IMPORTANT SAFETY
DO’S
• Read ALL the instructions before installing or using this Safe.
• Only use this Safe for its intended use as described in this manual.
• Ensure the Safe is installed where there is sufficient load bearing capacity.
• Always install the Safe in accordance with this guide. If in doubt obtain
expert advice.
DON’TS
• Do not use or store the Safe outdoors.
• Do not attempt to modify or make repairs to the Safe.
• Do not attempt to power this product by the introduction of a separate
power supply other that supplied.
BATTERY CAUTION
• Use of rechargeable batteries is not recommended for this product.
• Do not attempt to recharge non-rechargeable batteries.
• Only use batteries of the same or equivalent type to those recommended.
• Take special care to ensure the batteries are inserted correctly, observing
polarity.
• Avoid short circuiting the contacts of the battery housing or the battery
terminals.
• Remove exhausted batteries from product.
• Remove the battery from the product if storing for long periods.
• Remove the battery if the product is to be scrapped.
• Dispose of exhausted batteries safely and never dispose of batteries in a fire.
SAVE THESE INSTRUCTIONS
07
SECTION 03
OPERATING THE SAFE
It is recommended that both the primary code and master code are changed for
security reasons.
The reset button is located on the inside of the Safe door (see INITIAL SETUP). Pressing
this button will allow the codes to be changed and reset.
CHANGING THE CODES
Follow the processes below to change the primary code and master code values.
BACKUP POWER SUPPLY
If the batteries in the Safe run out, use the backup
power supply (supplied).
Simply plug it into the front of your Safe; this will allow
you to enter your code as normal.
Alternatively the override keys can be used to gain
entry into the Safe if the power for the batteries has
run out.
LED definitions
INPUT: Will flash each time a button is pressed
LOBATT: Indicates batteries are running out
OPEN: Indicates code has been accepted
Code definitions
Primary Code (Default - 1, 2, 3, 4, #
Master Code (Default - 1, 2, 3, 4, 5, 6, 7, 8, #
Changing the
primary code
Open safe with
override key
“Reset”
Button
4 digits of your
choice e.g. 1, 2, 3, 4
“#”
Button
Changing the
master code
Open safe with
override key or
primary code
Wait for “Open”
Light to go off
Press “0” button,
“0” button,
“Reset” button
8 digits of your
choice e.g.
1, 2, 3, 4, 5, 6, 7, 8
“#”
Button
