Coretronics TripTek 2510-X Manuale utente

Motor Coach Trip Computer

Operator’s Manual

MODEL 2510-X

Trademarks Coretronics is a registered trademark, and TripTek is a

trademark of Coretronics, Inc.

Coretronics, Inc.

1251 E. Iron Eagle Drive

Eagle, ID 83616

Telephone: (208) 938-6331

Fax: (208) 938-6334

www.triptek.net

Patented

Table of Contents

Quick Reference ……………………………………………….….……..…1

Overview ……………………………….….……………………….………..2

Description ……………………………….………………………..………..2

Display …………………………………….……………………….…….….2

Keypad Keys …………………………………………….……….………...3

Second Level …………………………………………………….……...….3

Clock Battery …………………………………………………….………...3

Operating the TripTek Computer …………………………….………….4

Check List Screen …………………………………………….……...........4

Today Screen ………………………………………………….……….......5

Leg Screen …………………………………………………….……...........6

Trip Screen …………………………………………………….…………..6

Coach Data Screen …………………………………………….….………7

Maintenance, Setup & Adjustment Screens ………………….………....8

Maintenance Screen ……………….………………………….………......8

Setup Menu Screen …………………………………………….…………9

Compass Zone Adjustment Screen …………………………….…..........9

Compass Calibration ………………………………….…………….......10

Maintenance Setup Screens ………………………….…………………11

Set Clock Screen …………………………………….………..……........11

Coach MPG ON/OFF Screen ……………………….…………………..12

Customer Service Screen …………………………….………………….12

Quick Reference

Series 2510

07/24/04

Oil Can:

If an oil can is displayed on any screen or “Engine Maintenance” is blinking on the CHECK LIST a

maintenance item needs attention. Refer to information on “MAINTENANCE” screen in this manual.

Maintenance/Setup/Information screens:

To get access to these screens press up and down keys simultaneously. (Ref this manual)

Maintenance Data:

Miles or hours have been preset at the factory to satisfy engine, transmission and generator break in

periods. Check MAINTENANCE SETUP screen to verify accurate breakin period.

After break in period reset mile and hour intervals to an appropriate setting to match your preferred

cycle.

If miles and/or hours are being set in mid cycle, set interval to accommodate remainder of cycle. After

maintenance cycle, change mile and/or hour intervals to full cycle period.

MPG Average:

To activate MPG Average on the COACH screen refer to the COACH MPG ON/OFF screen under

SETUP MENU. Reference Maintenance, Setup and Adjustment Screens section in manual.

Page 1

Operator’s Manual

Series 2510

06/01/04

Overview

TripTek is a trip and coach management computer designed for motorhomes. By receiving data from multiple

sources, i.e. electronic engine computer, compass and temperature sensors (optional), and other sources, the

system collects, analyzes, and saves data in memory and then displays information on the rear vision monitor.

Description

TripTek is comprised of multiple parts: a keypad, computer (behind dash), compass and temperature sensors

(optional), and utilization of the rear vision monitor for display.

Display

When the ignition is turned on, a pre-trip CHECK LIST is displayed to guide the operator through a list of

items to verify readiness of coach for travel.

To make efficient use of the data collected, and to best serve an actual vehicle trip, the system offers the

operator four separate travel screens: TODAY, LEG, TRIP, and COACH. Time, Day, Date and Year are also

included on these screens.

The TODAY screen is designed to give daily information. It provides miles to scheduled destination, time to

destination, miles traveled, time traveled, average MPG and average MPH. As an option, it will also give you

both inside and outside coach temperature and compass heading.

The LEG screen is designed to give information from fill to fill or for a trip. It provides average MPH, time

traveled, miles traveled, gallons used (by engine), average MPG, road speed, and cruise control status and

compass heading.

The TRIP screen is designed for long term data tracking for a complete trip or longer. It provides average

MPH, hours traveled, miles traveled, gallons used (by engine), average MPG and current MPG and compass

heading.

The COACH screen is designed to give you both coach and engine/transmission performance and operational

data. It provides gears select & monitor, turbo boost, engine temperature, transmission temperature, oil

pressure, average MPG and oil temperature and compass heading.

Note: If referenced information is not shown on one of these screens, that information is not offered or currently

being received from engine or transmission.

On a second level of screens there will be MAINTENANCE, SETUP MENU (COMPASS ZONE

ADJUSTMENT, COMPASS CALIBRATION, MAINTENANCE SETUP, SET CLOCK SCREEN, COACH

MPG ON/OFF), CUSTOMER SERVICE and VERSION INFORMATION.

The MAINTENANCE screen displays when to change engine oil, eng. fuel filter, transmission oil, generator oil

and gen. fuel filter. If Oil Can is displayed on travel screens a maintenance item needs attention. Line item will

be blinking.

The COMPASS ZONE ADJUSTMENT screen is used to maintain compass accuracy by state. To achieve

maximum accuracy, it is recommended to change the zone setting when traveling from state to state.

The COMPASS CALIBRATION screen is for calibration of the compass after its initial installation or anytime

the compass sensor is replaced or relocated.

The MAINTENANCE SETUP screen is to set the interval (miles for engine and hours for generator) for

maintenance.

Page 2

The SET CLOCK screen is to set all parameters of the clock, i.e. time zone, daylight savings, month, day,

year, time, am/pm and format (small, large or off).

The COACH MPG ON/OFF screen is to give the operator a way of turning MPG Average (COACH screen) on or

off.

The CUSTOMER SERVICE screen is to give the operator easy access to the phone numbers and web page

of the coach manufacturer.

Keypad Keys

(Maintain rear vision monitor in “on” position to display trip data)

Use the up ___ and down ___ keys to step through each line item of the CHECK LIST.

Use the VIEW key to move out of the CHECK LIST screen and go to the travel screens.

The VIEW key displays the four travel screens: TODAY, LEG, TRIP, and COACH. By pressing this key,

with the monitor on, the computer will sequence through the four data screens and one blank screen. The

system is also designed to sequence forward or backward, depending on which side of the key is pressed.

The SCREEN key will change data/picture contrast by changing the text background.

Successive presses to the VIEW or SCREEN keys will give the following options:

Data on picture: The ability to view a data screen and still see the rear vision image.

Data only: View data screen only with either a dark or light background for great contrast.

Picture only: View rear vision image only.

The RESET key will zero all or part of the data on the currently viewed screen.

The up ___ and down ___ keys set miles to be traveled today. Holding down a key will scroll through

numbers. This is operational only on the TODAY screen.

To get the second level SCREEN SELECTION screen, push the up___ and down ___ keys simultaneously.

SECOND LEVEL

Use the up ___ or down ___ key to change selection.

Use RESET key to select screen.

Use VIEW key to return to TODAY screen (or as noted).

Clock Battery

The TripTek computer utilizes a replaceable battery # CR1632 to retain its clocks memory when the system

is off.

Battery replacement:

1. Disconnect TripTek computer from coach. Most connectors utilize a latch to retain their position.

Compress latch arm to remove connectors.

2. With the removal of four screws from the two long sides of the computer lift off the back cover and

expose the inside of the system.

3. Locate battery on back surface of computer

4. Slide battery out from under metal spring clip.

5. Replace with positive side (+) of battery facing up.

6. Reverse steps 1 through 4 to reassemble system.

Page 3

Operating the TripTek Computer

Model 2510X

6/01/04

Turn the ignition switch ON.

Turn the rear vision monitor ON. Display rear vision picture.

Press the SCREEN key on the keypad to change contrast of displayed data to

the picture.

Note: If vehicle is put into reverse, the rear vision system will override the

computer and clear TripTek data from the screen until transmission is

taken out of reverse.

With the above steps completed, the “CHECK LIST” screen will be displayed

on the backup monitor.

There will be multiple screens displaying checklist items.

“CHECK LIST” will only come up when ignition is first turned on.

Press the VIEW key on the keypad. The “TODAY” screen will display on

the backup monitor.

Check List Screen

The CHECK LIST screen is designed to give you a list of items to verify readiness of coach for travel.

This screen will give you a list of items to check off to insure readiness of coach

for travel.

If a line item is blinking (i.e. “Engine Maint.”), it would imply that service is

required.

Page 4

Using the up ___ and down ___ keys will let you step down each line item and

check them off as you verify completion of task.

If a line item is blinking, press VIEW to move to the appropriate screen (i.e.

“MAINTENANCE”) to evaluate the problem.

Press VIEW key again to return to “CHECK LIST”.

Press VIEW key to move out of “CHECK LIST” and into “TODAY” screen.

Will function only on non-blinking lines.

The “CHECK LIST” is only visible when ignition is first turned on.

Today Screen

The TODAY screen is designed to give you daily information.

NW: Compass Heading (optional)

Oil Can: If Oil Can is displayed a maintenance item needs attention

(Ref. “MAINTENANCE” screen).

Time/Date: Time, Day, Date and Year. Line can be configured to large

text (default as pictured), small or off.

Out/In Temp: Outside and inside coach temperature (optional).

Miles To Go: Remainder of user entered miles to scheduled destination.

Time To Go: Approximate time to scheduled destination, utilizing “Miles To

Go” and current speed.

Mi Traveled: Miles traveled since “TODAY” screen reset.

Time Traveled: Time traveled since “TODAY” screen reset.

MPG Average: Average miles per gallon since “TODAY” screen reset.

MPH Average: Average miles per hour since “TODAY” screen reset.

Press RESET and follow screen instructions to zero out “TODAY” screen.

Using the up ___ and down ___ keys, set the miles you will travel today. The longer the

key is held down, the faster the number will scroll. Miles can be changed throughout the

day.

Press VIEW to return to “TODAY” screen.

Note: As “Miles Travld” changes, “Miles To Go” and “Time To Go” will also change

accordingly.

Press SCREEN to change data/picture contrast.

Press VIEW to move to the “LEG” screen.

Note: To move forward or backward through the screens, press the side of the

VIEW key that displays chosen direction.

Page 5

Leg Screen

The LEG screen is designed to give you information from fill to fill.

NW: Compass heading (optional)

Oil Can: If Oil Can is displayed a maintenance item needs

attention (Ref. “MAINTENANCE” screen)

MPH Average: Average miles per hour since “LEG” screen reset.

Time Traveled: Time traveled since “LEG” screen reset.

Mi Traveled: Miles traveled since “LEG” screen reset.

Gallons Used: Gallons of fuel utilized by engine from the time of

“LEG” screen reset. Data from engine computer.

MPG Average: Average miles per gallon since “LEG” screen reset.

Road Speed: Current coach speed.

Cruise OFF: Status of cruise control and its set speed. Displays

preset speed while cruise is off and actual speed

while cruise is on.

Press RESET and follow screen instructions to zero out “LEG” screen.

Press SCREEN to change data/picture contrast.

Press VIEW to move to the “TRIP” screen.

Trip Screen

The TRIP screen is designed for long term data tracking for a complete trip or longer.

NW: Compass heading (optional)

Oil Can: If Oil Can is displayed a maintenance item needs

attention (Ref. “MAINTENANCE” screen).

MPH Average: Average miles per hour since “TRIP” screen reset.

Hrs Traveled: Hours traveled since “TRIP” screen reset.

Mi Traveled: Miles traveled from time of “TRIP” screen reset.

Gallons Used: Gallons of fuel utilized by engine from time of

“TRIP” screen reset. Data from engine computer.

MPG Average: Average miles per gallon since “TRIP” screen reset.

MPG Current: Instantaneous miles per gallon.

Page 6

Press RESET and follow screen instructions to zero out “TRIP” screen.

Press SCREEN to change data/picture contrast.

Press VIEW to move to the “COACH” screen.

Coach Screen

The COACH screen is for coach and engine performance.

NW: Compass heading (optional)

Oil Can: If Oil Can is displayed a maintenance item needs

attention (Ref. “MAINTENANCE” screen)

Gear: Transmission gears selected and attained.

N=Neutral, C=Converter, L=Converter Lock

Turbo PSI: Turbocharger boost pressure.

Eng Temp: Engine coolant temperature.

Tran Temp: Transmission oil temperature.

Oil Pres: Engine Oil Pressure.

MPG Average: Average miles per gallon for life of coach.

Oil Temp: Engine oil temperature.

Note: If referenced information is not shown on your “COACH” screen, that

information is not offered from engine or transmission.

Note: MPG Average can be turned ON or OFF in the next level of screens, ref.

Maintenance, Setup and Adjustment Screens.

Press SCREEN to change data/picture contrast.

Press VIEW to move to the “BLANK” screen.

Page 7

Indice

Altri manuali Coretronics Accessori per automobili

Coretronics

Coretronics TripTek 2500 series Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente