8.Press until the highlight bar goes away. Press to highlight “PIR”. Press to enter
“SENSITIVITY”. Use or to choose the cameras sensitivity. Choose between “LOW,
NORMAL, HIGH, or OFF”, press “OK” to save.
a. Note: o!is used when taking time lapse photos if you do not want the camera to
automatically trigger on movement.
b. Note: NORMAL will work under most conditions. If you feel your camera is
triggering on objects other than animals, reduce the sensitivity to low. If you feel
the camera is not triggering when animals are present increase the sensitivity to
high. Sensitivity will likely have to be lowered in high temperatures.
9.Press to enter “INTERVAL”. Use or to choose how often the camera will trigger.
You can choose between “0 SEC and 60 MIN”, press “OK” to save.
a. Note: true interval between pictures will be determined by the interval selection
plus the time required to write images to the SD card. This is dependant upon
many factors such as the “write” speed of the SD card, size of the image being
stored and the number of images taken per trigger. For instance, if you choose an
interval of “0 SEC”, the actual interval between triggers may be 6-15 seconds.
10.Press to enter “TIME LAPSE”. Use or to turn the time lapse feature on/o!and
select an interval for the camera to automatically trigger even when there is not motion
present. This feature is perfect for scouting large areas where movement may be out of
range for the camera to sense. The included “Game-Trakker” software can be used to
make videos from these photos to watch several days worth of activity in just a few
minutes.
11.Press to Highlight “START-STOP”. This feature is used to program the camera to
function during a certain time of day and will control the camera in both standard
operation and Time-lapse mode. It is very useful when the Time-lapse feature is
activated. Use it to prevent the camera from taking pictures at night when most of the
activity will be beyond the reach of the IR Flash. Use or to turn the start-stop timer
on/o!and press “OK” to save. If you choose “ON”, the start-stop timer programing
screen will appear. Use or to select the start hour. Press to highlight the start
minutes. Repeat these steps to set the remainder of the timer parameters for both the
start and stop times. Once the start and stop times have been set, press OK to save.
12.Press until the highlight bar goes away. Press to highlight “SYS”. Press to
enter “Set Clock” and press “OK”. Use or to select the Month. Press to highlight
the Day. Repeat these steps to set the remainder of the date and time parameters and
press”OK” to save.
