INSTALLATION INSTRUCTIONS
A-11836 Cab with Doors Kit
05-11069
12/27/2012
15. Re-install doors and connect gas springs.
16. Open and close the doors. The striker stud can be adjusted for proper 2-stage rotary latch
engagement.
17. Layout hole location on each seat panel and drill a .375” diameter hole as shown in Figure 8.
Install locking compression plungers (Item 17) into seat panels as shown in Figure 9.
18. Raise and lower seats. When lowered, rubber part of plunger is to fit into 1” hole located in rear
mount panel. Fold lever to lock seat down, lift lever to tip seat up.
19. Additional foam seal and butyl tape is supplied with hardware kit and can be installed in various
areas as needed.
20. Make sure all installation hardware is fully tightened at this time. Reconnect battery.
21. Cab installation is now complete.
22. Proceed with replacing the vehicle’s standard front leaf springs with heavy duty front springs,
Toro P/N 99-0569 (Purchased separately from The Toro Company).
Optional kits are available for your Multi-Pro 5800 Sprayer Cab and are noted below;
A-11838 Wiper kit, radial coverage with park, switch, wiring and fuse
A-11839 Washer fluid tank with pump, wet arm, switch, wiring and fuse
A-11840 Interior mirror, full width 5 panel
A-11841 Air Conditioner kit, compressor, condenser, plenum, wire harnesses and controlsa
A-11845 Defroster fan kit with switch, wiring and fuse
99-0569 Heavy Duty Leaf Springs (Supplied by the Toro Company; (2) required per machine)
Sunshade and Front Window kits are also available for the Multi-Pro 5800 Sprayer;
A-11837 Sunshade roof and frame
A-11842 Front window for sunshade frame
For questions or comments, contact;
Figure 8 Figure 9
Plastic Bushing
Rubber Bushing
