Cressi-sub ELLIPSE Manuale utente

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 1

2nd stage ELLIPSE Black

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 2

2nd stage ELLIPSE Black

WARNING!

•This manual is intended for use by expert technicians who have already received

training in equipment repairs and maintenance from Cressi-sub.

•This manual is intended for use by expert technicians who have already received

training in equipment repairs and maintenance from Cressi-sub.

•Avoid performing maintenance and/or repair operations on the equipment without

the proper training required to conduct these operations.

•Users must never perform maintenance themselves; all maintenance must be

performed EXCLUSIVELY by an authorized Cressi-Sub center.

•If the information provided in this document is unclear or not fully intelligible,

please contact Cressi-sub before proceeding with any disassembly or maintenance

procedures.

•Before proceeding, Cressi-sub recommends that you read the following document

carefully to familiarize yourself with all the tools and techniques needed to

perform proper equipment maintenance and/or repair.

•Use this document as a guide during the various steps of maintaining and/or

repairing the equipment.

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 3

2nd stage ELLIPSE Black

•All operations must be done strictly in the order provided in this document. Failure

to do so could cause the equipment to function poorly, or worse, result in an

accident.

•To prevent any assembly errors when performing maintenance and/or repairs, we

recommend using all the replacement parts provided by Cressi-Sub in every

operation.

•Pay special attention to the recommendations provided in the margin of the figures

that show the various sequences of equipment maintenance and/or repair in order

to avoid any problems that could result in an accident.

•The document below in no way replaces the equipment's instruction manual.

•The procedures described in this document are pertinent to and intended only for

the disassembly, maintenance, and assembly of equipment meant for use with air

(21% oxygen, 79% nitrogen).

•The instructions provided in this document are based on information referring to the

most update equipment available. Cressi Sub reserves the right to make changes at

any time.

WARNING!

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 4

2nd stage ELLIPSE Black

ELLIPSE 2nd STAGES HZ 810067 ANNUAL REPLACEMENT KIT CHART (Real Size)

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 5

2nd stage ELLIPSE Black

•Maintenance kit 2nd stage Ellipse Black

HZ 810067

(Real Size)

•Use only original Cressi-sub spare parts

•Note: we recommend to carry out a complete maintenance of your

regulator once a year or more in case of a particularly intensive use.

Go back to

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 6

2nd stage ELLIPSE Black

•Yearly maintenance

•Cressi-Sub recommends complete regulator maintenance at least once a year,

or more frequently in the case of particularly intense use.

•Maintenance must include replacement of all components provided in the

annual equipment maintenance kit.

•The special tools for maintenance of this equipment are illustrated in a section

of this document on page 8.

•Metal parts must be washed with hot water and neutral detergent and rinsed

in fresh water. Any concretions must be removed using ultrasound cleaning or

with diluted acid solutions, always followed by long and thorough rinsing

under running water.

•Do not use acids or solvents on rubber components.

•The new ORs must be greased with a thin layer of silicon grease: this

procedure reduces to a minimum the risk of damage during assembly.

•The metal threading can be lubricated with grease on the first two rings of

threading.

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 7

2nd stage ELLIPSE Black

•Yearly maintenance

•Use only original Cressi-sub spare parts

•The procedures described in this document are pertinent to and

intended only for the disassembly, maintenance, and assembly of

equipment meant for use with air (21% oxygen, 79% nitrogen).

•Users must never perform maintenance themselves; all

maintenance must be performed EXCLUSIVELY by an authorized

Cressi-Sub center.

•You can find your authorized Cressi-Sub center by asking your

dealer, or Cressi Sub S.p.A. itself by sending an e-mail to:

[email protected]

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 8

2nd stage ELLIPSE Black

Special tools

Regulators repair and maintenance 2nd stage ELLIPSE Black

January 2008 Rev. ELL. OCTO /A Ed. B / 09 9

•Remove and replace all O-rings;

•Use a plastic tool or a round pointed metal one in order not to damage the

O-ring seat;

•To replace the O-ring correctly, press its sides to create a bulge inside which

to insert the round pointed tool, as shown in the pictures;

•Attention: USE ONLY ORIGINAL CRESSI-SUB SPARE PARTS

Regulators repair and maintenance

January 2008 Rev. ELL. OCTO /A Ed. B / 09 10

2nd stage ELLIPSE Black

•Using a 19 mm

(0,75 in.) and a 17

mm (0,67 in.)

spanner, remove the

low-pressure hose,

holding the set nut

with the former and

unscrewing the

shaft with the latter.

•The OR inside the

hose must be

replaced yearly.

•Disassembling the low-pressure hose

Altri manuali Cressi-sub Controllori

Cressi-sub

Cressi-sub MC5 Manuale

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente