CReTE Systems RT9 Manuale utente

NOTEBOOK COMPUTER

RT9

User’s Guide

Notice

The company reserves the right to revise this publication or to change its

contents without any notice. Information contained herein is for reference only

and does not constitute a commitment on the part of the manufacturer or any

subsequent vendor. They assume no responsibility or liability for any errors or

inaccuracies that may appear in this publication nor are they in anyway

responsible for any loss or damage resulting from the use (or misuse) of this

publication.

Any of the software described in this manual is sold or licensed "as is". Should

the programs prove defective following purchase, the buyer (and not the

manufacturer, its distributor, or its dealer) assumes the entire cost of all

necessary servicing, repair and any incidental or consequential damages

resulting from any software defects.

Brand and product names mentioned in this publication may or may not be

copyrights and/or registered trademarks of their respective companies. They

are mentioned for identification purposes only and are not intended as an

endorsement of that product or its manufacturer.

Trademarks

All other brand and product names are trademarks or registered trademarks of

their respective companies.

FCC (Federal Communications Commission) Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device pursuant part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses, and radiates radio frequency energy. If not

being installed and used in accordance with the instructions, it may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference

that may cause undesired operation.

FCC Caution:

To assure continued compliance, any changes or modifications not

expressly approved by the party responsible for compliance could void

the user's authority to operate this equipment. (Example - use only

shielded interface cables when connecting to computer or peripheral

devices).

III

Regulatory Information/ Disclaimers

Installation and use of this computer must be in strict accordance with the

instructions included in the user documentation provided with the product. Any

changes or modifications (including the antennas) made to this device that are

not expressly approved by the manufacturer may void the user’s authority to

operate the equipment.

The manufacturer is not responsible for any radio or television interference

caused by unauthorized modification of this device, or the substitution of the

connecting cables and equipment other than manufacturer specified. It is the

responsibility of the user to correct any interference caused by such

unauthorized modification, substitution or attachment. Manufacturer and its

authorized resellers or distributors will assume no liability for any damage or

violation of government regulations arising from failing to comply with these

guidelines.

Products with the CE Marking comply with both the EMC Directive

(89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the

Commission of the European Community.

Compliance with these directives implies conformity to the following European

Norms:

EN55022 (CISPR 22) Radio Frequency Interference

EN55024 (EN61000-4-2, EN61000-4-3, EN61000-4-4,

EN61000-4-5, EN61000-4-6, EN61000-4-8,

EN61000-4-11, EN61000-3-2, EN61000-3-3)

Generic Immunity Standard

LVD EN 60950 Product Safety, IEC 60950-1: 2005

R&TTE (CE) Manual Regulatory Requirement

WLAN - IEEE 802.11a/b/g/n

802.11a/b/g/n Restrictions:

European standards dictate maximum radiated transmit power of 100mW

EIRP and frequency range 2.400-2.4835 GHz. In France, the equipment must

be restricted to the 2.4465-2.4835 GHz frequency range and must be

restricted to indoor use.

CE Declaration of Conformity

It is confirmed to comply with the requirements set out in the Council Directive

on the approximation of the laws of the member states relating to

Electromagnetic Compatibility (89/336/EEC), Low-voltage Directive

(73/23/EEC), the Amendment Directive (93/68/EEC), and the procedures

given in European Council Directive (99/5/EC and 89/3360EEC).

The equipment was passed, and the equipment test was performed according

to the following European standards:

EN 300 328 V1.7.1: 2006

EN 301 893 V1.4.1 (2007-07)

EN 301 V1.8.1 2008-04 / EN 301 489-17 V1.3.2 2008-04

EN 50371:2002

EN 60950-1: 2005

UL, TÜ V

AC Adapter (TÜ V includes EN60950 LVD)

Power Conservation

This computer consumes much less power than conventional computers.

However, power consumption may be reduced by configuring the Power

Management Setup properly.

It is recommended the power saving functions to be enabled even when not

running on battery power.

Power Management will not degrade performance while saving power.

Power Safety

There are specific power requirements for this computer:

Only use an approved power adapter for this computer.

There is a 3-prong grounded plug of the power adapter. The third prong is

an important for safety. Do not neglect the importance for it. If you are not

able to access a compatible outlet, installing one by a qualified electrician

is necessary.

When unplugging the power cord, please be sure to disconnect it from the

plug head but from its wire.

Make sure the socket and any other extension cord you use can support

the total current load of all the connected devices.

Before cleaning the computer, make sure it is disconnected from any

external power supplies.

Warning:

Before any upgrade procedures, make sure the power is turned off, and all

the cables are disconnected (including telephone lines). Also, it is

advisable to re-move your battery in prevent from turning the computer on

accidentally.

VII

Battery Precautions

Only use the batteries designed for this computer. The wrong battery may

cause explosion, leakage or damage to the computer.

Do not remove the battery from the computer while it is powered on.

Do not continuously use a battery that has been dropped, or that appears

damaged (e.g. bent or twisted) in any way. Even if the computer is able to

continuously work with a damaged battery, the circuit damage may occur

and possibly cause fire.

Always use the notebook’s system or charger to recharge the battery.

Incorrect recharging may make the battery explode.

Do not try to repair a battery pack by yourself. Refer to any battery pack

repair or replacement, please contact with to your service representative

or qualified service personnel.

Please dispose of a damaged battery promptly and carefully. Explosion or

leakage may occur, if the battery is exposed to fire, improperly handled or

discarded.

Battery Disposal & Caution:

The product that you have purchased contains a rechargeable battery.

The battery is recyclable. At the end of its service life, under various state

and local laws, it may be illegal to dispose of this battery into the

municipal waste stream. Check with your local solid waste officials for

details in your area for recycling options or proper disposal. Danger of

explosion may possibly occur, if the battery is incorrectly replaced.

Replace only with the same or the equivalent battery recommended by

the manufacturer. Discard the used battery according to the

manufacturer’s instructions.

VIII

Environmental Information, Material Safety & Recycling

All materials used in the manufacturing of this equipment are recyclable or

environmentally friendly.

Please recycle the packing materials by the local regulations at the end of the

product's service life.

Notice:

The equipment may still contain tiny amount of hazardous substances for

health and environment, though those are below control level.

To avoid spreading such substances into the eco system, and to minimize

the pressure on the natural, you are encouraged to use the appropriate

take-back for reusing or recycling most of the materials in a safe way after

the service life.

The crossed bin symbol indicates proper disposal is required.

For more information on collection, reuse and recycling, please consult

the local or regional waste administration for more information.

You can also contact with the dealer for more information on the

environmental details of the equipment.

The symbol of the crossed out wheeled bin indicates that the

product (electrical and electronic equipment) should not be

placed in municipal waste. Please check local regulations for

disposal of electronic products.

TABLE OF CONTENTS

CHAPTER ONE - GETTING STARTED........................................1

UNPACKING ..............................................................................................1

QUICK OPERATION ....................................................................................2

APPEARANCE OVERVIEW ...........................................................................3

CHAPTER TWO - OPERATING INFORMATION .........................8

WORKPLACE.............................................................................................8

RUGGEDNESS ...........................................................................................8

OPERATING SYSTEM..................................................................................9

WORK WITH POWER BUTTON .....................................................................9

BOOT UP AND POST.................................................................................9

SHUT DOWN............................................................................................10

SLEEP/HIBERNATE..................................................................................10

KEYBOARD..............................................................................................11

KEYBOARD BACKLIGHT (OPTIONAL)..........................................................11

HARD DISK DRIVE (HDD) ........................................................................12

ODD (OPTICAL DISK DEVICE) ..................................................................12

EXPRESS AND PC CARDS ........................................................................13

RTC ......................................................................................................13

REPLACING MODULES..............................................................................14

WIRELESS DEVICES (OPTIONAL)...............................................................15

DOCKUNDER DUT89 (OPTIONAL) ............................................................22

CHAPTER THREE - MANAGING POWER.................................25

AC ADAPTER ..........................................................................................25

BATTERY ................................................................................................26

POWER CONSERVATION...........................................................................29

SUPPORTING ACPI .................................................................................29

CHAPTER FOUR - BIOS SETUP...............................................30

MAIN MENU ............................................................................................30

SATA PORT 1SUB-MENU .......................................................................32

SATA PORT 2SUB-MENU .......................................................................33

ADVANCED MENU....................................................................................34

ADVANCED MENU SELECTIONS.................................................................35

BIOS SETTINGS FOR WINDOWS XP INSTALLATION ....................................36

SIO SMC27 CONFIGURATION SUB-MENU...........................................36

SECURITY MENU .....................................................................................38

RF INTERFACE CONTROL SUB-MENU........................................................40

BOOT MENU............................................................................................41

Indice

Altri manuali CReTE Systems Computer portatile

CReTE Systems

CReTE Systems RF9 Manuale utente

CReTE Systems

CReTE Systems RF886EX Manuale utente

CReTE Systems

CReTE Systems RK9 Manuale utente

CReTE Systems

CReTE Systems RT886EX Manuale utente

Manuali Computer portatile popolari di altre marche

HP ze2401xt - Pavilion Notebook PC Manuale utente

Velocity

Velocity NoteMagix M10 Manuale utente

Dell

Dell Alienware 17 R2 Manuale utente

Toshiba

Toshiba A105-S2236 Manuale utente

HP ENVY 17 Manuale

Winbook

Winbook LM Manuale utente

Dell

Dell Inspiron 1464 Manuale utente

Dell

Dell Inspiron 15R 5537 Manuale utente

HP PROBOOK 4520S Manuale

Dell

Dell Latitude ATG D620 Manuale utente

Sony

Sony VAIO PCG-FX270 Manuale utente

Dell

Dell Latitude 7310 Manuale utente

Dell

Dell Precision GU806 Manuale utente

Sony

Sony VAIO PCG-R505JLK Manuale utente

Lenovo

Lenovo THINKPAD X32 Manuale utente

HP Compaq tc4200 Guida rapida

Toshiba

Toshiba mini NB300 Manuale utente

Lenovo

Lenovo ThinkPad X201 Tablet Manuale