Page 5of 8
The supply pressure must be regulated according to the pressures indicated on the rating plate. The
regulators that are supplied with all Crown Verity gas units are compatible with RG-SB-1 & RG-SB-2 side
burners and could be used to regulate gas for the side burners. A ''Tee'' can be installed downstream of
the regulator and copper tubing can then be used to connect the side burner.
It is very important that the side burner be connected to the correct type of gas and is regulated at the
correct pressure. The rating plate on all RG-SB-1 & RG-SB-2 units contains this and other important
information and must be observed.
Finally, before operating the side burner, perform a leak check by brushing on a soap and water solution
at every joint and watch for growing bubbles that indicate a leak. Once you are confident there are no
leaks, you may operate your new Crown Verity side burner.
START-UP
Electronically Lighting the Side Burner if equipped with spark ignition
1. Remove protective lid from unit
2. Stay clear of the side burner and do not bend over it directly when lighting
3. Ensure that all valve handles on the side -burner are in the OFF position (clockwise) before proceeding
4. Turn on the gas supply valve. WAIT 15 SECONDS.
5. Push and turn burner knob to on position (counter clockwise 90 °). Once on, immediately push and
hold the ignition button located below the burner knob until the ring burner is lit (you will hear the
arcing sound of the electrode and the ring burner should ignite). If ignition fails to light the burner after
four (4) seconds stop and turn off valve.
NOTE: depending on the length of fuel line used to connect the Side Burner, sometimes air must be
removed from the line before the unit will ignite. (Turn one burner valve on for 10 seconds then close
and wait for 5 minutes for gas to clear before proceeding back to step #3)
6. Visually check to ensure the ring burner is burning. If the Ring burner does not light on the first try,
repeat immediately.
7. If the ring burner does not light after three attempts, turn the burner knob to the OFF position. Wait
five minutes until the gas clears before proceeding to step #3.
8. If the ring burner does not light, please try the manual lighting procedure below.
9. Upon successful lighting of the ring burner, the burner can now be adjusted as desired.
Repeat this procedure if your side burner is equipped with two burners.
