1. SAFETY
Lithium Iron Phosphate (LiFePO4 or LFP) batteries are safe to use
indoors and outdoors. However, as with any battery, safety measures
must always be taken. Please follow the instructions within this user
manual for the safe handling and operation of CS-BATTERIES
batteries.
IMPORTANT SAFETY WARNINGS
•Always wear protective gear when handling batteries.
•Never attempt to open or disassemble a battery. If accidental contact
with internal battery contents occurs, wash the affected skin area
and contact a doctor for further medical assistance.
•Do not expose the battery to water or saltwater, or allow the battery
to get wet.
•Keep sparks, flames, heat sources (> 50°C/122°F), and metal
objects away from batteries.
•Make sure all cable connections are properly tightened.
•Battery cables should have some slack and not be tightly stretched.
•Install and remove batteries using the tools provided.
•The battery MUST be securely mounted into the vehicle.
•If the battery emits a peculiar smell, heating, distortion, or appears to
have any abnormality during operation or storage, please remove the
battery and move it to a safe location. Contact CS-BATTERIES for
further details.
•If the battery leaks and any chemicals get into the eyes or on the
skin, do not rub or wipe. Rinse with dean water and seek medical
attention immediately.
2. PRODUCT INTRODUCTION
2.1 Overview
Our groundbreaking Lithium Motorcycle Battery is the world's FIRST
RE-START motorcycle battery, it incorporates CS-Batteries patent
Battery Management System & Control technology to provide every
motorcycle enthusiast a unique experience, the Battery Management
System (BMS) automatically shuts off the battery to prevent permanent
damage from over-charge, over-discharge, short circuit, etc.
2.3 RE-START Function
CS-BATTERIES RE-START battery is a high-power, lightweight
Lithium-Ion power-sports battery built with our groundbreaking patented
RE-START technology, so you will never be troubled with a dead
battery anymore! The revolutionary RE-START battery with Battery
Management System, can intelligently monitor battery status, the
battery will enter into sleep mode before going completely dead so it
can have enough energy to RESTART your vehicle again. No matter
what model or what brand of motorcycles, it is very easy to RE-START.
You only need to SHAKE the motorcycle 3 times or more, then you
can successfully RESTART and ride off. You don't need to take out the
battery from the motorcycle or press any buttons.
3. INSTALLATION
Before Installation, please make sure the location of the CS-BATTE-
RIES Battery is free from potential short-circuiting of the cables,
terminals, and other electrical connections. Be aware of other potential
dangerous situations including moving parts or extremely hot parts
such as exhaust pipes.
3.1 Installation Tool: Use the tools provided.
3.2 Installation Guide
3.2.1 Replacing an old battery – Before disconnecting the battery cable,
please mark the cable connected to the (+) terminal of the old battery.
Always remove the negative (-) cable connector before removing the
positive (+) cable for safety reasons. Clean the cable connectors to
remove any corrosion or grease. If a voltmeter or multi-meter is
available, double-check the battery polarity to make certain the old
battery's (+) terminal is actually the (+) charge side.
3.2.2 LiFePO4 battery is 2-3 times higher in energy density than
lead-acid batteries,therefore, our battery will be smaller than the
lead-acid battery. You can use the foam shims to fill up any extra space
in your battery tray/box if needed. Trim the foam shims with scissors or
a knife for a firm fit to ensure a secure installation.
2.2 Spec
Model
HDX-14
HDX-20
HDX-30
HDX-40
Voltage
12.8V
12.8V
12.8V
12.8V
Energy
64Wh
76.8Wh
102.4Wh
153.6Wh
Cranking
amps
400A
600A
800A
1000A
Dimensions
L/W/H
113/70/83mm
149/65/92mm
135/75/139mm
175/87/142.5mm
Weight
0.75kg
0.95kg
1.35kg
1.94kg
Lead-acid
equivalent
PbEq 5-14Ah
PbEq 14-20Ah
PbEq 20-30Ah
PbEq 26-40Ah
L
W
H
Foam … Add as required
