5
6
7
Water Tank Cover
Water Tank
Filter Holder
Jug
Warming Plate
ON/OFF Switch
Filter
1
2
3
4
Amount of Water
1 serving (125ml) 1 level tablespoon (15ml) 2 tablespoons
12 level tablespoons6 level tablespoons 6 servings (750ml)
Amount of
Ground Coee
Regular Brew
Amount of
Ground Coee
Strong Brew
Type of Water Cleaning Frequency
Soft Water Every 80 Brewing Cycles
Hard Water Every 40 Brewing Cycles
Question
Why doesn’t the ON/OFF
switch light up?
Why doesn’t the coffee
brew?
Why does the coffee
maker only brew water?
Why does the coffee
taste badly?
Why do grounds appear
in the coffee?
Answer
Check that you have plugged your coffee maker into
the mains socket.
Check that you have plugged the unit into the mains
socket. The lter holder is not properly inserted, or
there is a power outage, or the water tank is empty.
There is no coffee in the lter, check that you have
added the desired amount of coffee.
Maybe you did not use the coffee grind recommended
for automatic drip coffee makers. The ground
coffee-to-water ratio was unbalanced. The coffee maker
needs to be cleaned.
The lter is not properly seated in the lter holder or
the lter has collapsed.
GB-1 GB-2 GB-3
J U G U S E A N D C A R E
PRODUCT OVERVIEW
GROUND COFFEE USAGE
Amount of Water
1 serving (125ml) 1 rounded teaspoon 2 rounded teaspoons
12 rounded teaspoons6 rounded teaspoons 6 servings (750ml)
Amount of
Instant Coee
Regular Brew
Amount of
Instant Coee
Strong Brew
INSTANT COFFEE USAGE
FIRST TIME USE
1. Wash the jug, the lid, the lter holder and the lter in mild detergent and hot water.
Rinse them thoroughly.
2. Fit the lter into the lter holder and close the lter holder.
3. To clean the inside of the coffee maker, ll the water tank of your coffee maker with
water, and follow Steps 3 to 6 in the OPERATION section.
4. Once the initial cleaning cycle is complete, switch off the coffee maker and discard
the water in the jug.
5. Your coffee maker is now ready to use.
UNPACKING
Remove all packaging from the unit. Retain the packaging. If you dispose of it
please do so according to any recycling regulations.
The following items are included:
• The Main Unit
• Jug (P.N.: C12FCB11, 38-47)
• Filter (P.N.: C12FCB11, 35-36)
• Instruction Manual (P.N.: C12FCB11-001)
If items are missing or damaged, please contact Partmaster (UK only)
Tel. 0844 800 3456 for assistance.
CLEANING INSTRUCTIONS
Your coffee maker must be cleaned when you notice any excessive steaming or the
brewing time increases considerably. This condition is caused by a build-up of lime
and mineral deposits from your water. If the pumping action stops before all the
water has been pumped out of the coffee maker, then it requires cleaning. The
frequency of cleaning depends on the hardness of the water used. The following
table gives suggested cleaning intervals.
Hard water can leave a whitish mineral deposit inside the jug. Coffee can discolour
these deposits, sometimes leaving a brownish stain inside the jug. To remove these
stains, follow these simple steps:
1. Use a solution of equal parts white vinegar and hot water.
2. Let solution stand in jug for about 20 minutes and then discard.
3. Wash and rinse the jug thoroughly using a soft cloth. Do not use harsh abrasive
cleaners.
OPERATION
1. Open the lter holder.
2. Add the desired amount of coffee into the lter (follow the measurement tables
shown above). Shake lightly to level the coffee. Close the lter holder.
3. Fill the jug with tap water to the desired capacity.
4. Pour the water from the jug into the water tank. Place the empty jug onto the
warming plate.
5. Switch your coffee maker on with the ON/OFF switch.
6. When the coffee stops dripping, the brewing cycle is complete (this usually takes
about 10 minutes for a 12 cup load). Your coffee is ready to drink, and will be kept
warm on the heated warming plate.
7. Carefully open the lter holder and discard the used ground coffee from the lter.
Rinse the lter holder and lter after use and then ret them.
8. To make another pot of coffee, repeat the above Steps 1 to 7.
To reduce the risk of re or electrical shock, do not remove any service
covers. There are no user serviceable parts inside. Repairs should be
done by qualied personnel only.
• Switch off your coffee maker when the jug is empty or when you are not
using it. Unplug the mains cable when not using the coffee maker for a
long period of time.
• To avoid the risk of personal injury or damage to property as a result of
overow, be sure that the jug is squarely centred under the lter holder
during the brewing cycle.
• The brewed coffee in the jug and the grounds in the lter are very hot.
Handle them with care to avoid scalding.
• If the coffee fails to drain into the jug during the brewing cycle causing
overows, do not open or touch the lter holder. Unplug the coffee
maker, and wait for it to cool down before handling.
HINTS AND TIPS
The jug may break if the following instructions are not followed:
1. Do not set a hot jug on a wet or cold surface.
2. Do not use a cracked jug or a jug with a loose or weakened handle.
3. Do not clean the jug with cleaners, steel wool pads or other abrasive materials.
4. Discard the jug immediately if it has boiled dry.
5. Avoid sharp blows, scratches or rough handling.
Pour one litre of undiluted white household vinegar into your coffee maker ‘s water
tank.
1. Place the empty jug on the warming plate and switch on the coffee maker. When
half of the vinegar has owed through, switch off the coffee maker and allow it
stands for 1/2 hour.
2. After 1/2 hour, pour the vinegar inside the jug back into the coffee maker water
tank.
3. Place the empty jug on the warming plate. Switch on the coffee maker again and
allow the coffee maker to complete its brewing cycle with all of the vinegar owing
through into the jug.
4. Discard the vinegar.
5. To remove all traces of vinegar, pour a jug full of tap water into the water tank of
the coffee maker, then switch on the coffee maker again and allow it to cycle
through.
6. Discard the water and switch off the coffee maker.
6
5
4
3
2
1
7
Jug and lter are dishwasher safe.
