Curtis IP1500UK Manuale utente

iPOD RADIO CD MICRO SYSTEM

MODEL NO. iP1500UK

OWNER'S MANUAL

PLEASE READ BEFORE OPERATING THIS EQUIPMENT

WARNING AND PRECAUTIONS

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS

UNIT TO RAIN OR MOISTURE.

This symbol, located on back or bottom of the unit, is intended to alert the

user to the presence of uninsulated “dangerous voltage” within the product’s

enclosure that may be of sufﬁcient magnitude to constitute a risk of electric

shock to persons.

This symbol, located on back or bottom of the unit, is intended to alert the

DANGER:

Invisible and hazardous laser radiation when open and interlock failed or

defeated. Avoid direct exposure to beam.

user to the presence of important operating and maintenance (servicing)

instructions in the literature accompanying the appliance.

Any use of the controls or an adjustment to the procedures other than those

speciﬁed herein may result in hazardous radiation.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

To reduce the risk of electric shock, do not remove cover (or back). There are

no user-serviceable parts inside. Please refer any servicing to qualiﬁed service

personnel.

WARNING: Changes or modiﬁcations to this unit not expressly approved by

the party responsible for compliance could void the user’s authority to operate

the equipment.

Power Sources

This portable audio system is designed to operate on

either 230V AC, 50Hz house current.

AC Operation

Unwind the AC cord and extend it to its full length. Insert the small end of the AC cord into the AC

socket on the rear of the unit. Insert the other end of the AC cord into any convenient 230V AC,

50Hz household outlet.

PREPARATION FOR USE

Connecting the Speakers

Place the speakers on either side of the main unit.

Connect the speaker on the left side of the main unit to the "L" speaker jack on the

back panel.

Connect the speaker on the right side of the main unit to the "R" speaker jack on

the back panel.

Right Side Speaker Left Side Speaker

Speaker wire with white strip will connect to "Red" speaker jack and speaker wire without

the white strip will insert to "Black" speaker jack

Make sure the speaker wires are fully inserted and locked into the speaker jacks on the

back panel of the main unit.

LOCATION OF CONTROLS

POWER BUTTON

MEM/CLK ADJ BUTTON

REPEAT/M-DN BUTTON

TIMER BUTTON

SLEEP BUTTON

FUNCTION BUTTON

IPOD BUTTON

SKIP/TUNE DN BUTTON

10.

11.

12.

13.

14.

15.

16.

PRESET EQ BUTTON

SKIP/TUNE UP BUTTON

VOLUME DN BUTTON

VOLUME UP BUTTON

STOP/BAND BUTTON

OPEN/CLOSE BUTTON

HEADPHONE JACK

PLAY/PAUSE MEM-UP BUTTON

1 2 3 4 5 6 7

8 9 10 11 12 13 14 15 16

LOCATION OF REMOTE CONTROLS

POWER BUTTON

FUNCTION BUTTON

DISPLAY BUTTONS

FM ST BUTTON

SKIP/TUNE DN BUTTON

SLEEP BUTTON

SKIP/TUNE UP BUTTON

TIMER BUTTON

MEM/CLK SET BUTTON

10.

11.

12.

13.

14.

15.

16.

17.

18.

STOP/BAND BUTTON

REPEAT/MEM DN BUTTON

PLAY/PAUSE/MEM UP BUTTON

VOLUME DN BUTTON

MUTE BUTTON

EQ BUTTON

VOLUME UP BUTTON

IPOD BUTTON

OPEN/CLOSE BUTTON

POWER EJECT

FM ST

MUTE

CLK SET MEM DN

TUNE/SKIP BAND MEM-UP

VOL

iPOD

REPEAT

7 8 9 10

POWER SOURCES

BATTERIES

NOTE:

The button cell battery contains mercury, don't put in the trash. Recycle or

dispose as hazardous waste.

NOTE:

You may need to remove a protective covering from the remote's battery

compartment before using the remote control.

(FOR REMOTE CONTROL)

OPERATING INSTRUCTIONS

Setting up your radio

Checking AM Radio reception

Your clock radio has a built-in antenna for AM radio. To improve

reception, you need to rotate your unit.

Unpacking And Set Up

•

Placement of the System

The system should be placed on a stable, level surface such as a

table, desk, or shelf, convenient to an AC outlet, away from direct

sunlight, and sources of excess heat, dust, moisture, humidity,

vibration, or strong magnetic fields.

The speakers may be placed next to the main unit or as far apart as

the speaker wires allow. We recommend that you leave a gap of

approximately 1/2 inch between the main unit and the speakers so

that any vibration from the speakers will not interfere with the CD

player in the main unit.

Remove the main unit, the speakers, and the remote control unit

from the display carton. Remove all packing materials from the

components.

Unwind the AC power cord and extend it to its full length.

Unwind the external FM wire antenna and extend it to its full length.

Remove the twist-ties from the speaker wires.

OPERATING INSTRUCTIONS

1. Plug the AC Power cord into a power outlet.

2. Press the POWER button on the main unit or remote control to turn the

system "On".

3. If necessary, press the FUNCTION button to select the Radio mode and

the display shows: FM 87.5 MHz.

4. To switch between FM and AM bands press the STOP/BAND button on

the front panel or remote.

5. Automatic Tuning - Depress and hold the TUNING / SKIP UP or DN buttons

until the display begins to move, then release the buttons. The tuner will

scan up or down the band until it finds the first strong station, and then

stop on that station. Repeat this process until the tuner stops on your

desired station.

6. If you tune to an FM Stereo station the "(ST)" indicator appears in the

display.

7. Manual Tuning - Press theTUNING / SKIP UP or DN buttons repeatedly

until the display is showing the frequency of your desired station. Use the

manual tuning method to tune to weaker stations that are bypassed during

Automatic Tuning.

Setting the time

To set the time on your radio:

1. With the power off.

2. Press and hold the MEM/CLK ADJ Button; "12Hr" will blink.

3. Press the SKIP/TUNING Button to set the unit to the 24 hour (24Hr) mode

or 12 hour (12Hr) mode.

4. Press the MEM/CLK ADJ Button and the hours will blink.

5. Press the SKIP/TUNING Button to set the current hour, then press the

MEM/CLK ADJ again; the minute digits will blink. Press the SKIP/TUNING

to set the current minutes.

6. Press the MEM/CLK ADJ Button to confirm the time.

Using your radio

OPERATING INSTRUCTIONS

Programming radio station presets:

You can program as many as 10 FM and 10 AM radio station presets. After you

program a station, you can tune to the station by pressing one of the SKIP/TUNE

Buttons.

To program a radio station:

1. Press the POWER Button to turn on your radio.

2. Press the FUNCTION Button one or more times until TUNER appears

on the display.

3. Press the BAND Button to select AM or FM.

4. Press and hold one of the SKIP/TUNE Buttons to select a radio station.

5. Press and hold the MEM/CLK ARJ Button to activate the programming

mode.

6. Press one of the SKIP/TUNING Buttons to select the preset number you

want to assign the station to.

7. Press and hold the MEM/CLK ARJ Button to store the station with the

preset number you selected.

8. Repeat Steps 4 through 7 to program additional presets.

OPERATING INSTRUCTIONS

To tune to a radio station preset:

1. Press the POWER Button to turn on your radio.

2. Press the FUNCTION button one or more times until TUNER appears on

the display.

3. Press the STOP/BAND Button to select AM or FM.

4. Press the MEM DN or MEM UP Button one or more times until the preset

number you want appears on the display.

To select an equalizer mode:

Press the EQ Button one or more times to select the mode you want

You can select:

* Classic

* Jazz

* Rock

* Pop

Listening to a CD

Your radio can play audio CDs, CD-Rs and CD-RWs. CD-Rs and CD-RWs

must be finalized before you can play them on your unit.

To listening to a CD:

1. Press the POWER Button to turn on your radio.

2. Press the FUNCTION Button one or more times until CD track "--" appears

on the display.

3. Press the OPEN/CLOSE Button to open the CD tray.

4. Place a CD with the label side up into the CD tray.

5. Press the OPEN/CLOSE Button to close the CD tray.

6. Press the PLAY/PAUSE Button to start playback.

7. To control the CD during playback:

* Press the PLAY/PAUSE Button to pause playback. Press the button

again to resume playback.

* Press one of the SKIP/TUNING Buttons to go to the next or previous

track on the CD.

* Press and hold one of the SKIP/TUNING Buttons to search for a track

on the CD.

8. Press the STOP Button to stop playback.

Indice

Altri manuali Curtis Impianto stereo

Manuali Impianto stereo popolari di altre marche

LG CM3330B Manuale utente

Sony

Sony SS-CEP50 Manuale utente

Cetacea Sound

Cetacea Sound CVS-II Manuale utente

Aiwa

Aiwa XR-H66MD Manuale utente

Denon

Denon UCD-250 Manuale utente

Sanyo

Sanyo DC-MX41i Manuale utente

Sharp

Sharp CD-ES600V Manuale utente

Exibel

Exibel BDX600-UK Manuale utente

Sanyo

Sanyo DC-F320 Manuale utente

Philips

Philips FWM583X Manuale utente

Sharp

Sharp CD-C462 Manuale utente

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio Manuale utente

Aiwa

Aiwa XR-EM70 Manuale utente

Cyrus

Cyrus Lyric Manuale utente

Philips

Philips MCM159/98 Manuale utente

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C Manuale utente

RCA

RCA RS3965SB Manuale utente

Sharp

Sharp XL-UH240 Manuale utente

Curtis iP1500UK Manuale utente

Manuali Impianto stereo popolari di altre marche