Method 2: Using a Command Prompt
NOTE: These instructions are for Windows OS. For other OS please refer
to RMCARD User’s Manual available for download at CyberPower
Systems ocal website: www.CyberPower.com.
1. Obtain the MAC address from the label on the Remote
Management Card. Each Management Card has a unique MAC
address.
2. Use the ARP command to set the IP address.
Example:
To assign the IP Address 192.168.10.134 for the Remote
Management Card, which has a MAC address of
00-0C-15-00-FF-99 you will type in the following in the
command prompt from a PC connected to the same network
as the Remote Management Card.
(1) Type in “arp -s192.168.10.134 00-0C-15-00-FF-99”then
press Enter.
3. Use the Ping command to assign a size of 123 bytes to the IP.
(1) Type in “ping 192.168.10.134 -l 123”then press Enter.
(2) If the replies are received, your computer can
communicate with the IP address.
7. You will need to enter a User
Name and Password for the
Remote Management Card in
the authentication window, as
shown in Figure 3.
- Default user name: cyber
- Default password: cyber
8. If the IP address change is
successful, you will see a
message confirming the IP set
up, as shown in Figure 4.
Figure 3. Authentication window
Figure 4. Setup IP Address successfully message
5
