Da-Lite DESIGNER MANUAL SCREEN Manuale utente

76488 Rev. 7/02Printed in U.S.A.

MAINTENANCE

PROJECTION SCREEN MAINTENANCE

Protect your screen by keeping it rolled in its

case when not in use. Always examine both

front and back of surface before rerolling into

case to make certain screen is free of dust, dirt

or other foreign matter. Use a very soft duster

brush to gently remove foreign particles.

CASE MAINTENANCE

The case of the screen has a Resistovar finish.

This finish is resistant against: water, alcohol,

marring, scratching, and nail polish remover. To

help maintain the best appearance of the case

it is recommended that the case be polished

with any reputable liquid or paste wax polish.

An oil type polish is not recommended because

it allows for the collection of dust and finger

prints. When necessary, this finish may be

wiped with a damp soft cloth using a mild soap

solution, rinsed with clear water and dried with

a soft cloth.

POWER

PRESENTATION PRODUCTS

The

Operating Instructions

For

Designer

Manual Screen

DA-LITE SCREEN COMPANY, INC.

3100 North Detroit Street

Post Office Box 137

Warsaw, Indiana 46581-0137

Phone: 574/267-8101

800-622-3737

Fax: 574/267-7804

http:// www.da-lite.com

e-mail: [email protected]

FOR WALL MOUNTING

HARDWARE PROVIDED

2 – “V” Bars ( one is factory mounted to the

back of the case; one will be mounted to

the wall)

6 – Toggle Bolts, 4"

6 – Lead Shields, #10-14 x 11/2"

6 – Phillips Flat Head Wood Screws, #10 x 2"

TOOLS REQUIRED

Electric Drill

Masonry Bit 5/16" (if mounting in solid masonry

or concrete)

Screw Driver, #2 Flat Tip (if using toggle bolts)

or #2 Phillips (if mounting in solid masonry or

concrete)

INSTALLATION INSTRUCTIONS

Determine the height of the top of the case

from the floor. This will be the height of the

wall mounted “V” bar.

Hold the loose “V” bar to the wall at the height

determined above (MAKE SURE IT IS LEVEL),

and mark the location for the screw holes. To

mount the “V” bar on solid concrete or

masonry wall, drill 5/16" holes and insert the lead

shields. Fasten the “V” bar to the wall using

the #10 x 2" wood screws. If you are mounting

to a hollow wall, drill 1/2" holes and insert the

toggle bolts. Then fasten the “V” bar to the

wall with the toggle bolts. Now set the case in

place on the wall with the “V” bar of the case

nestled into the “V” bar on the wall.

FOR CEILING SUSPENSION

Position and properly anchor screw hooks into

ceiling, beam or other solid surface. Then

proceed to use the two “D” rings that are

factory mounted to the top of the case to hang

the case securely.

TO LOWER AND RAISE PICTURE SURFACE

To lower the picture surface, pull the screen

down all the way. Then hesitate and allow the

screen to retract very slowly until it locks in

place. To raise the picture surface pull down on

the pull bail, then raise quickly, as a window

shade. Keep control of the picture surface. Do

not allow it to roll uncontrolled into the case or

damage to the screen is sure to result.

Allow a minimum of

11/4" from the ceiling

Ceiling

41/4"

Determine

measurement to the

top of the Case

Wall

“V” Bar mounted

to the back of the

Case at the factory

“V” Bar mounted

to the wall

Mount top of

“V” Bar flush

with top of Case

Floor line

Altri manuali Da-Lite Schermo di proiezione

Da-Lite

Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Manuale utente

Da-Lite

Da-Lite Tensioned large advantage deluxe electrol Manuale utente

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL Manuale utente

Da-Lite

Da-Lite IDEA Screen Manuale utente

Da-Lite

Da-Lite TENSIONED DUAL MASKING ELECTROL Manuale utente

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL Manuale utente

Da-Lite

Da-Lite EXECUTIVE ELECTROL Manuale utente

Da-Lite

Da-Lite IDEA Thin Manuale utente

Da-Lite

Da-Lite Picture King Manuale utente

Da-Lite

Da-Lite Designer Da-Tab Electrol Manuale utente

Da-Lite

Da-Lite Designer Electrol Manuale utente

Da-Lite

Da-Lite MULTI-MASK IMAGER Manuale utente

Da-Lite

Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Manuale utente

Da-Lite

Da-Lite Contour Electrol Manuale utente

Da-Lite

Da-Lite Presenter P-50 Manuale utente

Da-Lite

Da-Lite DIRECTOR ELECTROL Manuale utente

Da-Lite

Da-Lite AdvantageManual With CSR Manuale utente

Da-Lite

Da-Lite HORIZON ELECTROL Manuale utente

Da-Lite

Da-Lite C with CSR Manuale utente

Da-Lite

Da-Lite Model C Manuale utente

Da-Lite

Da-Lite Da-Snap Wrap Around Screen Manuale utente

Da-Lite

Da-Lite TENSIONED ADVANTAGE ELECTROL Manuale utente

Da-Lite

Da-Lite ACOUSTICAL IMAGER Manuale utente

Da-Lite

Da-Lite ADVANTAGE ELECTROL Manuale utente

Manuali Schermo di proiezione popolari di altre marche

FART PRODUKT

FART PRODUKT Standard SCREEN Manuale utente

Draper

Draper E Series Manuale

Elite Screens

Elite Screens Elite Tripod Series Manuale utente

Laarhoven

Laarhoven Companion II Manuale utente

Renogy

Renogy RMS-LFPS-US Manuale utente

Samsung

Samsung S*H65* Manuale utente

FONESTAR

FONESTAR PPTR-43100-FA Manuale utente

Slide Clear

Slide Clear Varro XL Manuale utente

Elite Screens

Elite Screens M85XWS1-SRM Manuale utente

OS РХ-090Н Manuale utente

Niko

Niko 10-845 Manuale utente

Speaka Professional

Speaka Professional 2357532 Manuale operativo

Sima

Sima XL-72 Manuale utente

Jasic

Jasic EVO 2.0 ET-200P Manuale utente

Elite Screens

Elite Screens Starling 2 Series Manuale utente

InFocus

InFocus SC-WALL GRY-92H Manuale

Barco

Barco OverView MVL-615 Manuale utente

Draper

Draper Envoy Manuale