1
2
Transmitter Installation :
●
● Stick the Transmitter on the wall or the door with double-sided adhesive tape (see image 2).
2
Battery Installation (Receiver):
● Remove the battery cover, insert batteries into the battery slot with the correct battery polarity.
Receiver Installation:
●
Battery Cover 2x1.5V AA
Alkaline Battery
(Not Included)
1 2
Drill two holes on the wall where desired. The holes are about 6mm in diameter. The
distance between the two holes is about 36mm. Insert two wall plugs (included) into both
holes. Secure the Transmitter cover with two screws. Insert two screws (included) into the
wall plugs. Now close the Transmitter (see image 1).
Drill one hole on the wall where desired. The
hole is about 6mm in diameter. Insert one
wall plug (included) into the hole. Insert one
screw (included) into the wall plug. Do NOT
completely insert the screw into the wall plug;
allow part of the screw to jag out to hold the
receiver. Finally, hang the Receiver.
Avoid placing the Receiver on UPVC frames,
above heat souces or in damp areas.
