Danfoss Link FT Manuale utente

MAKING MODERN LIVING POSSIBLE

Danfoss Heating Solutions

Danfoss Link™ FT Floor Thermostat

Installation Guide

2VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation Guide

Installationsanleitung

Guide d’installation

Installationsmanual

Installationshandbok

Asennusohje

Installatiehandleiding

Instrukcja instalacji

Instalační příručka

4VISGZ45X © Danfoss 04/2011

Introduction ............................................... 5

Installation................................................. 6

Adding device ............................................. 9

Perform network test....................................... 9

Factory reset.............................................. 10

Trouble shooting.......................................... 10

Disposal instructions...................................... 10

Technical speciﬁcations ................................... 11

Index

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

The Danfoss Link™ FT (Floor Thermostat) is a device for

switching the heating element ON/OFF.

In connection with a floor sensor it can also measure the

temperature in the floor (FTS). Secondly you have the

possibility to use the FT as a on and off switch to other

equipments manually or by schedule.

LED

Install button

ON/OFF

safety switch

The Danfoss Link™ FT is powered by 230 V~ and shall

according to regulations be installed on a build in box or on

the wall box.

Introduction

Installation Guide Danfoss Link™ FT

6VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation

The Danfoss Link™ wireless system’s transmission range is

suﬃcient for most applications; however each building has

diﬀerent obstacles aﬀecting communication and maximum

transmission distance.

If communication problems occur Danfoss suggests that

accessories would be required to support the system, such as

repeaters. In exceptional cases the wireless system may not be

suitable for your installation.

Please be aware of the following, when installing Danfoss

Link™ FT:

Installation and placement must be according to

local building regulations.

VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation

Operation mode

Danfoss Link™ FT supports two types of operation modes:

1. ON/OFF switching: do not connect a ﬂoor sensor with

Danfoss Link™ FT in this modus.

2. Heating regulation: when installing the Danfoss Link™ FT

you have to consider the type of heating and thus which

sensors should be used.

There are three options:

1. Comfort heating: Constant temperature on the ﬂoor in

bathrooms and other rooms where a comfortable warm

surface is required. Install the Floor sensor and choose Floor

regulation for the room when doing the conﬁguration.

2. Total heating: Control of room temperature in living rooms

etc. Install the ﬂoor sensor and a Danfoss Link™ RS. Choose

Combined regulation when doing the conﬁguration on the

Danfoss Link™ CC.

3. No ﬂoor sensor: A ﬂoor sensor is not present, and cannot

be installed. You must install a Danfoss Link™ RS. Choose

Room regulation.

Be aware that temperature control is less accurate without a

ﬂoor sensor and that all Danfoss Link™ FT in a room need to

have the same sensor conﬁguration.

Danfoss recommends always installing a ﬂoor sensor.

Note! Do not install electric ﬂoor heating system without a ﬂoor

sensor, when the heating element is installed on or beneath

wooden surfaces and other surfaces sensitive to temperature!

8VISGZ45X © Danfoss 04/2011

Installation

1. To remove the front cover, gently press the release tabs un-

der the bottom of the thermostat with a screwdriver - then

remove the front.

2. Connect the thermostat according to the connection

diagram.

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

Adding the Danfoss Link™ FT to a system is

made from the Danfoss Link™ CC Central

Controller.

When adding, press the install

button until the LED gives a

fast green ﬂash.

For further information,

see the Danfoss Link™ CC

instruction manual:

Conﬁguration 6:

Adding devices.

When the Danfoss Link™ FT

has been added to the Danfoss

Link™ CC Central Controller,

a network test should be

performed.

For more information on

network tests, see the Danfoss

Link™ CC instruction manual:

Conﬁguration 8: Perform

network test.

devireg™550

Installation Guide Danfoss Link™ FT

Adding device

Max. 1 m

Perform network test

10 VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Green LED ON Standby

Red LED ON Heating

Green LED fast ﬂash Inclusion or link test

Red LED short ﬂash Inclusion not OK, goes to not

included.

Linktest not OK, goes to

missing link

RED LED slow ﬂash Sensor failure

Trouble shooting

1. Turn oﬀ power on the safety switch

on the front.

2. Hold the install button in while

pushing ON the safety switch and

keep the install button pressed

until the LED gives a red ﬂash (ap-

prox. 5 sec.)

Factory reset

Disposal instructions

Altri manuali per Link FT

Indice

Lingue:

Altri manuali Danfoss Termostato

Danfoss

Danfoss FH-CWT Manuale utente

Danfoss

Danfoss TP5001 series Manuale utente

Danfoss

Danfoss ECL Comfort 210 Manuale utente

Danfoss

Danfoss WT-DR Manuale utente

Danfoss

Danfoss ECtemp Touch Manuale utente

Danfoss

Danfoss TPONE-RF Manuale utente

Danfoss

Danfoss FP715Si Manuale utente

Danfoss

Danfoss ECtemp 330 Manuale utente

Danfoss

Danfoss REP24CO3 Manuale utente

Danfoss

Danfoss ECL Comfort 210 Manuale utente

Danfoss

Danfoss TP4000 Range Manuale utente

Danfoss

Danfoss ECL Comfort 310, A367 Manuale utente

Danfoss

Danfoss TP5001RF Manuale utente

Danfoss

Danfoss RT 101 Manuale utente

Danfoss

Danfoss ECtemp 530 Manuale utente

Danfoss

Danfoss Link FT Manuale utente

Danfoss

Danfoss FH-CWD Manuale utente

Danfoss

Danfoss EFIT 550 Manuale utente

Danfoss

Danfoss CF-RP 088U0211 Manuale utente

Danfoss

Danfoss FP735Si Manuale utente

Danfoss

Danfoss DEVI DEVIreg Opti Manuale utente

Danfoss

Danfoss RET1001M Manuale utente

Danfoss

Danfoss ECL Comfort 210 Manuale utente

Danfoss

Danfoss RT52 Manuale utente

Manuali Termostato popolari di altre marche

EWELLY

EWELLY EW-181 Manuale utente

Prolon

Prolon T1100 Istruzioni per l'installazione

Computherm

Computherm Q20 Manuale utente

Heatmiser

Heatmiser neoStat Manuale utente

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuale utente

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuale utente

Saswell

Saswell SAS920XWHB-7-S-RF Guida

Aircalo

Aircalo TFP1-ET85P2 Manuale utente

Honeywell

Honeywell CM721 Manuale utente

Carrier

Carrier DEBONAIR 33CS Manuale utente

Lennox

Lennox iHarmony Zone Thermostat Istruzioni per il montaggio

Gemtech

Gemtech GT7000 Manuale di istruzioni

Rollei

Rollei Smartes 45000 Manuale utente

Sinope

Sinope TH1300RF Manuale utente

Honeywell

Honeywell RLV4305 Manuale utente

Honeywell

Honeywell Prestige 2.0 THX9421 Manuale utente

NuTone

NuTone NTBZ48 Istruzioni operative originali

Stelpro

Stelpro MAESTRO ASMT402AD Manuale utente