Danfoss Type CFR Manuale utente

RoomThermostat

User Guide

Type CFR

Temperature setting

Set room temperature on the thermostat dial.

On the right-hand side of the thermostat is a

function switch with 3 possible settings:

The room temperature will be as set

on the thermostat.

The control system must have a CFZ

programmer, put thermostat switch

into this position to engage the pro-

grammer. The temperature will be as

set on the room thermostat, but in ac-

cordance with the consumption pattern

entered.

The heating pattern in the programmer

can be overridden by moving the

switch to or .

The room temperature will be as set

on the thermostat less a setback of

5°C/9°F.

Limitation of the setting range

Behind the dial for temperature setting are two lock-

rings. These can be moved as shown if the thermo-

stat setting range is to be narrowed.

Warning: Changes or modifications to this unit not

expressly approved by the party responsible for

compliance could void the user’s authority to operate

the equipment.

(70°F)

FCC ID: PGBTYPE-CFR , CAN 3934104209

This device complies with Part 15 of the FCC Rules and

with RSS-210 of Industry Canada:

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

Setback

5°C (9°F)

088R0228

Li 3,6V/1,9Ah

088R0228 DKCD 03/01

Registration field in

CFM

RoomThermostat

Instructions for Installation

Type CFR

Each room thermostat has a unique ID number

preventing conflicts with other thermostats. A single

room thermostat is capable of regulating several

heating outputs, provided these outputs are assigned to

the thermostat.

Assigning thermostats to output(s)

-The installation cable between room thermostat and

CFM (fig. 1) must be connected in assigning each

thermostat to the respective output(s).

-IntheLED array the firstavailable position will flash.

Outputs already assigned will not be lit (fig. 2). By

pressing OK the thermostat will be assigned to that

output. If the room thermostat is to be assigned under

another lit output, scroll to the output bymeansof the+/-

keys,then press OK.

-When the installation cable is removed, the red LED

underneath the battery cover (fig. 1) will flash for at

least one minute (Test mode).

Removal of assigned thermostat

-It is not necessary to have the installation cable in

place when removing an assigned thermostat. Once a

thermostat has been removed, it may be reassigned to

another output.

-Removal of room thermostat is done by pressing OK

for 5 seconds, then the entire LED array will be lit.

Scroll to the specific room thermostat to be removed

with the +/- button,and press OK for 5 seconds. The

thermostat has now been removed.

Test of room thermostat

If a defect in a room thermostat is suspected, the fol-

lowing test may be carried out:

- Set the thermostat to the highest temperature.

- Move the function switch on the side of the room ther-

mostat to a new position.

- If the LED underneath the battery cover (fig. 1) flashes

quickly for 3 minutes, the room thermostat is OK.

Indice

Altri manuali Danfoss Termostato

Danfoss

Danfoss TP4 Istruzioni operative

Danfoss

Danfoss ECtemp Next Plus Manuale utente

Danfoss

Danfoss TP75M Manuale utente

Danfoss

Danfoss RTW-RA Manuale utente

Danfoss

Danfoss LinkFT Manuale utente

Danfoss

Danfoss RET B Istruzioni operative

Danfoss

Danfoss CET2000B-RF + RX1-S + CS2 Manuale utente

Danfoss

Danfoss 088U0212 Manuale utente

Danfoss

Danfoss DEVI DEVIreg Opti Manuale utente

Danfoss

Danfoss TP9 Manuale utente

Danfoss

Danfoss RMT-230 Manuale utente

Danfoss

Danfoss RET 230LS Manuale utente

Danfoss

Danfoss living connect Manuale utente

Danfoss

Danfoss FH-CWP Manuale utente

Danfoss

Danfoss DEVIreg 316 Manuale utente

Danfoss

Danfoss RET2000B-RF Manuale utente

Danfoss

Danfoss TP7001 series Manuale utente

Danfoss

Danfoss TP4000 Range Manuale utente

Danfoss

Danfoss FP715Si Manuale utente

Danfoss

Danfoss GET B-RF Guida

Danfoss

Danfoss RET2000 B Manuale utente

Danfoss

Danfoss Eco Manuale utente

Danfoss

Danfoss ECtemp 550 Manuale utente

Danfoss

Danfoss ECtemp Next Plus HW Manuale utente

Manuali Termostato popolari di altre marche

EWELLY

EWELLY EW-181 Manuale utente

Prolon

Prolon T1100 Istruzioni per l'installazione

Computherm

Computherm Q20 Manuale utente

Heatmiser

Heatmiser neoStat Manuale utente

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuale utente

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuale utente

Saswell

Saswell SAS920XWHB-7-S-RF Guida

Aircalo

Aircalo TFP1-ET85P2 Manuale utente

Honeywell

Honeywell CM721 Manuale utente

Carrier

Carrier DEBONAIR 33CS Manuale utente

Lennox

Lennox iHarmony Zone Thermostat Istruzioni per il montaggio

Gemtech

Gemtech GT7000 Manuale di istruzioni

Rollei

Rollei Smartes 45000 Manuale utente

Sinope

Sinope TH1300RF Manuale utente

Honeywell

Honeywell RLV4305 Manuale utente

Honeywell

Honeywell Prestige 2.0 THX9421 Manuale utente

NuTone

NuTone NTBZ48 Istruzioni operative originali

Stelpro

Stelpro MAESTRO ASMT402AD Manuale utente