1. FCC INFORMATION
This monitor has been tested and found to comply with the limits for a class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This monitor generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
monitor does cause harmful interference to radio or television reception, which can be determined
by turning the monitor off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the monitor into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables and A.C. power cord, if any, must be used in order to comply with emission
limits.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the monitor.
2. CE INFORMATION
The monitor must be installed according to the currently valid installation regulations for EMC to
guarantee the designed use and to prevent EMC problems.
The monitor supplied with this manual is according to the EC, EMC Directive,
2014/30/EU & LVD 2014/35/EU
3. SAFETY PRECAUTIONS
1. Do not modify the three-prong grounding type monitor power plug in any way.
2. Operate this unit only from the type of power source indicated on the label.
3. Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.
4. Do not place this monitor near a radiator or heating vent.
5. Do not push objects of any kind through cabinet openings. This may result in fire or electrical
shock.
6. Before adding attachments always ask a service technician to perform routine safety tests to
determine that the monitor is in safe operating condition. Ground potential tests should be part of
the routine safety check made by the service technician.
7. Do not place the monitor on an unstable cart, stand, or shelf where it may fall and injure
