Daytona DD125E-5C Manuale utente
MOTORCYCLES
DAYTONA SERIES DD125E-5C DD350E-6C DD400E-6C
This manual including the following model
DD125E-5C DD350E-6C DD400E-6C
2
3
4-8
9
10
11-16
9
19
17-18
20-24
25
The engine of this motorcycle rotates at
high speed. In order to make sure that the
engine can run normally, prolong its service
life and safeguard your interests, please
operate the motorcycle according to the
following regulations:
Since this manual covers a few model and
specification, the pictures listed are not covering
all of the parts or spec, so please take the actual
Safety driving through
Position of parts mounting
Function of parts
1.Lubrication
2.Tire pressure
3.Operating instructions
4.Repair and maintenance
5.Fault maintenance
6.Maintenance period table
7.Motorcycle main specs
8.Motorcycle electrical schematics
products as the standard.
..................
..............
........................
............................
...........................
.................
..............
.....................
..............
................
.....
CONTENTS
2
Motorcycle safety riding and &important notice
ACCESSORIES
Accessories produced by our company have
been under special design and test, and can render
the motorcycle safe. They are optional for users.
Users will take responsibility for their selection,
installation and use of accessories not produced
by our company. Please obey safe riding rules
and follow the next points: Carefully check your
accessories, make them out of sight line, reduce
ATTENTION
Proper use can extend the lifetime of the engine
Play a complete role of new bike function, please
ride bike according to following requirements.
1. During the first 1000km, avoid full throttle
and never labor the engine. The rotating speed of
the engine should be strictly restricted to less than
6000rpm.
2. After the first 300 km, 600km and 1000km,
please clean the engine and change. The engine oil
in accordance with the requirements of operation
and maintenance Manual.
EFI model has fuel injection system replying on
power.Please do not add extra equipment to cause
the problem like default or distroy the ECU.
A motorcycle rider ususally has his /her head
injured in an accident. In order to ensure personal
safety, the rider should wear a helmet, goggles,
boots, gloves etc.The passenger should wear the
The temperature of the muffler is very high when
the motorcycle is ridden. The passenger should wear
boots or shoes high enough to cover his/her angles to
prevent his/her feet from being scalded. The rider
should wear close-fitting clothes to prevent loose
clothing catching the handlebar, kick stand, footpegs
and tyres.
same gear.
PROTECTIVE APPAREL
distance between them and the ground and side up
angle, and keep suspension or steering device from
moving or affect handling. Avoid attaching any
electrical equipment.Otherwise it can bring trouble
to the electrical system.
Warning:
Motorcycle parts position
①REAR MIRROR
②CLUTCH CONTROLL GRIP
③LEFT SWITCH
④THROTTLE GRIP ⑤RIGHT SWITCH
⑥BRAKE LEVER ⑦ODOMETER
3
①
②
③④
⑤
⑦⑥
Headlock
headlock①is below the steering.
Please turn to the very left,take out
the key and turn at clockside, take
out the key
Attention:
When lock the bike, please don't move
orstart the bike
4
FUNCTION OF PARTS
②③
IGNITION SWITCH
Switch at ① right side of chasis, pls open the
switch cover first. Insert key,turn 90°at clockwise，
the ignition switch can turn both sides, start the
engine, the key can pull out any condition.
Ignition at position②：engine can not start with
all routing shut off。
Ignition at position③：engine can start with all
routing on Meanwhile all head light , tail light,etc
are on. Odometer dial is bright.
Ignition switch turn to position ④ ：engine can
start , but position light and meter dial light is off.
Kindly suggest you to switch the ignition to position
4 when start.
①④
①
Suit for water cooling model
EFI Bike valid
⑤ distance data resetting
anticlockwising the odometer handle, the
distance data changes to 0.
⑧short distance data
for short distance purpose, it can be changed to O.
⑥speed
showing the km/hr。
⑦odometer
it can grand total the number KM/miles, do not
delete the numbers.
⑨water temperature indicator (except DD400E-6C)
⑩EFI warning light
it shows the temperature of water cooling. When
it turns to the red,means the temperature is too high.
Warning:
When red light is on, please stop riding, check
the fun, coolant is enough or not. please check
the details until bike okay.
5
FUNCTION OF PARTS
ODOMETER
①Left idicator
switch to the left, it will flash when making a
left turn.
②high beam
high beam will be on by turning the switch to
high beam
③neutral light
when engine is in neutral, the N light will be
on, and others are off.
⑨
① ② ③ ④
⑤ ⑥ ⑦ ⑧
⑩
④right indicator
switch to the right, it will flash when making
a right turn.
⑨
①②
③④
⑥⑦
⑩
12 11
⑥Choke handle
Please dial down the choke handle,open the choke
when starting the bike,
④
If you want to overtake the others. Please press
the high beam continuously for safety.
⑤headlight changing switch
If you need dipped headlight, please switch to
“ D ”position；if you need high beam, please
switch to“ D ”。
carburator version only.
Overtake
By starting the bike, please dial up the choke handle,
close the choke.
③clutch controll handle
when you want to shift the gear, please hold the
handle with grip hardly to seperate the clutch
If you wanna to start the engine, please pull the
handle as well, then the bike can start up.
6
×
Right handle switch(no AHO)
①cutoff preset switch
“ ” position：all circuit
shut off engine can not start or
cutoff the running engine.
Fuel gage
The EFI light is on when switched, it is off when
start the engine. If the light still on, it means that
the bike still have problem.
Please use the Diagnostic to check the failure code
and solve it.
For EFI bike
It shows the fuel in tank. If indicating below red
line, please fuel the bike a.s.a.p.
The EFI bike need enough fuel.otherwise few
fuel will cause the fuel pump idling and distroy
the fuel pump.
Warning:
Left switch
②turning light switch
If you need to turn left, then
move “ ”position，If you
need to turn right, then move to ”position.Move
the arrow to the middle, then it is 。
“
①horn
Press horn if you need to use it.
① ②
③④ ⑤
①②
③
④
×
①cutoff preset switch
“ ” position：all circuit
shut off engine can not start or
cutoff the running engine.
“ ”：means the bikecircuit on, you can start
the engine.Please set the swith to“ ”position.
②throttle grip
adjust the throttle full-size，controlling the bike
speed grip turning to rider yourself,it's accelerating.
otherwise it's slowing speed.
③power with electric press-button
1、Engine is in Neutral or in gears, grasp the
cluth handle to separate the clutch disc.
2、key to the ignition switch,turn to“ ”position.
3、cutoff switch to“ ”position, press power with
electric button“ ”turn throttle grip,the engine can start
warning：
Every ignition less than 5s and 10s between
twice.If failure,please check oil-way &system
7
Right handle switch(EURO Ⅳ）
NOTE:EURO 4 AHO.
P
“ ”：means the bikecircuit on, you can start
the engine.Please set the swith to“ ”position.
②throttle grip
adjust the throttle full-size，controlling the bike
speed grip turning to rider yourself,it's accelerating.
otherwise it's slowing speed.
③headlight switch
P
It has three swtiches“ ”“ ”and“ ".
“ ”：headlight, taillight, odometer light are on
“ ”：front position light, tail light,odometer
light are on.
“ ”：front light, tail light, front position light,
odometer light are closed.
④power with electric press-button
1、Engine is in Neutral or in gears, grasp the
cluth handle to separate the clutch disc.
2、key to the ignition switch,turn to“ ”position.
3、cutoff switch to“ ”position, press power with
electric button“ ”turn throttle grip,the engine can start
①②
③
It's not well locked to pull out the key.Please
do not extract it strongly forced.
please do not over fuel exceeding the neck of
it.Please lock it when fully fuele。d.
REAR SHOCK
Fuel tank & tank cover
Open the cover, insert the ignition
key turn right at 90 degree.Yo can
open the cover. Press it when you
want to close it and pull back&take
out the key.
Fuel tank switch
Suit for carburator models
The whole fuel is closed by this position。
Please close this fuel switch by long time riding.
Warning：
Please fuel the bike immediatley when you start
to use spares(only2.7L), please turn on the switch
after fueling it.
Turn on
please turn to this position, the fuel enters into
the carburator smoothly.
Spare
When normal fuel is
used up, please handle
this to use the spare.
Close
Fuel pump
Suit for EFI models
EFI fuel the bike using fuel
pump Open the ingition lock,
fuel pump runs 5 s.Stop working
after 2-3seconds.Pump always working afer engine
starts, It's destroyed by the pump idling.please pay
attention to the fuel always.
Fuel pump assy.
Fuel tank cover Turn on Spare Close
Attention：
8
①locknut
②Adjust
You can adjust the position
please loose the locknut ①，
loose or tighten the nut ②。
adjust the spring tention, to
tighten or loosen the rear
suspension。
please make sure the same
tension
Shifter
N
① ② ③ ④ ⑤
This engine has 5 gears internationally,The
relationship chart please refer
to following：
Lubrication fuction
lubrication oil is very important for engine
lifetime,please forbid to use bad quality oil.
We suggest to use SAE15W / 40 API SJ oil.If you
want to use others, the level need to reach above SG,
the viscosity shows a rather pronounced variation
with temperature. Please exhaust all lubrication in
the crankcase and fuel the new lubrication oil。
Attention:：
Please send the used
lubrication to the recycle
bin.to avoid polluting the
environment.
Tyre pressure
Correct tyre pressure can hold the best stable ride
and comfort ride,make the tyre long time use.
It's dangerous to use over worn tyre,and effect
stability,steering and operation improper pressure
can cause the extra worn and cause accident, Less
pressure can cause the damage or get out of rim
and lead to accident.
Please check the tyre pressure. Check its scratch ,
nail or others sharps when bike is not started.Check
the tyre sunk or out of shape. If problem, please
repare it or replace it immediately.
Please change tyre of following limits pattern
min.limit Deep pattern（mm）
Front tyre：1.5 Rear tyre：2.0
Dangerous
Load
Rider
rider and passengers
Pressur（e Kpa）
Pressur（e Kpa）
F.tyre:225 rear tyre:225
front tyre:250
rear tyre:250
9
Altri manuali per DD125E-5C
1
Questo manuale è adatto per i seguenti modelli
2
Indice
Altri manuali Daytona Motociclo
