Dell DX6012S Manuale utente
Dell™ DX6012S Systems
Getting Started
With Your System
Guide de mise en route
Introducao ao uso do sistema
Pasos iniciales con el sistema
Dell™ DX6012S Systems
Getting Started
With Your System
Regulatory Model E13S Series
Notes, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use of
your computer.
CAUTION: A CAUTION indicates potential damage to hardware or loss of data if
instructions are not followed.
WARNING: A WARNING indicates a potential for property damage, personal
injury, or death.
____________________
Information in this document is subject to change without notice.
© 2010 Dell Inc. All rights reserved.
ReproductionofthesematerialsinanymannerwhatsoeverwithoutthewrittenpermissionofDellInc.
is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.; Intel and Xeon are
registered trademarks of Intel Corporation in the U.S. and other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming
the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and
trade names other than its own.
Regulatory Model E13S Series
February 2010 P/N C3PHM Rev. A00
Getting Started With Your System 3
Installation and Configuration
WARNING: Before performing the following procedure, review the safety
instructions that came with the system.
Unpacking the System
Unpack your system and identify each item.
Assemble the rails and install the system in the rack following the safety
instructions and the rack installation instructions provided with your system.
4Getting Started With Your System
Connecting the Power Cable(s)
Connect the system’s power cable(s) to the system.
Securing the Power Cable(s)
Bend the system power cable into a loop as shown in the illustration and secure
the cable to the bracket using the provided strap. Plug the other end of the
power cable into a grounded electrical outlet or a separate power source such as
an uninterrupted power supply (UPS) or a power distribution unit (PDU).
Getting Started With Your System 5
Turning On the System
Press the power button on the system. The power indicators should light.
Installing the Optional Bezel
Install the bezel (optional).
6Getting Started With Your System
Other Information You May Need
WARNING: See the safety and regulatory information that shipped with
your system. Warranty information may be included within this document or
as a separate document.
• The rack documentation included with your rack solution describes
how to install your system into a rack.
•The
Hardware Owner’s Manual
provides information about system
features and describes how to troubleshoot the system and install or
replace system components. This document is available online at
support.dell.com/manuals
.
• Any media that ships with your system that provides documentation
and tools for configuring and managing your system, including those
pertaining to the operating system, system management software,
system updates, and system components that you purchased
with your system.
NOTE: Always check for updates on support.dell.com/manuals and read the
updates first because they often supersede information in other documents.
Obtaining Technical Assistance
If you do not understand a procedure in this guide or if the system does
not perform as expected, see your Hardware Owner’s Manual. Dell offers
comprehensive hardware training and certification. See dell.com/training for
more information. This service may not be offered in all locations.
Getting Started With Your System 7
NOM Information (Mexico Only)
The following information is provided on the device described in this
document in compliance with the requirements of the official Mexican
standards (NOM):
Technical Specifications
Importer:
Model number: E13S Series
Supply voltage: 100–240 V CA
Frequency: 50/60 Hz
Current consumption: 7.5–4.0 A
Processor
Processor type One Intel®Xeon®processor 5000 series
Expansion Bus
Bus type PCI Express Generation 2
Expansion slots using riser card
Slot 1: PCIe x4, half-length, full-height
Slot 2: PCIe x4, full-length, full-height
Slot 3: PCIe x8, half-length, full-height
Slot 4: PCIe x4, internal slot for integrated card
NOTE: All four slots are x8 connectors.
8Getting Started With Your System
Memory
Architecture 1066 or 1333 MHz DDR3 registered or
unbuffered Error Correcting Code (ECC)
DIMMs
Memory module sockets Eight 240-pin
Memory module capacities 1 GB, 2 GB, 4 GB, or 8 GB
Minimum RAM 1 GB
Maximum RAM 64 GB (8 GB dual- and quad-rank DIMMs)
Drives
Hard drives Up to twelve 3.5-inch, hot-swappable SAS,
SATA, or SSD drives
Optical drive Optional external USB DVD-ROM
Connectors
Back
NIC
Two RJ-45 (for integrated 1 GB NICs)
Serial
9-pin, DTE, 16550-compatible
USB
Two 4-pin, USB 2.0-compliant
Video
15-pin VGA
Front
Video
15-pin VGA
USB
One 4-pin, USB 2.0-compliant
Internal
USB
Two 4-pin, USB 2.0-compliant
Video
Video type Matrox G200, integrated in the BMC
Video memory 8 MB
Altri manuali per DX6012S
3
Indice
Lingue:
Altri manuali Dell Magazzinaggio
Dell
Dell PowerVault 220S Manuale utente
Dell
Dell PowerVault 51F Manuale utente
Dell
Dell PowerVault LTO Manuale utente
Dell
Dell VxRail E660 Manuale
Dell
Dell PowerVault MD3600i Series Manuale utente
Dell
Dell SC4020 Guida di riferimento rapido
Dell
Dell PS4100 Manuale del proprietario
Dell
Dell PowerVault RD1000 Manuale utente
Dell
Dell PowerVault NX1950 Manuale utente
Dell
Dell PowerVault MD3200i Series Manuale utente
Dell
Dell SD630-S Guida di riferimento rapido
Dell
Dell EqualLogic PS Series Istruzioni utente
Dell
Dell PowerVault DL2200 CommVault Manuale utente
Dell
Dell PowerVault MD3200i Series Guida di riferimento rapido
Dell
Dell PowerVault ML6000 Manuale utente
Dell
Dell PowerVault NX1950 Guida di riferimento rapido
Dell
Dell FS7500 Manuale utente
Dell
Dell EqualLogic FS7600 Istruzioni per il montaggio
Dell
Dell PS6000 Manuale del proprietario
Dell
Dell PowerVault NX1950 Guida rapida
