DeLonghi IH Manuale utente

RADIATEUR INFRAROUGE - IH-IHF

STUFA INFRAROSSI - IH-IHF

qermastra uperuqrhs aktinobolias -

IH-IHF

INFRAROOD KACHEL - IH-IHF

AQUECEDOR POR INFRAVERMELHO - IH-IHF

AQUECEDOR POR INFRAVERMELHO - IH-IHF P

RADIANT HEATER - IH-IHF

A) If your appliance comes fitted with a plug, it will incor-

porate a 13 Amp fuse. If it does not fit your socket, the

plug should be cut off from the mains lead, and an

appropriate plug fitted, as below.

WARNING: Very carefully dispose of the cut off plug

after removing the fuse: do not insert in a 13 Amp

socket elsewhere in the house as this could cause a

shock hazard.

With alternative plugs not incorporating a fuse, the cir-

cuit must be protected by a 15 Amp fuse.

If the plug is a moulded-on type, the fuse cover must be

re-fitted when changing the fuse using a 13 Amp Asta

approved fuse to BS 1362. In the event of losing the

fuse cover, the plug must NOT be used until a replace-

ment fuse cover can be obtained from your nearest

electrical dealer. The colour of the correct replacement

fuse cover is that as marked on the base of the plug.

B) If your appliance is not fitted with a plug, please fol-

low the instructions provided below:

WARNING - THIS APPLIANCE MUST BE EARTHED

IMPORTANT

The wires in the mains lead are coloured in accordance

with the following code:

Green and yellow: Earth

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead may not corre-

spond with the coloured markings identifying the terminals

in your plug, proceed as follows:

The green and yellow wire must be connected to the termi-

nal in the plug marked with the letter E or the earth symbol

or coloured green or green and yellow.

The blue wire must be connected to the terminal marked

with the letter N or coloured black.

The brown wire must be connected to the terminal marked

with the letter L or coloured red.

N

E

L

ELECTRICAL CONNECTION (UK ONLY)

RADIANT HEATER

Technical Data

Type Category Low Maximum Medium Gas pressure

Input Input Input

KW g/h KW g/h KW g/h

1.50 109 4.20 305 2.85 207 28÷30 mbar

This appliance is designed to operate with Butane at nominal pressure: 28 ÷ 30 mbar. For

a regular gas combustion the required air quantity is: 8,4 m3/h.

WARNINGS

- ALWAYS use heater in accordance with instructions. Read the instructions book carefully

and keep it in a safe place.

- This appliance requires a rubber tube and a pressure regulator in accordance with the

law in force. If not supplied check with your gas supplier.

- Use ONLY in a well ventilated area.

- This appliance MUST NOT be used in basements, high rise flats, bathrooms or

bedrooms and in rooms having volume less than 15m3(30 m3in living rooms).

- This appliance emits the combustion residues in the room in which is used.

- DO NOT USE in recreative vehicle (caravans and campers).

- DO NOT place clothes or other materials on the heater, as apart from the danger of fire

their presence could affect the efficient working of the appliance (fig. 1).

- DO NOT move heater from room to room when it is lit (fig. 2).

- DO NOT position heater alongside a wall or near curtains or arm-chairs etc. (fig. 3 - 4).

- ALWAYS face heater towards centre of room. Special care should be taken if the heater is on

a surface where it can move or twist on its wheels or castors if knocked by a child or dog, etc.

- Minimum Clearance : 200 mm from sides,1500 mm from front.

- The heater you have purchased is fitted with safety devices which come on in the event

of malfunctioning while the appliance is in use. If the pilot light (placed opposite the

burner) accidentally goes out, or if the room is not sufficiently ventilated, the safety devi-

ce will block the gas flow, causing the heater to go off.

- Do not use the heater at high altitudes.

Gas leakages

If a leak is suspected, turn off gas at the gas bottle, open the window and air the room. DO

NOT disconnect the pressure regulator. Extinguish all naked lights. Slowly turn the gas on

and brush the connections with soapy water or liquid detergent - a gas leak will form bub-

bles. If a leak is found, turn the gas off and inform your Dealer. DO NOT use the heater

again until it has been inspected by your Dealer. NEVER USE MATCHES TO FIND LEAKS.

I3B

G30

GENERAL SAFETY INSTRUCTIONS

Gas bottle

Gas Bottle with 15 kg of maximum capacity can be installed.

Changing of gas bottle must not be carried out in the presence of a naked flame.

Use the gas bottle always in upright position. If a screw on regulator is used ensure that the

regulator washer is present and in good condition -replace if in any doubt.

To place the bottle in position, remove the rear panel which faces the inside during tran-

sport, by unfastening the screws; than put the bottle in position and replace the panel.

Pressure regulators, rubber tubes and clips

CHECK that tubing is completely over the nozzles at each end of

the tubing and that it is held firmly in place by tube clips (See

fig.5). Examine flexible tubing regularly and

get your Dealer to fit new tubing 400 mm

long complying to local standard, if peri-

shed, worn or damaged.

Ensure that the rubber tube inserted in the plastic support (see fig.

6). When connecting the pressure regulator to the gas bottle avoid

undue twisting of the flexible tubing.

A 28 ÷ 30 mbar (11.2 in w.g.) pressure regulator for Butane or

Propane complying to local standard must be connected to the

appliance with the above tubing, using suitable tube clips.

Room ventilation

USE ONLY IN A WELL VENTILATED ROOM

Adequate ventilation must be provi-

ded in rooms in which the heater is

used. This ensures removal of the

products of combustion and allows

the entry of replacement air.

The following table shows the smal-

lest size of room suitable for each

heat setting and the dimensions of

the aperture which must be provi-

ded equally divided between high

and low level.

SAFETY GUARD

The guard is to prevent risk of fire and no part of it should be permanently removed.

It does not give full protection for young children or the infirm.

fig. 5

fig. 6

Control knob setting Room Size Room Aperture

Position

big flame

(maximum rate)

15 m3

105 cm2

Position

medium flame

(medium rate)

28.5 m3

Position

small flame

(low rate)

42 m3

OPERATING INSTRUCTIONS

Lighting the heater

1. Turn on the gas at the gas bottle tap.

2. FROM «G» POSITION, fully depress the control knob for 10 seconds and turn to

(Small Flame) position. (If pilot flame does not ignite return to starting position and

repeat). When the pilot flame is lit, continue to fully depress the knob for a further 20

seconds to allow the thermocouple probe to heat up. Then turn the knob to select the

desired setting as follows:

(Small Flame) Low Input (Big Flame) Maximum Input

(Medium Flame) Medium Input,

Auxiliary ignition

Should piezoelectric starter fail to work, repeat operation on control knob and use a match

to light pilot flame and repeat the operations above described.

Tunring off the heater

Turn off the gas bottle tap. The Heater will be totally “OFF” only if the tap at the gas bottle is turned off.

Important

When the large knob is released at the end of the ignition time (see the rating plate and

instruction booklet), it must return upwards by around 5 mm to its initial position. If this does

not happen, close the gas tap and contact your after-sales service centre. Never operate the

appliance with the large knob held downwards by force.

VENTILATED RADIANT HEATER

Electrical connection

- Before using the appliance check that your supply voltage is the same as that shown on

the rating label of the unit.

- Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.

- THIS APPLIANCE CONFORMS TO DIRECTIVE EN 55014 GOVERNING RADIO INTER-

FERENCE.

Operation and use

Fully insert plug into socket-outlet and switch on the fan heater following the instructions of

Fig. 7. Before switching on the gas burner, read carefully the relevant operating instructions.

VENTILATION ONLY

(It can be used together

with the gas burners for

an adequate heat distri-

bution). OFF

VENTILATION + 1000 W

HEATING RIGHT OR LEFT

(It can be used together with the

gas burners - 4200 W - for the fast

heating of the room).

VENTILATION + 2000 W

HEATING

(It can be used together with

the gas burners - 4200 W -

for the very fast heating of

the room).

Fig. 7

TENSION

220-230V 9,0A50Hz 2000W

FREQUENCY AMPS MAXIMUM

POWER

IMPORTANT

DO NOT cover the appliance when in operation, this could cause a dangerous rise of the

temperature of the fan heater with consequent risk of fire.

Important notes

- Your heater must always be earthed: warranty does not cover damages caused by non-

observance of this warning.

- Do not use your heater close to wash-basin, bath- tub, shower, swimming pool.

- Do not lay the cable on the hot unit.

- Use the appliance only standing on the floor.

- The heater must always operate in upright position.

- Do not cover either the hot air output or input grid on the top of the unit during service.

- Replacement of the power cable must be carried out by qualified personnel. Always use

original spare parts supplied by the manufacturer.

- The heater must not be located immediately below a fixed socket outlet.

-A safety device switches the fan heater off if it accidentally overheats.

To reset the unit for normal operation, remove the plug from the mains

socket for a few minutes, eliminate the cause of the overheating (e.g. air

intake or outlet grilles obstructed) and then plug the fan heater back in

again. Contact your nearest Technical Assistance Service if the fan heater

does not start operating normally again.

- Never direct the fan hater’s air flow towards furniture, curtains , spray cans and inflam-

mable material.

- Do not install the appliance in a room which might contain gas, oil or sulphur, or near

sources of heat.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the termal cutout, this

appliance must not be supplied through an external switching device, such us a timer, or

connected to a circuit that is regularly switched on and off by the utility.

MAINTENANCE

Wipe your appliance with a soft damp cloth and only when it is switched off, cold and

unplugged. Do not use solvents or abrasives detergents.

Check that there is no dust blocking the air inlet or outlet grids. Clean using a vacuum clea-

ner. When not in use the heater should be covered and stored in a dust-free place. Refer

any major maintenance to your Local Authorised Dealer. Major servicing should be carried

out every 2 - 3 years. If in doubt refer to your nearest authorised dealer.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali DeLonghi Stufa

DeLonghi

DeLonghi FAN HEATER Manuale utente

DeLonghi

DeLonghi TRRS0920C Manuale utente

DeLonghi

DeLonghi HVY1020 Mini Manuale utente

DeLonghi

DeLonghi TRV Series Manuale utente

DeLonghi

DeLonghi HTF3033 Manuale utente

DeLonghi

DeLonghi Dragon4 Pro Manuale utente

DeLonghi

DeLonghi HS Manuale utente

DeLonghi

DeLonghi HCX9115E-6A AG Manuale utente

DeLonghi

DeLonghi DUH 1000 Manuale utente

DeLonghi

DeLonghi DRAGON 4 Manuale utente

DeLonghi

DeLonghi HFX60 Series Manuale utente

DeLonghi

DeLonghi DCH6031 Manuale utente

DeLonghi

DeLonghi Electric oil filled radiator Manuale utente

DeLonghi

DeLonghi DFH132 Manuale utente

DeLonghi

DeLonghi MTR2000 Manuale utente

DeLonghi

DeLonghi CERAMIC FAN HEATER Manuale utente

DeLonghi

DeLonghi EW7507EB Manuale utente

DeLonghi

DeLonghi TRN Manuale utente

DeLonghi

DeLonghi EW 7707CM Manuale utente

DeLonghi

DeLonghi DRAGON 4 TRDS4 0820E Manuale utente

DeLonghi

DeLonghi Dragon 4 Pro Manuale utente

DeLonghi

DeLonghi TRRS0920E.G Manuale utente

DeLonghi

DeLonghi HCA324FS Manuale utente

DeLonghi

DeLonghi HSX3320 Series Manuale utente

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente