Delta Electronics UNOnext Manuale utente
Delta Electronics, Inc.
UNOnext
Troubleshooting: RS485
2
RS485
Following the documents: UNOnext quick start guide and UNOnext Modbus RTU the
Building Management
System
(BMS) system retrieves the UNOnext data via RS485 interface. If there is any trouble, please check the
items below to verify the environment and device settings in the RS485 bus. All referred documents can be found
at https://isdweb.deltaww.com/resources.
3
Environment Settings
1. Check for correct power from the 9-24V DC input or adapter is correct.
If the power supply is normal and the UNOnext hardware is normal, the power led is on. If the power supply
is normal but the power led is not on, please send UNOnext back for repair.
2. Check that A2 (+) and B2 (-) are properly connected to Modbus RTU client.
3. Check the cable specifications.
It is recommended to use a 22AWG/24AWG multi-core shielded twisted pair cable or above to achieve the
best performance for UNOnext.
4. Check that the signal and power wire are in the same conduit or not.
It is recommended to separate the signal and power wire into separate conduit. Or use the individual power
supply for UNOnext.
Please refer the following suggested RS485 wire specs:
Twisted Pair Cable
22-24AWG twisted pair, shielded jacketed communication cable.
Characteristic impedance of 100-120 ohms.
Capacitance of 17 pF/ft conductor-to-conductor or less. 18AWG cable does not meeting this
specification.
Braided or aluminum foil shield.
Velocity of propagation of 66% or higher.
Example compatible cable products are Belden 9841, Belden 82841 and Windy City Wire 42002-S
4
Device Settings
1. Check the Modbus RTU slave address settings.
The Modbus RTU slave address is set by DIP switch from [2] to [5] in the back of UNOnext. The DIP definition
corresponding to the slave address is shown as below table.
Modbus Salve Address
PIN No. of DIP switches
Decimal
Hexadecimal
2
3
4
5
208
0xD0
209
0xD1
210
0xD2
211
0xD3
212
0xD4
213
0xD5
214
0xD6
215
0xD7
216
0xD8
217
0xD9
218
0xDA
219
0xDB
220
0xDC
221
0xDD
222
0xDE
223
0xDF
2. Check the UART settings.
The UART settings for UNOnext as:
Baud: 9600 by default, also supports 38400, 57600, 115200 modified by Modbus RTU protocol. (See
UNOnext Modbus RTU)
Data-bit: 8
Parity: None
Stop-bit: 1
3. If the UNOnext daisy-chained for longer distances, please pull up the DIP switch [1] to enable Modbus
terminal resister to try.
4. Try a factory reset.
5
If the problem is still not solved after checking and modifying the above device settings, please try to restore
the factory settings.
METHOD: After booting, press the filter reset key three times duration one second to execute factory reset.
After factory reset, all settings will be cleaned.
Note. If all actions do not resolve the problem, please contact your dealer for assistance.
Indice
Altri manuali Delta Electronics Monitor
Delta Electronics
Delta Electronics A10 Manuale utente
Delta Electronics
Delta Electronics A10 Manuale utente
Delta Electronics
Delta Electronics Network Device DOP-B Manuale utente
Delta Electronics
Delta Electronics Digital Setup Display DVPDU-01 Manuale utente
Delta Electronics
Delta Electronics Network Device DOP-A/AE/AS Manuale di istruzioni
