■ The Privacy Button
Pressing the Privacy button will select Privacy. This will prevent others from listening
to your Unit. If you wish to respond to a call and privacy is selected you can cancel
Privacy by pressing the Privacy Button.
To select full privacy where you cannot be called or listened to, press and hold
Privacy for more than two seconds. A short beep will be heard when the Button is
released to indicate full privacy has been selected.
■The Music Button
If music is connected to the system pressing the Music button will allow music to be
heard. To cancel music, press the Music button again. Music may not be selected
when the Unit is included in an intercom call.
Music may be set for 60 minutes at any Room Unit. To select music for 60 minutes
press and hold the Music button for more than two seconds. When the Music button
is released a short beep will be heard to indicate that 'sleep' has been selected (See
Radio Button page 3).
6
■Clock Set Button (cont.)
While the time is displayed the Dot will flash every second.
When the Alarm Time is displayed the dot will not flash.
■Alarm Set Button
When the alarm time is displayed a vertical dash will be shown in the top left corner
of the 4 digit display.
To adjust the alarm time, press the Alarm Set button to place the system in “ALARM
SET MODE”while in this mode you can press either the hour or minute button to
adjust the ALARM time. To Exit “ALARM SET MODE”press the Alarm Set button
again.
To activate the alarm press the Alarm button. The alarm light will illuminate to
indicate that the Alarm has been turned on. To turn off the Alarm press the Alarm
button again.
The Alarm will turn the Radio on and music will be heard for approximately one hour
at the Room Units. The Radio will continue to be heard at the Master Unit.
■Display Button
The Display button will change the display to show the time, Alarm time and the
Radio frequency each time it is pressed. The Display will automatically revert back to
the time display.
■Radio Button
The Radio controls are located below the Clock controls. The Radio On/Off button
turns the Radio on or off. When the Radio is turned on the Radio On/Off light will be
illuminated. (Note: Music button must be turned ON to hear the Radio.)
To tune the Radio press one of the Tuning buttons either up or down for one
second. The radio will automatically search for a station. If the radio scans past your
required station simply tap either Tuning button to stop the scan. You can then
manually tune the radio by briefly tapping one of the Tuning Buttons and it will step
through the channel bank each time the Tuning Button is pressed.
To switch from the AM Band to the FM Band press the AM/FM button.
To store stations in the memory press the MEM button and then press the Channel
button you want to store the Station in. There are 5 preset stations for both AM and
FM.
3