DeskMakers TeamWorx Installation Guide
LEVEL SPINE WALL
A. Locate the small holes approximately 3” from
the ground in each spine wall.
B. Using a 5/32 Allen wrench, adjust the glides so
that the wall sections are of even height.
ATTACH SPINE WALL TO
WORKSURFACES
A. Use 12” L-brackets, 8” cantilever brackets, or
12” cantilever brackets. (These items should
appear on your packing list or P.O.)
B. Always install brackets first to worksurfaces,
then to walls.
C. To enhance spine wall stability, place 12”
brackets so that they straddle the wall’s seams.
D. Some applications require attachment of cargo
hubs to the spine wall by drilling a screw
through the back panel of the cargo hub and
into the wall.
INSTALL PRIVACY PANELS
A. Attach the steel clips onto the worksurface or
on top of a spine wall.
For laminate or glass privacy panels,
use the two-piece 2”x 2” steel clips.
For acrylic privacy panels, use the one-
piece 1-5/8”W x 3/4”H steel clips.
See drawing for panel placement.
B. Align the privacy panel so that it is seated snugly
in the clip.
C. Tighten the clip using a Phillips screwdriver (for
2”x 2” two-piece clips) or an Allen wrench (for 1-
5/8” x 3/4” clips.
