DTC INST 158 – 18.4.11 ISSUE 2
General Details
General DetailsGeneral Details
General Details
The urchased roduct is a thermostatic sequential ex osed shower valve.
The shower has a single lever which allows both control of tem erature and flow.
The cold water is obtained by turning the lever from the OFF osition anti-clockwise.
(NOTE: The tem erature of the cold water de ends on the system and the re-set
tem erature of the shower).
By turning the lever both flow and tem erature will increase.
The maximum tem erature has been re-set under factory conditions at a rox 45°c,
this can be adjusted by following the instructions shown in the section headed
“CALIBRATION”
Subject to correct installation, this mixer is suitable for any water system, in case of
instantaneous heaters, hot water flow must meet at last the minimum flow required by
the heater.
Technical D
Technical DTechnical D
Technical Data
ataata
ata
The water su lies are connected to the mixer via two elbows, which include
com ression nuts and olives to suit 15mm su ly i es.
The tem erature setting has been carried out under factory conditions and in
accordance with BS EN1111.
The shower will be received with the outlet to the bottom and the hot inlet (red sticker)
to the left), if you require a to outlet, do not sim ly turn the valve over, you must
change the location of the blanking lug and outlet.
Remove the blanking lug using a wide blade screw driver and remove the outlet using
a 12mm allen key.
Once removed swa the lug and outlet and re-fit and tighten fully
.
Cleaning or re lacing cartridge
Cleaning or re lacing cartridgeCleaning or re lacing cartridge
Cleaning or re lacing cartridge
Using a 30mm s anner unscrew the cartridge and flange (1) from the valve (2) by
turning anti-clockwise.
To clean the filters (1) of cartridge (2) kee arts 1,2 & 3 together and run under
warm water or soak in vinegar or de-scaling agent, then rinser thoroughly and
re lace.
To re lace cartridge, unscrew lower section of (2) from flange (3) by turning
anti-clockwise.
