Diamond DCS9 Manuale utente
Mod: DCS9
Production code: TT820BE
04/2013
ASSEMBLY INSTRUCTIONS
Page 1
TABLE OF CONTENTS
Chapter 1 ASSEMBLING THE
DETERGENT DISPENSER
Chapter 2 ASSEMBLING THE ADDITIONAL RINSING PUMP
Chapter 3 ASSEMBLING THE DRAINING PUMP
Chapter. 4 DISCHARGE PUMP FITTING INSTRUCTIONS ON B 270 AND MODELS
WITHELECTROMECHANICAL CONTROLS
page 2
page 5
page 9
page 12
Page 2
ASSEMBLY INSTRUCTIONS
CHAPTER 1 ASSEMBLING THE DETERGENT DISPENSER
Assembling should be performed by skilled personnel
OPERATIONS:
1. Disconnect the power supply (through the wall
switch) before performing any operation.
2. Remove the machine front panel by removing
the two fastening screws “A” on the frame in the
lower side of the machine.
3. Insert the detergent inlet junction by removing
the rubber plug into the special hole in the tank,
on the left side.
1
2
3
A
ASSEMBLY INSTRUCTIONS
Page 3
4. Fasten the measuring device on the front frame,
using the special holes and fastening screws.
5. Connect the junction to the measuring device
through the supplied piping using the special
clamps.
6. Connect the measuring device to the supply
mains using the supplied cables close to the
same device. Follow the instructions shown on
the attached wiring diagram.
7. TESTING:
Check that the measuring device starts at the
first tank filling and any time the machine
supplements the water into the boiler, that is, at
any rinsing.
Note: for adjustments, follow the instructions in
the user manual at chapter “Adjustments and
checks”.
4
5
6
Page 4
ASSEMBLY INSTRUCTIONS
Component Q.ty
Technical features of the kit components
01
Timed peristaltic batcher device, 230V 50/60 Hz.
01
Stainless steel union elbow (with nut and washer).
02
4MAx16 stainless steel screw.
02
M4 self-locking nut.
02
Clamp.
ASSEMBLY INSTRUCTIONS
Page 5
CHAPTER 2 ASSEMBLING THE ADDITIONAL RINSING PUMP
Assembling should be performed by skilled personnel
OPERATIONS:
1. Disconnect the power supply (through the wall
switch) before performing any operation
2. Remove the right side panel of the machine by
removing the two fastening screws “A” on the
frame in the lower side of the machine.
3. Fasten the motor pump to the bottom of the
machine using the special holes and fastening
screws.
1
2
A
3
Page 6
ASSEMBLY INSTRUCTIONS
4. Remove the outlet piping from the solenoid valve
(by removing the check clamp) and attach it in
outlet from the motor pump.
5. Fasten the stub pipe (supplied) between the
solenoid valve and the motor pump inlet by
clamping it with the clamps (supplied) and
perfectly tightening it.
6. Connect the motor pump to the supply mains
using the supplied cables (close to the motor
pump). Follow the instructions shown on the
attached wiring diagram.
Red and Black
4
5
6
EXIT
ENTER
ASSEMBLY INSTRUCTIONS
Page 7
7. Fasten the condenser (by lifting the tab on the
machine bottom side) by inserting the condenser
screw into the special hole, and tighten it with the
supplied nut.
8. Implement the electrical connections between
condenser and motor pump. Note: (The motor pump
connection terminals are designed to prevent
inverting the winding connections).
9. TESTING:
Check that there is no leak in the hydraulic
connections (check to be performed during the motor
pump operation).
The motor pump should start at the machine filling
and any time the machine supplements water into the
boiler (that is, at any rinsing) .
Green & White
7
8
Page 8
ASSEMBLY INSTRUCTIONS
Component Q.ty
Technical features of the kit components
01
Peripheral motor pump, 230V 50Hz. 460w
01
Rubber pipe, 12x19.5 mm
03
12-22 band clamp
01
6Ma x 10 stainless steel screw
01
6MA self-locking nut
01
10µF condenser.
Questo manuale è adatto per i seguenti modelli
1
Indice
Lingue:
Altri manuali Diamond Lavastoviglie
Diamond
Diamond DK7/6 Manuale utente
Diamond
Diamond 046D-NP Manuale utente
Diamond
Diamond 046D/6 Manuale utente
Diamond
Diamond Diverso WR-LB40-MPSC Manuale utente
Diamond
Diamond DC402/6 Istruzioni per il montaggio
Diamond
Diamond D117E/7 Manuale utente
Diamond
Diamond T101BE23DN Manuale utente
Diamond
Diamond DC402/6-A Manuale utente
Diamond
Diamond DC202/6R Manuale utente
Diamond
Diamond Diverso WR-LV50-MC Manuale utente
