Digicom Michelangelo LAN C Manuale utente
http://www.digicom.it
Full rate 8Mbit/s ADSL support
G.lite 1Mbit/s ADSL support
Configuration utility
Software upgrade
User's Guide
rev. 1.0 del 10/2002
MICHELANGELO USB C
MICHELANGELO USB C
Index
I
INDEX
PREFACE II
ENVIROMENTAL CONDITIONS II
CLEANING THE TERMINAL II
VIBRATIONS OR DROPPING II
WARNING: THIS IS A CLASS B PRODUCT. II
DECLARATION CE OF CONFORMITY II
1. GENERALITY 1.1
1.1. PRODUCT FEATURES 1.1
1.2. THE FRONT PANEL 1.2
1.3. REAR PANEL 1.2
2. HARDWARE INSTALLATION 2.1
3. SOFTWARE INSTALLATION
(WINDOWS® 98SE, ME, 2000 E XP) 3.1
4. VERIFY AND CHANGE THE CONFIGURATION 4.1
4.1. ADSL CONNECTION (PPPOA-PPPOE) 4.3
5. UNINSTALL 4.1
II
MICHELANGELO USB C
Preface - Declaration CE of Conformity
PREFACE
All rights reserved; no part of this publication may be reproduced, stored in a retrieval system, or trasmitted in
any form or by any means, electronic, otherwise, without the priorwritten permission of Digicom S.p.A. The
contents of this booklet may be modified without prior permission. Every possible care has been taken in
testing and putting together all the documentation contained in this booklet, however Digicom can not take
any responsability brought by the use of this booklet.
The following installation rules should be respected in order to have the best working order of
the equipment and for the user’s safety.
ENVIROMENTAL CONDITIONS
ENVIROMENTAL TEMPERATURE RELATIVE HUMIDITY
from -5 to +45
°
Cfrom 20 to 80% n.c.
Rapid changes of temperature or humidity should be avoided (0,03
°
C/min).
This equipment, including cables, should be installed in an area free from:
Dust, humidity, heat from direct sun light.
Objects which irradiate heat.These could cause damage to the container or other problems.
Objects which produce a strong electtromagnetic field (loudspeakers, etc.)
Liquids or chemical corrosive substances.
CLEANING THE TERMINAL
Use a clean and soft cloth. Wet the cloth with water or natural detergent if it is necessary to
remove any stains. Never use chemical products such as petrol or solvents.
VIBRATIONS OR DROPPING
Caution against vibrations and dropping.
WARNING:
THIS IS A CLASS B PRODUCT.
DECLARATION OF CONFORMITY
We, Digicom S.p.A. registered office at: via Volta 39 - 21010 Cardano al Campo (Varese -
Italy) declare under our sole responsability that the product:
Name: MICHELANGELO USB C Category: Information Technology Equipment, satisfies the
basic requirement of the below indicated Directive:
1999/5/CE
of March 9 1999, R&TTE as having been designed in conformity with the
requirements of following Reference Standards:
- EN 55022
- EN 55024
- EN 61000-4-2 , EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6
MICHELANGELO USB C
Generality
1.1
1. GENERALITY
Asymmetric Digital Subscriber Line
(ADSL) technology provides high-
speed data access over regular
phone lines. ADSL service is able to
co-exist on the same line with your
telephone service.
The ADSL has an unbalanced
connection speed.
It means that you have a connection
where data are received at the
maximum speed of 8Mbps and sent at the maximum speed of 1Mbps. The unbalance allows
to carry out connections with top performance in Internet access or remote access applications.
Asymmetric operation is ideal for home and small office use where files and information are
downloaded more frequently than uploaded.
ADSL modems employ ATM (Asynchronous Transfer Mode) framing. ATM is a protocol that
divides packets into small fixed sized cells for rapid transmission over high-speed networks.
Several different protocols are used over ATM. Michelangelo configuration depends on the
equipment used by your service provider:
Point to Point Protocol Over ATM (PPPoA)
Bridged/Routed Ethernet/IP over ATM (PPPoE)
1.1. PRODUCT FEATURES
ADSL modem for PCI Bus
Asymmetric data speed
Downstream up to 8Mbps
Upstream up to 1Mbps
8 Mbps full rate ADSL support
1.5 Mbps G.Lite ADSL support
PC interface: PCI compliant with 2.2 specifications
ADSL interface: RJ11 connector
ADSL standards : ANSI T1.413, ITU G.992.1 (G.dmt) e ITUG.992.2 (G.lite)
RFC Supported:
RFC1483 (Bridged/Routed Ethernet/IP over ATM)
RFC2516 (PPP over Ethernet)
RFC2364 (Point to Point Protocol Over ATM)
1.2
MICHELANGELO USB C
Generality
Windows® Plug&Play
Flash upgradable
CE mark
Driver for Windows® 98SE/2000/ME/XP
1.2. THE FRONT PANEL
The following table explains the functions of the LEDs on the
Front Panel:
Name Color Status Meaning
Power Red Flashing Power on
Off Power off
Data Yellow Flashing Data is under transferring
Off Data is not under transferring
Link Green Flashing ADSL line is connected
Off Line link off
1.3. REAR PANEL
MICHELANGELO USB C
Hardware Installation
2.1
2. HARDWARE INSTALLATION
Remove Michelangelo USB from its package
and check its integrity.
During the software installation, you will be
asked to connect the modem to your computer
USB port.
If you have any problems identifying
the USB socket on your Computer,
refer to the User’s Manual of your PC.
Connect the telephone cable to the
ADSL line.
USB
MICHELANGELO USB C
Software Installation
3.1
3. SOFTWARE INSTALLATION
(WINDOWS® 98SE, ME, 2000 E XP)
For a right installation you have to perform the configuration utility. This will
automatically install the right driver with your provider configuration.
Before connecting the modem, you have to perform a Setup.exe file, present in the Driver\
Michelangelo USB C folder in the CdROM.
In the “Install the DSL Device” Windows click on the “Next>” button.
3.2
MICHELANGELO USB C
Software Installation
You have to select the right configuration. Ask your Provider for the profile to be used.
Name Protocol Default
EoA Bridged IP over ATM LLCSNAP (RFC1483)
Routed IP over ATM LLCSNAP (RFC1483)
Bridged IP over ATM VCMUX (RFC1483)
Routed IP over ATM VCMUX (RFC1483)
Classical IP over ATM (RFC1483)
PPPoA PPPoATM VCMUX (RFC2364)
PPPoATM LLC (RFC2364)
PPPoE PPPoEthernet VCMUX (RFC2516)
PPPoEthernet LLCSNAP (RFC2516)
PPPoE PPPoATM VCMUX (RFC2364)
PPPoATM LLC (RFC2364)
PPPoE PPPoEthernet VCMUX (RFC2516)
PPPoEthernet LLCSNAP (RFC2516)
The installation will install the default protocol. In order to change the protocol refer to chapter
4. VERIFY AND CHANGE THE CONFIGURATION.
Click on the “Next” button to continue the installation.
Indice
Altri manuali Digicom Modem
Digicom
Digicom Pocket GPRS Power Manuale utente
Digicom
Digicom Michelangelo Gateway Manuale utente
Digicom
Digicom Palladio USB Bluetooth Manuale utente
Digicom
Digicom Palladio USB Bluetooth Manuale utente
Digicom
Digicom HSDPA Manuale utente
Digicom
Digicom SNM15 Manuale utente
Digicom
Digicom Michelangelo Gateway Manuale utente
Digicom
Digicom HDSL Manuale utente
Digicom
Digicom Donatello Memory ISDN Modem Manuale utente
Digicom
Digicom LCM16P Manuale utente
Digicom
Digicom Tintoretto Manuale utente
Digicom
Digicom Tiziano 56 Memory Manuale utente
Digicom
Digicom LCM16P Manuale utente
Digicom
Digicom SNM50 Manuale utente
Digicom
Digicom Michaelangelo USB ADSL/HDSL Modem Manuale utente
Digicom
Digicom pocket GSM Manuale utente
Digicom
Digicom MTL01 Manuale utente
Digicom
Digicom Pocket GPRS Micro Industrial Manuale utente
Digicom
Digicom Michelangelo Gateway Manuale utente
Digicom
Digicom Gsm Bulk DCS1800 Manuale utente
