Digital Equipment SA106 Manuale tecnico



SA106/TA867 Storage Subsystem

User and Installation Guide

EK–SA106–IM–001

Digital Equipment Corporation

First Edition, August 1992

The information in this document is subject to change without notice and should not

be construed as a commitment by Digital Equipment Corporation. Digital Equipment

Corporation assumes no responsibility for any errors that may appear in this document.

Printed in U.S.A.

FCC NOTICE: The equipment described in this manual generates, uses, and may emit

radio frequency energy. The equipment has been type tested and found to comply with

the limits for a class A computing device pursuant to Part 15 of FCC Rules, which are

designed to provide reasonable protection against such radio frequency interference when

operated in a commercial environment. Operation of this equipment in a residential area

may cause interference, in which case the user at his own expense may be required to

take measures to correct the interference.

The following are trademarks of Digital Equipment Corporation: CompacTape, TK, TZ,

VAX, VMS, and the DIGITAL logo.

Contents

Preface v

1 User Information

1.1 Introduction...................................... 1–1

1.2 Speciﬁcations..................................... 1–3

1.3 Related Documentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–3

2 Physical Installation

2.1 SitePlanning..................................... 2–1

2.1.1 Space Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–1

2.1.2 Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–1

2.1.3 Environmental Requirements . . . . . . . . . . . . . . . . . . . . . . 2–1

2.1.4 STI Interconnect Cabling . . . . . . . . . . . . . . . . . . . . . . . . . . 2–2

2.1.5 STICables..................................... 2–2

3 Acceptance Testing

3.1 Power-on Self-test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3–1

3.2 Diagnostics....................................... 3–1

4 Operation

4.1 Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–1

Figures

1–1 SA106 Storage Subsystem . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–2

2–1 SA106RearView.................................. 2–4

4–1 SA106 and TA867 Controls and Indicators . . . . . . . . . . . . . . 4–3

iii

iv Contents

Tables

1–1 Speciﬁcations..................................... 1–3

2–1 STI Interconnect Cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–3

4–1 SA106 and TA867 Controls and Indicators . . . . . . . . . . . . . . 4–2

Preface

This manual includes four chapters that provide the following information

about the SA106-AA/AB and TA867-AA/AB Storage Subsystem.

• User Information

• Physical Installation

• Acceptance Testing

• Operation

UserInformation

1.1 Introduction

The SA106 storage subsystem (Figure 1–1):

• Can be added to any installation that uses conventional ac power

• Does not require any special site preparation

The SA106 storage subsystem contains two compartments:

• Upper compartment with one factory installed magazine tape

subsystem

• Lower compartment with the SCSI/STI adapter assembly

The TA867 Kit is installed in an existing cabinet. See the installation

instructions in the TA867 Kit for information.

The TA867 storage subsystem includes:

• Magazine tape subsystem

• SCSI/STI adapter assembly

• Mounting hardware kit

1–1

1–2 User Information

Figure 1–1 SA106 Storage Subsystem

SHR-X0177_91-DG

User Information 1–3

1.2 Speciﬁcations

Table 1–1 lists the speciﬁcations of the SA106/TA867 storage subsystem.

Table 1–1 Speciﬁcations

Characteristic SA106/TA867 Storage Subsystem

Data backup

capacity 42.0 GB

Performance 800 KB/s sustained data rate

Power requirements 100-120/220-240 Vac (50/60 Hz)

Weight 86.184 kg (190 lb) (SA106 only)

Height 71.12 cm (28 in) (SA106 only)

Width 43.18 cm (17 in) (SA106 only)

Length 86.36 cm (34 in) (SA106 only)

Communications

interface STI bus

Environmental

standard (operating) 10°C to 40°C

20 to 80% RH

Environmental

standard

(nonoperating)

–40°C to 66°C

10 to 90% RH

EMI certiﬁcation Meets applicable FCC standards for Class A devices

Safety certiﬁcation Meets UL, CSA, and IEC standards

Power consumption 175 W

1.3 Related Documentation

See the Tx867 Series Magazine Tape Subsystem Owner’s Manual (EK–

TX867–OM) for information on the magazine tape subsystem contained in

the SA106 subsystem.

PhysicalInstallation

2.1 Site Planning

Follow the requirements in this section to prepare a site for the SA106

and TA867 subsystems.

2.1.1 Space Requirements

Leave enough space to remove the magazine tape subsystem from the

front of the cabinet (about 1 meter). Also leave enough space to remove

the SCSI/STI adapter assembly from the rear of the cabinet (about 1

meter).

2.1.2 Power Requirements

The subsystem can operate from 100 to 120 Vac at 60 Hz, or from 220 to

240 Vac at 50 Hz.

2.1.3 Environmental Requirements

The SA106 and TA867 conform to a modiﬁed class A environment (general

ofﬁces and workstations).

• When the SA106 and TA867 are operating, the temperature should

range from 10°C to 40°C with relative humidity of 20 to 80%

noncondensing

• When the SA106 and TA867 are not operating, the temperature

should range from –40°C to 66°C with relative humidity of 10 to 90%

2–1

2–2 Physical Installation

2.1.4 STI Interconnect Cabling

1. Connect the STI cable(s) to the rear of the SA106 chassis (Figure 2–1).

Each cable is secured with two captive screws. For cabling of the

TA867, see the documentation in the TA867 Kit.

2. Connect the HSC cable(s) to the K.SI module.

NOTE

K.STI modules do not support the SA106 and TA867 storage

subsystems.

3. Assign a unique unit number to the magazine tape subsystem. The

unit number is a decimal number between 0 and 255. To assign the

unit number, use the push buttons on the side of the unit number

switch to increase or decrease the number.

Transport numbers are always assigned in groups of four to each

formatter. Transports are assigned the following unit numbers:

• 0 to 3 for the ﬁrst formatter

• 4 to 7 on the second formatter of a system with two or more

formatters

• 8 to 11 on the third formatter, and so on

4. Place a decal identifying the transport unit number just below the

loader fault indicator on the magazine tape subsystem .

2.1.5 STI Cables

The SA106 storage subsystem will contain one, 25-foot STI cable. You will

need a second cable for dual applications.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Digital Equipment Magazzinaggio

Digital Equipment

Digital Equipment TU58 DECtape II Manuale utente

Digital Equipment

Digital Equipment SWXTA-AA 2-GB Manuale utente

Digital Equipment

Digital Equipment SZ106 Manuale

Digital Equipment

Digital Equipment SA100 Manuale utente

Digital Equipment

Digital Equipment RK06 Manuale utente

Digital Equipment

Digital Equipment RL01 Manuale utente

Digital Equipment

Digital Equipment EK-SWRA2-IG Manuale dell'operatore

Digital Equipment

Digital Equipment TLZ09 Manuale utente

Digital Equipment

Digital Equipment ESE50 SDI Manuale utente

Digital Equipment

Digital Equipment TK50 Manuale utente

Digital Equipment

Digital Equipment RA81 Manuale utente

Digital Equipment

Digital Equipment Storage Works Manuale utente

Digital Equipment

Digital Equipment EF5XX-Series Manuale utente

Digital Equipment

Digital Equipment TSZ07 Istruzioni operative

Digital Equipment

Digital Equipment RZ-series Manuale utente

Digital Equipment

Digital Equipment TLZ06 Manuale utente

Digital Equipment

Digital Equipment StorageWorks ESA10000 Manuale utente

Digital Equipment

Digital Equipment TZS20 Series Manuale utente

Digital Equipment

Digital Equipment RK05 Series Manuale utente

Digital Equipment

Digital Equipment TU56 Manuale utente

Digital Equipment

Digital Equipment DECTAPE DUAL TRANSPORT 555 Manuale utente

Digital Equipment

Digital Equipment RZ26 Manuale utente

Digital Equipment

Digital Equipment RA70 Manuale utente

Digital Equipment

Digital Equipment CELEBRIS XL 590 Manuale utente

Manuali Magazzinaggio popolari di altre marche

QNAP

QNAP TS 32PXU Series Manuale utente

LaCie

LaCie RUGGED RAID Manuale utente

Freecom

Freecom CLS DOCK Manuale utente

PNY

PNY Attache P-FD64MBATT3 Manuale utente

HP StorageWorks MSL2024 Manuale utente

OLT

OLT 6x6 Maximizer Manuale utente

Transcend

Transcend JetFlash 160 Manuale utente

LaCie

LaCie RUGGED MINI Manuale utente

Thunderbolt

Thunderbolt 600 Manuale utente

Panasonic

Panasonic LB-DH8 series Manuale

Intel

Intel RAID High Availability Manuale utente

LaCie

LaCie 12big Thunderbolt 3 Manuale utente

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuale utente

Panasonic

Panasonic LKM-F931-1 Manuale utente

Tabernus

Tabernus Enterprise Erase E2400 Manuale utente

Rocstor

Rocstor COMMANDER 3F series Manuale utente

HP P9000 Manuale utente

Western Digital

Western Digital Ultrastar Data60 Manuale utente