© 2020 Digitrax, Inc. www.digitrax.com— 2 —
To Join Your Throttle to the layout Duplex Group
1.
2.
-
nel and Key number.
3. When this throttle disconnects it will change to Duplex wireless radio opera-
tions and perform most tasks as if it were plugged in to the LocoNet system.
4. Use the e.g. DT602D throttle to select one of the locomotives on your system.
will do a short wink OFF very about 2 seconds to indicate it has an active
settings.
5.
communication problem. This usually indicates a range or interference issue.
6.
-
range.
This ‘tethered’ LocoNet method of joining the UR93 or layout Duplex Group
will always work to join any Duplex throttle to a particular Duplex Group. This
method bypasses the need to know the Key number if it is not 0000, and active.
Alternatively, you can also join in wireless mode! See the DT602 manual for
instructions on; joining a Group without plugging in, and changing Duplex
settings.
Troubleshooting Your Installation
coverage and reliability.
-
tion.
with UR93 location will usually help you locate a position that is best for your
layout and allow reliable operations.
coverage overlap and signal reliability.
-
ers may cause interference on one or more of the Duplex channels 11 to 25. Try
