Dimplex DLGM29 Manuale utente
Owner’s Manual
Model
DLGM29
7212240100R02
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use the log grate. For your safety, always
comply with all warnings and safety instructions contained in this
manual to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
2 www.dimplex.com
Table of Contents
Always use a qualied technician
or service agency to repair
this Log Grate.
!NOTE: Procedures and
techniques that are considered
important enough to
emphasize.
CAUTION: Procedures and
techniques which, if not
carefully followed, will result in
damage to the equipment.
WARNING: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of re,
serious injury, or death.
Welcome & Congratulations....................3
IMPORTANT INSTRUCTIONS ..................4
Site Selection and Preparation ..................7
Log Grate Assembly ..........................9
Log Grate Installation ........................14
Operation..................................15
Maintenance...............................17
Warranty .................................18
ReplacementParts..........................20
3
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an Log Grate
from Dimplex, the world leader in electric replaces.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result in a
possible electric shock, re hazard and will void the warranty.
Please record your model and serial numbers below for future
reference: model and serial numbers can be found on the Model and
Serial Number Label of your Log Grate.
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at: www.dimplex.com/customer_support
For Troubleshooting and Technical Support
OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST
Please have your model number and product serial
number ready. (See above)
Model Number
Serial Number
4 www.dimplex.com
When using electrical appliances,
basic precautions should always
be followed to reduce the risk of
fire, electric shock, and injury to
persons, including the following:
①Read all instructions before
using the Log Grate.
② Always unplug the Log Grate
when not in use.
③ Do not operate any unit with
a damaged cord or plug, or if the
Log Grate has been dropped or
damaged in any manner. Return
unit to authorized service facility
for examination, electrical or
mechanical adjustment, or repair.
④ Do not use outdoors.
⑤ The Log Grate is not intended
for use in bathrooms, laundry
areas and similar indoor
locations. Never locate unit where
it may fall into a bathtub or other
water container.
⑥ Do not run the cord under
carpeting. Do not cover cord with
throw rugs, runners, or the like.
Arrange cord away from trafc
area and where it will not be
tripped over.
⑦ To disconnect the unit, turn the
controls off, then remove the plug
IMPORTANT INSTRUCTIONS
from the outlet.
⑧ Do not block air intake or
exhaust in any manner.
⑨ Do not use on soft surfaces,
like a bed.
⑩ Do not modify the Log Grate.
Use it only as described in
this manual. Any other use
not recommended by the
manufacturer may cause re,
electric shock or injury to persons.
⑪ Do not burn wood or other
materials in the Log Grate.
⑫ Always use a certied
electrician should new circuits or
outlets be required.
⑬ Always use properly grounded,
fused and polarized outlets.
⑭ Disconnect the power supply
before performing any cleaning,
maintenance or relocation of the
unit.
⑮ When transporting or storing
the unit and cord, keep in a
dry place, free from excessive
vibration and store so as to avoid
damage.
⑯ The Log Grate must not be
located directly below a socket
outlet.
5
SAVE THESE INSTRUCTIONS
⑰ The Log Grate must be
positioned so that the plug is
accessible.
WARNING: Remote control
contains small batteries.
Keep away from children. If
swallowed, seek medical attention
immediately.
WARNING: Do not install
battery backwards, charge, put
in re or mix with used or other
battery types - may explode or
leak causing injury.
!NOTE: Changes or
modications not expressly
approved by the party responsible
for compliance could void
user's authority to operate the
equipment.
IMPORTANT INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
6 www.dimplex.com
CAUTION: This equipment has
been tested and found to comply with
the limits for Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
Reorient or relocate the receiving•
antenna.
Increase the separation between•
the equipment and the receiver.
Connect the equipment into an•
outlet on a circuit different from
that to which the receiver is
connected.
Consult the dealer or an•
experienced radio/TV technician
for help.
Operation is subject to the following
two conditions: (1) this device may
not cause interference and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
IMPORTANT INSTRUCTIONS
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of re, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to reduce
the risk of re, electric shock and
injury to persons.
Do not attempt to wire your own
new outlets or circuits. To reduce
the risk of re, electric shock or
injury to persons, always use a
licensed electrician.
7
Site Selection and Preparation
This section provides instructions
for selecting a location and
preparing the site to install the
Log Grate.
Select a suitable location1.
that ensures the Log Grate is
sitting on a hard level surface
for optimum ame effect.
Allow for approximately 2"2.
(5.1cm) of clearance behind
the unit (from the frame to
the back of mantel) and 7"
(17.8cm) directly above the
back log to allow for removal
of the Rell Container.
Carefully unpack all of the3.
components from the box.
1
3
2
4
5
6
7
CAUTION: Handle logs carefully,
they are fragile and can easily crack
or break, if dropped.
8 www.dimplex.com
Site Selection and Preparation
Figure 1
Transducer
Wire Slots
Emitter
Unpack the transducer4.
(contained within the water
reservoir) which has been
wrapped to protect it during
shipping. See Figure 1.
To access the transducer:
Remove top cover by turning•
the retaining tabs on both
ends of the water reservoir.
Remove any packing•
material.
Install transducer so that it•
is sitting level in the circular
holding area in the Reservoir.
Retaining
Tabs
Removable Rell
Container
Water
Reservoir
Orient transducer wire so that•
it does not sit directly above
the Emitter and the wire
passes through the slot in the
side of the tank.
Reinstall the top cover and•
ensure both retaining tabs
have been turned so that
they are pointing inwards.
!NOTE: Completely assemble
the unit before lling with water.
Top Cover
9
Log Grate Assembly
1
2
CAUTION: Handle logs
carefully, they are fragile and
can easily crack or break, if
dropped.
10 www.dimplex.com
Hook and
Loop Pads
Wire Connectors
3
Log Grate Assembly
Each log is a separate component
that needs to be placed on the
grate. Position each log so that
the hook and loop pad on the
backside of the log lines up with
the corresponding hook and loop
pad on the log grate. These pads
assist with securing the logs to
the grate.
!NOTE: Each of these logs
are hand made, and as such, the
hook and loop pads on the logs
and grate may not align perfectly,
therefore, we have included
additional pads should you need
to re-position them.
Each of the logs contain LED
lights to create a ickering effect.
During assembly, each log
requires the electrical connectors
on the log and grate to be
connected as they are being
placed. In some cases, these
wires can have tie wraps added to
prevent the wires from being seen
after nal assembly, not included.
Altri manuali per DLGM29
1
Indice
Altri manuali Dimplex Riscaldatore elettrico
Dimplex
Dimplex Adagio Fire ADG20 Manuale utente
Dimplex
Dimplex Danube DNB20 Manuale utente
Dimplex
Dimplex GDHRAD24FAN Manuale utente
Dimplex
Dimplex SP420 Manuale utente
Dimplex
Dimplex DLG1106 Manuale utente
Dimplex
Dimplex CUH05B31T Manuale utente
Dimplex
Dimplex Yeominster YEO20 Manuale di istruzioni
Dimplex
Dimplex CKHA Series Manuale utente
Dimplex
Dimplex 430 RCE/B Manuale utente
Dimplex
Dimplex DX 512E Manuale utente
Dimplex
Dimplex Alta Series Manuale utente
Dimplex
Dimplex BDG15-AU Manuale utente
Dimplex
Dimplex WW 101 E Manuale utente
Dimplex
Dimplex OFRC10TFN(B)(W) Manuale utente
Dimplex
Dimplex CDFI500-PRO Manuale utente
Dimplex
Dimplex Apollo APL100 Manuale utente
Dimplex
Dimplex ML2TA Manuale utente
Dimplex
Dimplex 316 CHE Manuale utente
Dimplex
Dimplex T60W Manuale utente
Dimplex
Dimplex VR15 Manuale utente
