Dimplex DHHDR3 Manuale utente
For domestic household use only.
INSTRUCTION MANUAL
3 Tier Aluminium Heated
Drying Rack
Model: DHHDR3
IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND
RETAINED FOR FUTURE REFERENCE.
Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE
INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY
Please read the operating instructions carefully before using your product
for the rst time and keep them in a safe place.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• Cleaning and user maintenance shall not be made by children.
• CAUTION: Some parts of this product can become very hot and cause
burns. Particular attention must be given where children and vulnerable
people are present.
• Only allow to install at the distance of atleast 0.6m from bath and shower
• DO NOT use if there are visible signs of damage to the heated drying rack.
• DO NOT place the Drying Rack directly below a xed socket outlet.
• The socket-outlet used to plug in the Drying Rack must be accessible
at all times to enable the mains plug to be disconnected as quickly as
possible if required.
• WARNING: Risk of re – Do not use this appliance connected through an
extension lead or any external switching device such as a plug-in timer or
remote control plug in adaptor. All heating appliances draw high current
through the mains supply and any weakness in the design, connections
or components in these devices can easily result in overheating of the
connection points resulting in melting, distortion and even the risk of re.
• DO NOT pull, lift, carry or move the appliance using the mains lead.
• IMPORTANT: If the mains lead of this appliance is damaged, it must be
replaced by the manufacturer or its service agent or a similarly qualied
person in order to avoid a hazard.
• In the event of a fault, unplug the appliance.
• Unplug the appliance when not required for long periods.
• This product is only intended for INDOOR RESIDENTIAL applications. DO
NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
2
• DO NOT route cord under furniture or appliances. Take care to position the
cord away from trafc areas and where it will not be a tripping hazard.
• DO NOT operate the Drying Rack in an area with gasoline, paint or ammable
liquids may come into contact.
• DO NOT insert or allow foreign objects to enter any openings in the Drying
Rack, as this may cause an electric shock, re or damage to the Drying
Rack.
• DO NOT use this product outdoors.
• WARNING:
Use the Drying Rack only as described in this manual. Any other
use is not recommended by the manufacturer and may lead to damage or
hazards.
• WARNING: This instruction leaet belongs to the appliance and must be
kept in a safe place. If changing owners, the leaet must be surrendered to
the new owner.
3
Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
On a slope or
uneven surface
Where it may be
damaged by
chemicals
If there is a risk
of water falling on
the unit
Where there is a risk
of interference by
foreign objects
This product is not
made for DIY repair
4
For greater precision, please always refer to the rating label placed on the product.
Specications
Model no. DHHDR3
Power supply
220-240V ~ 50Hz
Rated power
300W
Temperature
50°C
Warm-up duration 10 minutes
Bearing capacity 15kg, each tier 5kg
IP Rating IP22
Weight (net) 4kg
Dimensions (w x d x h) 680 x 730 x 1430mm
5
Assembly
HOW TO ASSEMBLE THE HEATED DRYING
RACK:
Note: For rst time use, cut the ribbons
attached to the columns of the Heated Drying
Rack
1. Place the Heated Drying Rack on a dry level
surface near an electrical socket, with plenty
of space surrounding the Heated Drying
Rack.
2. Open out the supports to a 90° angle.
3. Slide all the shelf support clips (found on the
two thinner supports), until they are facing
straight out.
4. Stand at the side of the Heated Drying Rack
that has the on/off switch and open out the
shelves, starting with the BOTTOM shelf rst,
then the middle and then the top.
5. Now use the shelf support clips to secure the
shelf.
6
HOW TO OPERATE THE HEATED DRYING RACK:
Ensure the Heated Drying Rack is folded out securely before loading it with
laundry and switching it on.
1. Make sure your electricity supply matches the voltage shown on the ratings
label, then plug in the Heated Drying Rack.
2. Press the On/Off button on the control panel. When the Heated Drying Rack
is on, the red indicator light will turn on.
3. The Heated Drying Rack will warm up within 10 minutes.
4. Load clothes evenly across the surface to avoid the Heated Drying Rack
tipping over.
Clothes should be damp, not soaking wet. Wring out all excess water rst
before loading. Do not overload the Heated Drying Rack. The maximum load
of the Heated Drying Rack is 15kg.
5. When you have nished using the Heated Drying Rack, switch the unit
off by pressing the On/Off button again and unplug. Leave to cool down
completely.
6. To fold closed for storage purposes, start with the TOP shelf rst, then
middle then bottom. Proceed to fold the supports together so the Heated
Drying Rack is folded at.
Operation
7
Cleaning
Over time, dust can accumulate on the Heated Drying Rack which can effect
performance. It is recommended to clean the unit at least once a month.
1. Turn the Heated Drying Rack OFF and disconnect the appliance from the
power supply.
2. Remove any dust build up with a soft brush or vacuum cleaner with a soft
brush attachment.
3. Wipe the outer surface of the unit with a soft damp cloth. Mild detergent
can be used for any stubborn marks.
IMPORTANT
The ON/OFF switch and other parts must not come into contact with water or
any other liquids.
Storage
If the unit is not in use for an extended period of time, after cleaning please:
•
Ensure the Heated Drying Rack is OFF and remove plug from the power outlet.
• Cover the unit and store it upright in a location where it will not receive direct
sunlight. IMPORTANT NOTE: Prolonged exposure to direct sunlight will discolour
the unit.
8
If the unit fails to operate efciently, is broken or other problems arise, unplug
and do not operate. Ask for advice by calling your local after sales service
agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824
(NZ).
Maintenance
Recycling: Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities. Contact your
local government for information regarding the collection systems
available. If electrical appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground water, polluting the
food chain and damaging health and well-being.
Warranty
Please refer to the warranty card in the box for warranty information. For any
troubleshooting advice, please contact the relative Customer Care Centre below.
Glen Dimplex Australia Pty Ltd
8 Lakeview Drive,
Scoresby 3179, Victoria
Australia
Ph: 1300 556 816
Glen Dimplex New Zealand Ltd
38 Harris Road, East Tamaki,
Auckland 2013
New Zealand
Ph: 0800 666 2824
9
Notes
10
Indice
Altri manuali Dimplex Rack e supporto
