Directed 6867T Manuale per l'uso e la cura
© 2017 Directed, All rights reserved. N6867T--2017-11-30
1
Product Description
The 6867T control center is compatible with the following modules: DS4
and DS4+.
Mounting the Control Center
Note Once this replacement control center has been installed, all
remote controls must be paired with your system. See Remote
Pairing for details and follow the instructions for your remote
control type.
The control center’s position should be discussed with the vehicle owner
prior to installation since the antenna, with built-in status LED and Valet/
Program, must be visible/accessible to the customer.
The best position to locate the control center is centered high on the front
windshield. It can be mounted vertically or horizontally relative to the
windshield. Metallic window tint can also aect range negatively, so this
should be a consideration when determining the mounting location.
After you determine the best mounting location, follow these steps:
Clean the mounting area with a quality glass cleaner or alcohol to remove
any dirt or residue.
Plug the cable into the control center.
Mount the control center with double-sided tape.
Route the cable down the window pillar to the control module and plug
the cable in the control module.
CONTROL CENTER
CABLE
CONTROL
MODULE
Remote Pairing
Prepare the vehicle system to be Paired with a new remote
1. Open at least one vehicle door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Control button on the Control
Center one time.
4. Within 5 seconds, press and hold the Control button on the Control
Center. The status LED begins flashing in single flash sequence and
the siren/horn sounds once to confirm the system is ready for remote
pairing. Release the button.
5. Locateyour remote control model below andfollow the instructions.
System Pairing will exit if:
• The ignition is turned o
• The open door is closed
• 60 seconds lapses with no actions
Note
:Make sure the remote to be paired with the system is set for the de-
sired Car 1 or Car 2 operation.
LCD Remote Control:
1. Press and hold the
AUX
button for 8 seconds, the remote beeps once,
Main Menu is displayed. Release the
AUX
button.
2. Press the AUX or
AUX
buttons until Pair is displayed.
3. Press and hold the
AUX
button until the remote beeps 3 times thenre-
lease the
AUX
button. The remote is now ready to pair with the system.
4. Press the
AUX
button.
5. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful
the siren/horn sounds and the remote emits several tones. The screen
displays if the Pairing is successful or failed with corresponding text. If
pairing fails repeat step 4.
To exit pairing mode on the remote:
• Press and release the
A U X
button.
•Wait 30 seconds without pressing a command button on the remote.
Responder LED or Companion Remote Control:
1. Pressand holdthe
AUX
button for 8 seconds. The transmit LED will come
on solid. Release the
AUX
button.
2. Press and hold the
AUX
until the transmit LED flashes 3 times then
comes on solid.
3. Press the
AUX
button.
4. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful
the siren/horn sounds and the 2-way remote emits several tones (the
companion remote does not generate tones). If pairing is not suc-
cessful press and release the
AUX
button once and then repeat steps
2 and 3.
To exit pairing mode on the remote:
• Press and release the
AUX
button once, thenpress and hold until the
transmit LED shuts o.
•Wait 30 seconds without pressing a command button on the remote
control.
6867T
Replacement
Digital Control Center
© 2017 Directed, All rights reserved. N6867T--2017-11-30
2
GOVERNMENT REGULATIONS
920-10012-01
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable
operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by
turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
To satisfy FCC RF exposure compliance requirements, the device and its antenna must maintain a separation distance of 20 cm
or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance.
WARNING! : Changes or modifications not expressly approved by Directed Inc. could void user's authority to operate the
equipment.
This device complies with Industry Canada licence-exempt RSS-247 standards. Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standards RSS-247. Son fonctionnement est soumis
aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d'interférences et
(2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.”
Health Canada RF Exposure Warning:
This device complies with Health Canada’s Safety Code. The installer of this device should ensure that RF radiation is not
emitted in excess of the Heath Canada’s requirement. The device must maintain a separation distance of 20cm or more from the
person’s body, except for the hands and wrists. Information can be obtained at:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-eng.php
Lignes Directrices de Santé Canada sur l’exposition aux radiofréquences:
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme d’installation de cet appareil doit s’assurer
que les rayonnements RF n’est pas émis au-delà des limites établies par Santé Canada. L’emplacement de l'appareil doit se
situer à une distance de 20cm ou plus par rapport au corps de la personne, à l’exception des mains et des poignets. Les
informations peuvent être obtenues à l’adresse Internet suivante:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-fra.php
LIMITED ONE YEAR CONSUMER WARRANTY
For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed
Electronics. (“DIRECTED”) prom -ises to the original purchaser, to repair or replace with a comparable reconditioned piece,
the security or remote start accessory piece (hereinafter the “Part”), which proves to be defective in workmanship or
material under normal use, provided the following conditions are met: the Part was purchased from an authorized
DIRECTED dealer; and the Part is returned to DIRECTED, postage prepaid, along with a clear, legible copy of the receipt
or bill of sale bearing the following information: consumer’s name, address, telephone number, the authorized licensed
dealer’s name and complete product and Part description.
This warranty is nontransferable and is automatically void if the Part has been modified or used in a manner contrary to its
intended purpose or the Part has been damaged by accident, unreasonable use, neglect, improper service, installation or
other causes not arising out of defect in materials or construction.
TO THE MAXIMUM EXTENT ALLOWED BY LAW, EXCEPT AS STATED ABOVE, ALL WARRANTIES, INCLUDING BUT
NOT LIMITED TO EXPRESS WARRANTY,
IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE AND
WARRANTY OF NONINFRINGEMENT OF INTELLECTUAL PROPERTY, ARE EXPRESSLY EXCLUDED; AND
DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON OR ENTITY TO ASSUME
FOR IT ANY DUTY, OBLIGATION OR LIABILITY IN CONNECTION WITH ITS PRODUCTS. DIRECTED HEREBY
DISCLAIMS AND HAS ABSOLUTELY
NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING DEALERS OR INSTALLERS. DIRECTED IS
NOT OFFERING A GUARANTEE OR INSURANCE AGAINST VANDALISM, DAMAGE, OR THEFT OF THE
AUTOMOBILE, ITS PARTS OR CONTENTS, AND DIRECTED HEREBY DISCLAIMS
ANY LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE, OR
VANDALISM. IN THE EVENT OF A CLAIM
OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY
IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND
GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY
CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE
PRICE OF THE PART. DIRECTED SHALL
NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY
CONSEQUENTIAL DAMAGES, INCIDENTAL
DAMAGES, DAMAGES FOR THE LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC
OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, THE MANUFACTURER DOES OFFER A LIMITED
WARRANTY TO REPLACE OR REPAIR AT DIRECTED’S OPTION
THE PART AS DESCRIBED ABOVE.
This warranty only covers Parts sold within the United States of America and Canada. Parts sold outside of the United
States of America or Canada are sold “AS-IS” and shall have NO WARRANTY, express or implied. Some states do not
allow limitations on how long an implied warranty will last or the exclusion or limitation of incidental or consequential
damages. This warranty gives you specific legal rights and you may also have other rights that vary from State to State.
DIRECTED does not and has not authorized any person or entity to create for it any other obligation, promise, duty or
obligation in connection with this Part. For further details relating to warranty information of Directed products, please visit
the support section of DIRECTED’s website at: www.directed.com
© 2017 Directed, All rights reserved. N6867T--2017-11-30
3920-10012-01
Altri manuali Directed Controllori
