DMX Channel Listing
Channel Value Description
1
(Red)
0 Red Off
1-255 Increasing Brightness
2
(Green)
0 Green Off
1-255 Increasing Brightness
3
(Blue)
0 Blue Off
1-255 Increasing Brightness
4 0-255 Master Dimmer (works with or without Channel 6 active)
5 0-255 Strobe at Increasing Frequency (0=Off)
6 0-255 Adjusts Speed of Channel 6 Features
7
Automatic
Programs
0-2 Channel Not Active
3-49 Strobe Mode (Adjust Speed with Channel 5)
50-100 Preset Colors (Adjust Color with Channel 5)
101-150 Slow Color Fades (Adjust Speed with Channel 5)
151-200 Quick Color Fades (Adjust Speed with Channel 5)
201-250 Color Cycles by Snapping (Adjust Speed with Channel 5)
251-255 Sound Active Mode: Colors Change to Sound
Setting Up DMX Connection with an E ternal Controller:
1. Connect the Hyper unit to a DMX Controller (not included) using an microphone
or data cable with XLR connectors. Multiple Hyper units may be connected by
daisy-chaining them together. (Note that XLR input and output jacks are wired in
parallel so that either may be used as input or output.)
2. Set the DMX Start Channel on the Hyper unit so that it is the same as the DMX
Start Channel on the lighting controller.
3. Adjust the DMX channels on the controller to manipulate the light as desired.
Typical DMX Operation:
1. Set Channel 4 (master dimmer) to maximun value.
2. Set Channels 1, 2, & 3 so that the desired color is achieved.
3. If strobing is desired, set Chanel 6 to 10 and adjust speed with Channel 5.
4. Set Channel 4 so that the desired overall brightness is achieved.
www.divinelighting.com 361 v2.1
