HEALTH & SAFETY
p hine Safety Regulations.
a system
re points of the source of energy directly earthed, the
t point by
nnected to
f the source.
ing no
rts of the
ected
her supply
replaced it
tions
rocedures
Failure to do so may invalidate warranty.
y be used for the purpose for which they
d and constructed. No parts may be used for
print head.
is powered
d present a
azard.
be in
nd non
d to all unused
connectors to protect against dust and dirt and possible static damage to internal
components.
Ensure all reasonable safety precautions have been undertaken. However, please ensure
that when working with / or around the machine, every care is taken to avoid
potential hazards. ALWAYS take great care around the machine not to slip, trip or fall;
especially if the machine is used in areas where the floor may be wet or greasy.
GENERAL SAFETY
The roduct is designed to conform to all current Mac
Note: Please read through this section before operating the machine.
This printer is designed for use with the following supply systems that conform to IEC
664 light industrial / domestic installation category II mains supply:
•‘TN’ (any of following - TN-C, TN-S or TN-C-S) for example;
having one or mo
exposed conductive parts of the installation being connected to tha
protective conductors.
•‘TT’ for example; a system having one point of the source of energy directly
earthed, the exposed conductive parts of the installation being co
earth electrodes electrically independent of the earth electrodes o
It is not suitable for connection to an ‘IT’ system for example; a system hav
direct connection between live parts and earth, the exposed conductive pa
installation being earthed. This therefore excludes any ‘phase to phase’ conn
supplies such as may be available in some factories and / or countries. If eit
fuse (located on the rear of the Controller, below the supply connector) is
must be replaced by a fuse 3.15/6.3AT - 230/115V – 50/60Hz - 300VA. Installation
must only be performed by qualified Domino personnel. For customer installa
authorisation must be obtained from Domino UK Ltd. All relevant Safety P
must be followed.
The printer and its component parts must onl
were sold, and for which they are designe
other functions.
Do not touch the printer or the controller with wet or damp hands.
Do not expose the printer or controller to rain.
Do not run the printer without ribbon material, as this may damage the
ALWAYS disconnect the power to the machine before removing any covers. You
must remove the plug from the mains power supply.
DO NOT insert body parts into the print head opening whilst the printer
as there is a danger that the mechanism will move without warning an
crushing h
DO NOT operate the machine with any covers removed. ALL covers must
place using the appropriate number of fasteners. It is essential that electrical a
electrical connector dust covers (provided with the machine) are fitte
27864 Issue 1January 2008 (9)
