Password Change Confirmation Screen
This screen appears when the user selects “Change Password” on the Court
/
Operation Selection Screen. The user should push “Yes” if they want to
change the password or “No” if they do not wish to change the password.
Enter New Password Screen
This screen appears after the user confirms they want to change the
password. User should press the CLEAR button, enter new four-digit
password then press the ENTER button. As new digits are entered they will
appear in the top right of the screen.
If user mistakenly presses an incorrect numeral they can press the CLEAR
button and start over.
Password Changed Screen
This screen appears after the users enters the new password. The new
password will be displayed in the center of the screen.
Press “Continue” to return to the Operation Selection Screen
Manually Operating Devices from Relay Panels
In the event of a control processor or interface failure, the Smart Gym allows
for emergency manual operation of devices for the relay panel.
•
This should only be used in the event of such failures and only when
absolutely necessary.
•
Ensure area around device to be operated is clear of people and
equipment.
•
If the equipment being operated is not visible from the relay box location
two or more people need to form a communication “chain” between the
point where the device is visible and the relay panel.
•
In Manual mode relays act in a maintained manner or like a simple on-
off switch. Only one device should be operated at a time and once the
device is in desired position, relay should be moved to off condition.
1.
Locate relay panel worksheet that tells you which devices are connected
to each relay. The appropriate worksheet should have left during initial
installation in or around each relay panel. If you are unable to locate the
necessary worksheets, contact Draper or your local Draper representative
for assistance.
2.
Remove the cover of the relay panel. Use extreme caution to avoid contact
with any of the wires connected to any of the relays to avoid injury from
shock.
3.
Locate the local control section on the right-hand side the GLXX-CTRL
module that is at the bottom middle of the relay panel.
4.
Depress the button marked ENABLED. Red LED next to button will
illuminate
5.
Use the buttons marked with up and down arrows to navigate to the relay
number that you want to operate. The relay number will be displayed by the
NET ID LED display.
6.
Make sure the area around the device to be operated is clear and that
someone who has clear view of device to be operated, has a clear chain of
communication to the person at the relay panel.
7.
Press the ON button and device will start to operate.
8.
Once device is in desired position press the off button.
9.
Continue to operate equipment until all items are in desired position then
depress the Enable button making sure adjacent LED is no longer illuminate
red.
Maintenance Schedule
Your Smart Gym Control System has been custom programmed to match your
specific needs, and designed to provide many years of trouble free service.
There are no owner serviceable or programmable components to the Smart
Gym Control System. If your system malfunctions, you should contact Draper
or your local Draper representative for assistance.
Touch Screens have glass faces and can break if not used properly. If
Glass breaks, discontinue use and contact Draper or your local Draper
representative
for assistance. Touch Screens can be cleaned with slightly damp cloth or lens
wipe like used to clean glasses or mobile phones.
RELAY
LOCAL CONTROL
ON
OFF
Toggles Local Control
On/Off
Toggles Selected Relay
On/Off
Use Up/Down Arrows
to Select Relay to Control
(NET ID will display relay number)
Red LED Illuminates
when local control
is enabled
ENABLE
page 3 of 4
503339 - 7" Graphic Touch Screen
503340 - 10.1" Graphic Touch Screen
