10/51
Set up a system
Join devices to the Heat HubR
Add a Room Thermostat
After you assign the Room Thermostat to a
room, such as a lounge, the Room Thermostat
must be joined to the Heat HubR as follows.
Insert the batteries and join the network
Insert the batteries into the Room
Thermostat.
Ensure the polarity of the batteries (+
and - ends) is correctly oriented. The
polarity is indicated on the device’s
terminals.
Close the battery compartments.
Place/Mount the Room Thermostat
The Wiser Heat app assigns this Room
Thermostat to the named room.
Place this Room Thermostat in the room, either
on the wall or on the provided desk stand.
Follow the messages on the Room
Thermostat’s display to join the network.
Press Oto initiate the connection.
No network found? The Heat HubRhas
timed out
If the Heat HubRsetup mode has timed out (the
LED shows a solid green), repeat the setup
step.
No network found? The Heat HubRis still in
setup mode
If the Heat HubRis still in setup mode (the LED
is ashing), the Room Thermostat is too far
away from the Heat HubR.
In this condition, choose another
location for the Room Thermostat or use an
RF Range Extender (contact Drayton Customer
Services).
Do you want to move the Room
Thermostat to another room?
Have a look here: Moving the Room
Thermostat -> page 42
