Dymo 1570 Manuale utente

DYMO 1570

Adjusting Space on Label Ends

For more blank spaces before and after messages: Turn the tape feeder (B) .

For less blank spaces: Turn the tape feeder (B) in reverse, emboss the message, turn feeder

forward, and cut.

To center a message: Advance completed label 3 spaces (5 space for 1530 Office Mate I)

Squeeze tape cutter.

Troubleshooting

Label shows letters instead of blank space: Squeeze handle half way until you hear a click,

then release.

Letters too light: Squeeze harder by holding the upper end of the handle.

Tape jam: In the unlikely event the tape does not feed properly, remove the tape wheel, discard

left over tape ends, and replace the wheel.

Preparing Problem Surfaces

Use non-residual solvents (i.e., alcohol, acetone) to clean oily or greasy surfaces. If the surface is

rough or porous, coat it with a sealer (i.e. shellac, lacquer). Once stuck, water will not affect the

label. Do not apply labels to surfaces exceeding 140 F.

1. Load Tape

Expose 3" of the tape, open the tape compartment (A), and insert so that ‘U’ shape opening in the

tape cartridge points down. Insert the tape into the feed slot and thread forward until visible.

Close the tape compartment to lock in the tape.

2. Advance Tape

By turning the feeder (B) or with several half-squeezes (squeeze until click sound is audible) of

the handle (F), advance the tape 1/4" past front of embosser.

3. Emboss Letters

Turn the wheel (E) until the desired letter aligns with selector. Squeeze the handle (F) firmly and

repeat for each letter. To space between words, half-squeeze handle until click is heard.

DO NOT HOLD WHEEL WHILE EMBOSSING.

4. Cut Tape

Squeeze the cutter (C) and remove excess tape from the end of the embosser.

5. Apply Label

Pull the end of the tab to strip the backing. Apply tape to a clean dry surface.

6. Change Wheel

Push wheel right to left and remove. Snap in the new wheel.

DO NOT SQUEEZE HANDLE WHILE CHANGING WHEEL.

Indice

Altri manuali Dymo Etichettatrice

Dymo

Dymo LabelPoint 150 Manuale utente

Dymo

Dymo RHINO 6000 Manuale utente

Dymo

Dymo LabelPOINT 100 Manuale utente

Dymo

Dymo LabelWriter DUO Manuale utente

Dymo

Dymo LetraTag XR Manuale utente

Dymo

Dymo Rhino 3000 Industrial Label Printer Manuale utente

Dymo

Dymo Rhino 5200 Manuale utente

Dymo

Dymo LP300 Manuale utente

Dymo

Dymo LabelMANAGER 150 Manuale utente

Dymo

Dymo RHINO 6000 Manuale utente

Dymo

Dymo M11 Manuale utente

Dymo

Dymo LabelPOINT 100 Manuale utente

Dymo

Dymo LabelPoint 250 Manuale utente

Dymo

Dymo LabelManager Series Manuale utente

Dymo

Dymo LabelWriter DUO Manuale utente

Dymo

Dymo LetraTag 100-H Manuale utente

Dymo

Dymo LetraTag Manuale utente

Dymo

Dymo LabelPOINT 350 Manuale utente

Dymo

Dymo 10199 Manuale utente

Dymo

Dymo LabelManager 210D Manuale utente

Dymo

Dymo 2000 Manuale utente

Dymo

Dymo Rhino 5200 Hard case Kit by Manuale utente

Dymo

Dymo RhinoPRO 3000 Manuale utente

Dymo

Dymo LabelPoint 250 Manuale utente

Manuali Etichettatrice popolari di altre marche

Brother

Brother P-Touch 2420PC Manuale utente

newell

newell Dymo LabelManager 210D Manuale utente

Brother

Brother TD-4000 Manuale utente

U-Line

U-Line BROTHER H-8754 Manuale utente

Tharo Systems

Tharo Systems H-435+ Manuale utente

Brother

Brother E300 Manuale utente

Godex

Godex RT700 SERIES Manuale utente

ID Technology

ID Technology 252 Manuale utente

Labelmate

Labelmate MC-11 Manuale utente

CAB

CAB XD4M/300 Manuale utente

Avery Dennison

Avery Dennison Pathfinder 6057 Manuale di servizio

Brother

Brother P-touch PT-9700PC Manuale utente

TSC

TSC PEX1000 Series Manuale utente

Adkins

Adkins Label Master Manuale utente

Epson

Epson LabelWorks LW-400 Manuale utente

Primera

Primera 510212 Manuale utente

Brady

Brady BradyPrinter S3100 Manuale utente

DuraLabel

DuraLabel LabPRO Manuale utente