User’s Manual
Please follow the steps as below:
1. Plug the receiver into PC USB port before using, the red indicator shines
means the connection between PC and receiver is OK.
2. Load the batteries to the mouse and click on the power switch then the optical
LED will be lightened.
3. Click the mouse ID setting button, its optical LED will be darkened and the
low power indicator (red color) will shine for once.
4. Click the receiver ID setting button, it will shine red slowly.
5. After ID setting of the mouse and receiver is finished, the red indicator of
receiver will be quickly shining and then stop shining which shows that the
connection between mouse and receiver is OK.
6. The red indicator of the receiver will shine while moving the mouse, and stop
shining if mouse not moving.
7. When the batteries carry low power (2.1V), the red low power indicator of the
mouse will shine.
8. After 8 minutes of not moving the mouse, its optical LED will be darkened (in
sleepmode).
9. Users should click the mouse buttons or scroll if tend to wake it up from the
sleep mode.
FCC Warning Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance will void the user’s authority to operate the equipment.
Any change to the equipment will void FCC grant.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
