Start motor
Stop motor
Start motor as per below, loosen rod immediately once the motor start rotation.
Pleased do not use the rod while flying, otherwise, the copter will stop working in the air.
Two methods to stop motor after starting.
1. While the copter landing on the ground, push the throttle rod to the lowest position pic 1, then
operate the rob as pic 2, the motor will be stopped immediately and then loosen the rod.
2. While the copter landing on the ground, push the throttle rod to the lowest position and stay 3s to
stop the motor.
Basic flight steps:
1. Keep the copter on the flat and wide ground, pilot should stand behind the copter.
2. Turn on remote control and copter smart battery.
3. Connect mobile device(monitor) with copter X230.
4. The copter can be safe flight while the green indicator light keep blinking. Start the motor with
operation rod.
5. Push up the throttle rod slowly to fly the copter steadily.
6. Adjust the camera tilt angle by adjustable slider.
7. Shooting by photo key and video key.
8. Pull down the throttle rod slowly to land on the ground steadily.
9. Once landed, pull the throttle rod to the lowest position and stay over 3s to stop the motor.
10. Turn off copter and remote control while stop motor.
Manual start/stop motor
1. Whether enough power for remote control, smart battery and mobile device(Monitor).
2.
Whether all the propellers work properly, please change if any aging, damage or out of shape.
3. Whether the propellers mounted properly and firmly.
4. Make sure the camera with SD card.
5. Whether camera works properly once power on.
6. Whether the motors can work properly once starting up.
7. Whether the monitor can work properly.
Flight
Inspection before flight
Basic flight
Pitch rod to control the copter fly forward and backward
The copter will fly forward while push up the rod, Fly backward while pull down the rod.
The copter will stay there while the rod in the middle.
Move the rod to control tilt angle forward and backward, the more you move the rod,
the more tilt angle will be, and the faster the copter will be as well.
Roll rob to control fly to left and right
The copter will fly to left while push the rod to left; The copter will fly to right while push
the rod to right. The copter will stay level while the rob in the middle.
Slide this switch to control flight mode, detailed flight mode switch as below, different
modes for different switch position.
Mode 0 (Manual): All the flight lines and attitude are controlled by pilot with remote
control rod in manual mode. (Do not suggest to beginner)
Mode 1(Auto-stable): The flight attitude is auto-stable by flight control.
Mode 2(3D): The copter is in full manual mode. Pilot can control the copter to flip by
remote control rod.
Slide this switch to set 3 different flight data and sensitivity. (Custom settings)
10 11
1 0 2
1 0 2
