eaglelighting INDIGO COMBO T5 Manuale utente
IMPORTANT INFORMATION
Please read this guide carefully before
installing or maintaining this equipment.
Data should be used as an INDICATION only.
▪Good electrical pracces should be followed
at all mes.
▪Must only be installed by a licensed
electrician.
▪If the external exible cable or cord of this
luminaire is damaged, it shall be exclusively
replaced by the manufacturer or their
service agent or a similar qualied person in
order to avoid a hazard.
▪For indoor use only.
▪A qualied electrician, in accordance with
AS/NZS 3000:2007 wiring regulaons
should carry out connecon to mains
wiring.
▪This unit must be EARTHED.
▪Ensure that the rated voltage and frequency
requirements are compable with the
available mains supply, 220-240V 50Hz.
▪Cleaning of reectors and lenses should be
carried out using clean, so and lint free
cloths and an-stac cleaning uid.
▪Do not carry out high voltage insulaon
test i.e. 500/1000V this may damage the
xtures electrical components.
Warning - Applicable to New Zealand (Only)
This luminaire is not suitable for installaon in
locaons where thermal insulaon is present,
or may reasonably be expected to be installed
in the future, or where there is a likelihood of
other combusble material, e.g. Leaves or vermin
debris, etc. collecng on or around the luminaire.
It is not suitable for domesc installaons or
installaon in residenal areas of non-domesc
installaons (residenal instuons, hotels,
boarding houses, hospitals, accommodaon
houses, motels, hostels and the like).
Luminaire’s light distribuon is direct.
Luminaire is designed for the T5-light source’s unique
characteriscs. The small diameter of the uorescent lamp
has created new condions for light control.
IP20
IP CLASSIFICATION
IP20 : Protected against solid objects greater than 12mm.
e.g. Persons ngers.
CLASS I
Appliances with funconing insulaon. Equipped with an
earth terminaon.
RISK OF FIRE
a. The minimum clearance distance from the top of the
luminaire to any normally ammable building element
is 100mm.
b. The minimum clearance distance from the top of the
luminaire to any building insulaon is 100mm.
c. The minimum clearance distance from the side of the
luminaire to any normally ammable building element
is 100mm.
d. The minimum clearance distance from the side of the
luminaire to any building insulaon is 100mm.
WARNING – RISK OF OVERHEATING OR FIRE IF THE
CLEARANCE DISTANCES ARE COMPROMISED.
Luminaire is available in designs for convenonal emergency
lighng operaon.
RCM
Indicates a device’s compliance with applicable ACMA
technical standards.
INSTALLATION INSTRUCTIONS
INDIGO COMBO T5
SPECIFICATION
CODE INS-IND5
MELBOURNE | 17-19 Jets Court. Melbourne Airport. VIC 3045 P.03 9344 7444 F.03 9344 7433
SYDNEY | Unit 4, 21 Mars Road. Lane Cove. NSW 2066 P.02 9420 5799 F.02 9420 5988 BRISBANE | 53 Caswell Street. East Brisbane. QLD 4169 P.07 3891 0744 F.07 3891 0755
EXPOSED T-BAR
Step 1
Li the luminaire into the ceiling cavity.
Step 2
Complete the electrical connecon.
Step 3
Posion the luminaire centrally within
the T-Bar.
PLASTER CEILING
Step 1
Cut out the correct hole size in the
ceiling for your plaster frame accessory.
Step 2
Li the plaster frame to the plaster
cut out.
Step 3
Fold over the retaining tabs located
in the ends of the frame to assist in
securing the frame.
Step 4
Fasten the recessing brackets to the
secure the frame within the ceiling cavity.
Step 5
Li the luminaire into the ceiling cavity.
Step 6
Complete the electrical connecon.
Step 7
Posion the luminaire centrally within
the Plaster frame.
SURFACE MOUNTED
Step 1
Li the surface mounted body to
the ceiling, feeding the supply cable
through the cable entry hole.
Step 2
Secure the body onto the mounng
surface with appropriate fasteners (not
supplied) to suit the mounng substrate.
Step 3
Complete electrical connecon.
Step 4
Slide the luminaire into the surface
mounted body and connect the earth
lanyard to the end.
Step 5
Slide the end into the surface mounted
body.
INSTALLATION INSTRUCTIONS
INDIGO COMBO T5
CODE INS-IND5
MELBOURNE | 17-19 Jets Court. Melbourne Airport. VIC 3045 P.03 9344 7444 F.03 9344 7433
SYDNEY | Unit 4, 21 Mars Road. Lane Cove. NSW 2066 P.02 9420 5799 F.02 9420 5988 BRISBANE | 53 Caswell Street. East Brisbane. QLD 4169 P.07 3891 0744 F.07 3891 0755
Indice
Altri manuali eaglelighting Lanterna
