EAGO DA333F8 Manuale utente

1. Copper Elbow 3. 4x Rubber Gasket 4. Fan

2. Copper Nut

10. Thermostatic Faucet Asembly

13. Control Valve 14. Air Control Valve

12. Body Spray Jet

17. Color LED Light

15. Drain Assembly

28. Speaker

27. Door Roller

25. Door handles

33. Steam Outlet

31. Cleaning Port

29. Hand shower Pole

6mm Washer: 8pcs

6mm Lock Washers: 4pcs

Rubber Grommet: 4pcs

3mm Allen Wrench: 1pc

6x30mm Bolt: 4pcs

Roof Fastening Brackets: 7pcs

3.5x30mm Screw: 8pcs

Whirlpool power

110V 20Amp GFCI

Steamer Power

220V 30Amp GFCI

Drain

Level

1. Carefully Unpack the bathtub from the Crate and bring

into house and put into position on floor in bathroom.

Level Bathtub

2. Put a level on the bathtub to check the level in both directions as illustrated in drawing

Adjust the adjustable legs if the bathtub is not level and to make sure there is no rocking of bathtub

once final level is set then lock the adjustable legs in position by tightening the locking nut with a wrench

And Recheck level of bathtub.

3. Once Bathtub is leveled and legs locked in position then move it away from the walls approx 12”

to allow for assembly of the shower panels on top of bathtub.

Install Moveable doors

1. Hang the doors on the upper track (Illustrated in Drawing A) Then press the lower spring loaded wheels down to hook into the lower aluminum track.

(Illustrated in Drawing B) Note: there is an adjustment screw on the upper wheel assembly to adjust if there is a gap between the moveable doors or if the doors

are overly stiff in movement then adjust the upper wheels to correct fit of doors.

2. Install the door handles by putting the large phillips screw thru the hole in door and screw into one side of the handle. Attach the handle on the other side

of door to the other side of the handle with an allen wrench by tighening the set screw on the handle. (Illustrated in Drawing C.)

Allen Wrench

Push the bottom

wheels down so that

the wheels hang in the

bottom aluminum Rail

Allen Wrench

4mm washer

6mm rubber washer

Metal bracket

Rubber grommet

6mm Lock washer

6mm Flat Washer

Handshower Pole

Handshower hose to

wall connection

Install Accessories

1. Install the Glass Shelf as illustrated in Drawing A. first install the brackets to the wall Using 4x16mm screws, 4mm washers, 6mm Plastic Washers and

4mm nuts. Then attach the arms to the brackets and the glass shelf to the arms as Illustrated in Drawing B.

2. Install the hand shower pole as Illustrated in Drawing C. First install the brackets to the wall same as the glass shelf. and the pole attaches to the