Eaton Powerware 3105 UPS Manuale utente

Powerware 3105 UPS

User’s manual

The contents of this manual are the copyright

of the publisher and may not be reproduced (even extracts)

unless permission granted.

Every care has been taken to ensure the accuracy of

the information contained in this manual, but no liability

can be accepted for any errors or omission. The right

to make design modiﬁ cations is reserved.

Powerware 3105 UPS

ser

’

s manua

1023921 Revision A

Contents

Introduction

.................................................................................................

Features

....................................................................................................................

Unit inspection

.........................................................................................................

Requesting a Declaration of Conformity

...............................................................

Safety Instructions

......................................................................................

Battery connection required before use!

.....................................................

Connecting the Battery:

...........................................................................................

Installation and Operation:

..........................................................................

Typical applications

.................................................................................................

Indicators

....................................................................................................

Battery replacement procedure:

..................................................................

Status Indicators

......................................................................................................

LED and Alarm Status Table

..................................................................................

Speciﬁ cation

...........................................................................................................

Troubleshooting

......................................................................................................

Service and Support

..................................................................................

User’s manual

350 - 700 VA

1023921

Revision A

Introduction

The Powerware 3105 uninterruptible power system (UPS) ﬁ lters the input line from

line disturbances and protects your sensitive electronic equipment from ﬁ ve common

power problems such as power failures, power sags and power surges.

Features:

Eight outlets

- Four with surge and battery backup protection

- Four with surge protection only

Data Line (Internet fax–modem–DSL) or telephone line surge protection jacks

Cold Start capability

Proprietary LanSafe Power management software

User-replaceable batteries

Built-in USB communication port

Compact design ﬁ ts on/under your desk; can also be mounted to a wall

Unit inspection

Once you have received the Powerware 3105 UPS product, you should remove and

inspect the product for shipping damage. If any damage is found, please notify the

carrier and your dealer. Please keep the shipping carton and the packing foam in the

event the product must be returned to the factory for service.

Requesting for CE-declaration

Can be downloaded from

http://www.powerware.com/Service_support/EMEA_certiﬁ cates.asp

Eaton Power Quality Oy

Koskelontie 13, FIN-02920 Espoo Finland

Phone: +358-9-452 661

Fax: +358-9-452 66 396

•

User’s manual

350 - 700 VA

1023921

Revision A

Safety Instructions

ATTENTION

Maintenance, other than battery replacement must be performed by a

qualiﬁ ed technician. Failure to do so could result in an electrical shock.

Although the unit may be unplugged from utility power, hazardous

voltage still may be present through the battery.”

1. Place the Powerware 3105 UPS indoors in an area that has adequate airﬂ ow and

is free of excessive dust. Do NOT allow the UPS to be exposed to moisture, rain,

excessive heat, or direct sunlight.

2. Use of the Powerware 3105 UPS product in life support applications, where failure

of this equipment can reasonably be expected to cause failure of life support

equipment or to signiﬁ cantly affect its safety or effectiveness is NOT recommended.

3. Shut off the UPS and disconnect the input power cord from the wall outlet before

replacing the battery.

4. When replacing the battery, use the same number and type of battery

5. Do NOT dispose of battery in a ﬁ re. The battery may explode.

6. Do NOT open or mutilate the battery. They contain an electrolyte that is toxic and

harmful to the skin and eyes.

7. Proper disposal of the battery is required. Please refer to your local laws/

regulations regarding battery disposal.

8. Use tools with insulated handles to replace the battery to avoid personal injury.

Due to energy hazard, please remove wristwatches and jewelry such as rings when

replacing battery.

User’s manual

350 - 700 VA

1023921

Revision A

Battery connection required before use!

Connecting the Battery:

Principal shown below for detailed information how to connect please refer to battery

replacement section.

Installation and Operation:

Following steps explain how to connect and operate the Powerware 3105 UPS.

1. Connect the UPS to a grounded power outlet.

Note

It is recommended that the battery should be charged for minimum 8 hours

to ensure full charge before placing the UPS in service.

2. Plug your computer, monitor or load to be protected into the “Battery Backup &

Surge Protection” outlets. (These outlets will provide emergency battery backup

power during power outages as well as protection from surges and spikes.)

Do NOT plug LASER PRINTERS into the “Battery Backup” outlets.

Do NOT plug ACCESSORY SURGE strips into the “Battery Backup” outlets.

3. Plug your peripheral equipment or non-critical loads (printer, scanner, fax, speaker,

etc.) into the “Surge Protection” outlets. (These outlets provide surge and spike

protection only, they will NOT provide battery backup power during a utility power

failure).

4. Connect your computer to the UPS using USB cable provided.

5. With your equipment turned off, switch on the UPS.

6. When the “On/Off” LED light is illuminated, turn on the connected equipment.

7. Install Power management software provided with the UPS

User’s manual

350 - 700 VA

1023921

Revision A

Typical applications

Indicators

1. On/Off Push Button/Test Switch

One switch controls the power to your equipment. Upon power turn on, unit performs

a self-test to detect overload or undercharged conditions.

Turn on the UPS

Press and hold the push button switch depressed for more than one second. Release

the switch after the audible beep is sounded.

Turn off the UPS

Press and hold the push button switch for more than one second and release the

switch after the audible beep is sounded. The UPS will shut down.

Self-Test

The UPS performs a self-test for about 3 seconds when the UPS is turned on.

User’s manual

350 - 700 VA

1023921

Revision A

2. On/Off Battery LED

Indicates the UPS is on and is powering your equipment.

A constantly illuminated LED indicates normal utility power operation.

A blinking LED indicates that the UPS is providing power from its battery.

3. Fault/Warning LED

Indicates a fault or warning condition is present.

A constantly illuminated LED indicates a LOW battery condition.

A blinking LED indicates the UPS is overloaded.

4. Battery Backup & Surge Protection Outlets

(4) IEC C13 output receptacles that provide both battery backup and surge protection.

5. Surge Protection Outlets

(4) IEC C13 output receptacles that provide surge and spike protection.

RJ11

data /Phone/Fax Protection Connectors

7. USB Communication Port

The provided LanSafe monitoring and shutdown software can be automatically

conﬁ gured to save your ﬁ les and shut down your computer in the event of a prolonged

power outage.

Your personal computer can receive the status as utility power line, utility power

failure, on battery and low battery by contact closure signals that are sent through the

USB port.

8. Circuit Breaker (resetable)

The button protrudes out when an overload condition occurs. If the button protrudes

out, then disconnect some non-essential equipment and reset the circuit breaker by

pushing the button inward.

9. Power connector

IEC C13 connector. Use you computer power cable to power the UPS

Battery replacement procedure:

1. Disconnect UPS system from power source.

2. Open battery door.

3. Disconnect used battery. Connect new battery. (It is important that connectors be

ﬁ rmly attached to new batteries.)

4. Close battery door

5. Properly recycle used battery.

User’s manual

350 - 700 VA

1023921

Revision A

350VA and 500VA models (12V-4.5Ah,or 5Ah battery)

700VA model (12V- 7Ah battery)

Status Indicators

The UPS provides both visual and audible status indicators. Visual indicators consist of

three LEDs to represent the following conditions:

On utility power operation

On battery power operation

UPS fault/alarm

•

User’s manual

350 - 700 VA

1023921

Revision A

LED & Alarm Status Table

UPS status

Green LED

Red LED

Buzzer

Self test

Blink 1 (by turns)

AC (Utility mode

Charging

OFF

Charge off

OFF

Low battery

Blink 2

Over load

Blink 2

DC (Battery

Mode)

Normal

Blink 2

OFF

Over load

Blink 2

OFF

Low battery

Blink 2

Short/Fault/DC Over-Bat

OFF

AC Over-Bat/Bat Fault

OFF

Blink 2

Notes:

Blink 1:

ON 0.5 seconds / OFF 0.5 seconds

Blink 2:

ON 0.25 seconds / OFF 0.25 seconds

B1:

1 beep / 5 seconds ON 0.25 seconds / OFF 4.75 seconds

B3:

2 beeps / 5 seconds ON, 0.25 seconds / OFF 0.25 seconds 2 times 4 seconds OFF

B4:

ON 0.5 seconds / OFF 0.5 seconds

B5:

3 beeps / 5 seconds ON 0.25 seconds / OFF 0.25 seconds 3 times 3.5 seconds OFF

Speciﬁ cation*:

Model numbers

3105 350i

3105 500i

3105 700i

Capacity

350 VA / 210 W

500 VA / 300 W

700 VA / 420 W

Input voltage range

184 to 256 V, ±3% Vac

Frequency

50 / 60 Hz auto sensing

Total 8 outlets

4 battery backup & surge protection

4 surge protection only

Lightning / surge protection

476 joules

Transfer time to battery / AC

6 ms typical

Battery type

Maintenance free, sealed and leak proof lead-acid battery

Battery speciﬁ cation

350 VA: 12 V 4,5 Ah

500 VA: 12 V 5 Ah

700 VA: 12 V 7Ah

Typical backup time

3 min minimum at full rated load

Internet / phone / fax protection

RJ11

Short circuit protection

Circuit breaker

Communication port

USB

Operating temperatur

0°C to 40°C

Operating relative humidity

0 to 95% non-condensing

Storage temperature

-15°C to 50°C

Net weight

6 kg

Dimensions (W x D x H)

280 x 178 x 115

*Due to continuing product improvement programs, speciﬁ cations subject to change without notice

Altri manuali per Powerware 3105 UPS

Indice

Altri manuali Eaton UPS

Eaton

Eaton Powerware 5110 Manuale utente

Eaton

Eaton Ellipse ASR 450 Manuale utente

Eaton

Eaton 9PX 1000i Manuale utente

Eaton

Eaton 5E650i Manuale utente

Eaton

Eaton 9PX 1:1 Guida rapida

Eaton

Eaton 93E 30IAC-D Manuale utente

Eaton

Eaton 9E20K-TH Manuale utente

Eaton

Eaton Ellipse MAX 600 Pulsar Series Manuale utente

Eaton

Eaton 5A1200I-UNI Manuale utente

Eaton

Eaton 5S 550 Manuale utente

Eaton

Eaton 9PX Istruzioni per il montaggio

Eaton

Eaton ARRAY 3A3 Pro Manuale utente

Eaton

Eaton 5P 750 Manuale utente

Eaton

Eaton SOMATOM Manuale utente

Eaton

Eaton 9E15Ki Manuale di istruzioni

Eaton

Eaton 5E 500 Manuale utente

Eaton

Eaton 5P 650 AU Manuale utente

Eaton

Eaton Nova AVR 500 Manuale utente

Eaton

Eaton Power Xpert 9395 Manuale utente

Eaton

Eaton Ellipse MAX 600 Manuale utente

Eaton

Eaton 9E-IN 1K Manuale utente

Eaton

Eaton Ellipse MAX 600 Manuale utente

Eaton

Eaton 93E UPS Manuale utente

Eaton

Eaton 550i Manuale utente

Manuali UPS popolari di altre marche

Pylontech

Pylontech Victron & Pylontech US5000 Manuale utente

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuale utente

Mecer

Mecer ME-1000-WTU Manuale utente

Mustek

Mustek PowerMust 530(B) Plus Manuale di installazione e funzionamento

Emerson

Emerson Liebert NXL series Manuale utente

MAKELSAN

MAKELSAN BOXER SERIES Manuale utente

Block

Block PC-0524-400-0 Manuale utente

CyberPower

CyberPower CP585LCD Manuale utente

CyberPower

CyberPower Office Tower Series UPS 1000 Manuale utente

CyberPower

CyberPower BM100 Manuale utente

Best Power

Best Power 610 Manuale utente

Best Power

Best Power Unity/I UT3K Manuale utente

Mustek

Mustek PowerMust 400 Offline Manuale utente

Xantrex

Xantrex Trace 512 UR-UPS Manuale utente

Forza

Forza SL-1501UL Manuale utente

LEGRAND

LEGRAND keor 310081 Manuale utente

ABB

ABB Conceptpower DPA 500 Manuale utente

ZincFive

ZincFive BC Series Manuale utente