2
EIHPTC CEILING FLOOR TYPE
PRECAUTIONS
INSTALLATION INFORMATION
ATTACHED FITTINGS
INSPECTING AND HANDLING THE UNIT
INDOOR UNIT INSTALLATION
OUTDOOR UNIT INSTALLATION
INSTALL THE CONNECTING PIPE
CONNECT THE DRAIN PIPE
WIRING
TEST OPERATION
CONTENTS
3
2
4
9
4
4
13
6
CAUTION
PRECAUTIONS
If you do not follow these instrutions exactly, the unit may cause
property damage, personal injury or loss of life.
If you do not follow these instrutions exactly, the unit may cause
minor or moderate property damage, personal injury.
After completing the installation, make sure that the unit operates
properly during the start-up operation. Please instruct the
customer on how to operate the unit and keep it maintained. Also,
inform customers that they should store this installation manual
along with the owner's manual for future reference.
Be sure only trained and qualied service personnel to install,
repair or service the equipment.
Improper installation, repair, and maintenance may result in
electric shocks, short-circuit, leaks, re or other damage to the
equipment.
keep this manual where the operator can easily nd them.
Read this manual attentively before starting up the units.
For safety reason the operator must read the following
cautions carefully.
Installation must be performed in accordance with the
requirement of NEC and CEC by authorized personnel only.
(Applicable to the North American area only).
The safty precautions listed here are divided into two categories.
Install according to this installation instructions strictly.
If installation is defective, it will cause water leakage, electrical
shock and re.
When installing the unit in a small room, take measures against
to keep refrigerant concentration from exceeding allowable
safety limits in the event of refrigerant leakage.
Contact the place of purchase for more information. Excessive
refrigerant in a closed ambient can lead to oxygen deciency.
Use the attached accessories parts and specied parts or
installation.
Otherwise, it will cause the set to fall, water leakage, electrical
shock and re.
Install at a strong and rm location which is able to withstand
the set' s weight.
If the strength is not enough or installation is not properly done,
the set will drop to cause injury.
The appliance shall not be installed in the laundry.
Before obtaining access to terminals, all supply circuits must be
disconnected.
The appliance must be positioned so that the plug is accessible.
The enclosure of the appliance shall be marked by word, or by
symbols, with the direction of the uid ow.
For electrical work, follow the local national wiring standard,
regulation and this installation instructions. An independent
circuit and single outlet must be used.
If electrical circuit capacity is not enough or defect in electrical
work, it will cause electrical shock re.
Use the specied cable and connect tightly and clamp the cable
so that no external force will be acted on the terminal.
If connection or xing is not perfect, it will cause heat-up or re at
the connection.
Wiring routing must be properly arranged so that control board
cover is xed properly.
If control board cover is not xed perfectly, it will cause heat-up at
connection point of terminal, re or electrical shock.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualied person
in order to avoid a hazard.
An all-pole disconnection switch having a contact separation of
at least 3mm in all poles should be connected in xed wiring.
When carrying out piping connection, take care not to let air
substances go into refrigeration cycle.
Otherwise, it will cause lower capacity, abnormal high pressure in
the refrigeration cycle, explosion and injury.
Do not modify the length of the power supply cord or use of
extension cord, and do not share the single outlet with other
electrical appliances.
Otherwise, it will cause re or electrical shock.
12
14
WARNING
WARNING
