eddy.com/pipescanhd 10
7. ANALYSIS AND REPORTING
At the end of the job, a report listing all the indication is generated, providing information on their position in a
comprehensive table.
The below datale shows 4 indications with a diameter of 22 mm and a depth of 20%, 40%, 60% and 80% of the wall
thickness. The threshold line has been adjusted so that the 20% indication is not reported, only what has a greater
volume will be highlighted in the C-scan.
1. Go to the backstage, general tab then select Generate Report.
2. In the Table prole drop-down menu, select Surface screening.
3. Go back to the frontstage.
4. Once the threshold position is conrmed, go in the Analysis ribbon.
5. Click on Report Detections. This will add all indication highlighted by a yellow box in the report.
6. Open the report (In the Layout ribbon, make sure that the Report is activated, then open the report by clicking on
the small Report tab at the bottom of the screen).
The report provides the following information:
x Filename: indication from all les of the inspection folder can be added in the same report.
x Index: Numerical increment for each indication added to the report (automatically generated by the software,
cannot be modied).
x Code: All indications automatically detected by Magni will be called Ind. If defects are manually added to the
report, the code name will be the one selected by the analyst when adding the entry.
x Channel/C-scan: Indicates from which view the indication comes from.
x X pos. (mm): Gives the center position of the indication in the scan direction, from the zero position of the scan.
x Y pos. (mm): Gives the center position of the indication on the index axis, from the zero position of the scan.
x X length (mm): Gives the width of the indication box.
x Y length (mm): Gives the height of the indication box.
x Comments: This eld is editable. Operators or analysts can type comments if needed (e.g. add depth value after
UT proong).
Note: The screenshot function is not available for the indications that are automatically reported by software. To be able
to use the screenshot function, the indications shall be converted into defects by adding defects manually in the report.
