Edimax HP-8501 Manuale utente
EDIMAX HP-8501
Quick Installation Guide
1
HP-8501
Powerline Ethernet Bridge
Quick Installation Guide
EDIMAX HP-8501
Quick Installation Guide
2
Copyright©by Edimax Technology Co, LTD. all rights reserved. No part of this publication may
be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language or computer language, in any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual or otherwise, without the prior written permission of this company
This company makes no representations or warranties, either expressed or implied, with respect
to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any
particular purpose. Any software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not this company, its
distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any
incidental or consequential damages resulting from any defect in the software. Further, this
company reserves the right to revise this publication and to make changes from time to time in
the contents hereof without obligation to notify any person of such revision or changes.
Linux Open Source Code
Certain Edimax products include software code developed by third parties, including
software code subject to the GNU General Public License ("GPL") or GNU Lesser General
Public License ("LGPL"). Please see the GNU (www.gnu.org) and LPGL (www.gnu.org)
Web sites to view the terms of each license.
The GPL Code and LGPL Code used in Edimax products are distributed without any
warranty and are subject to the copyrights of their authors. For details, see the GPL Code
and LGPL Code licenses. You can download the firmware-files at edimax’s Website：
http://www.edimax.com under "Download" page.
※ The product you have purchased and the setup screen may appear slightly different from
those shown in this QIG. For more detailed information about this product, please refer to
the User's Manual on the CD-ROM.
※ Software and specifications subject to change without notice. Please visit our web site for the
update.
※ All rights reserved. Trademarks or registered trademarks are the property of their respective
Holders
EDIMAX HP-8501
Quick Installation Guide
3
1.Introduction
1.1 Package Contents
Open the package carefully, and make sure that none of the items listed below are missing.
zEdimax HP-8501 x 1
zQuick Installation Guide x 1
zCD-ROM (with Management Utility) x 1
zEthernet RJ-45 Cable x 1
Note：CD-ROM with the management Utility could help you to manager all of the HP-8501 in the
LAN. The Utility is not necessary when you use the internet via HP-8501. If you need to know the
function of Utility , you can study the manual in the CD-ROM.
If any item is missing or damaged, please contact your local resellers for service.
Attention: It is recommended to keep the original packing materials, in case of product service;
the returned product shall be packed in the original or equivalent materials to protect it from
damage during delivery.
1.2 Hardware Introduction and Installation
LED Indicators
1. PWR：Power
2. ETH：Ethernet link activity
3. PL ：Powerline link activity
Ethernet Port：Where you can connect 10/100M Ethernet network devices, such as PCs, printer
EDIMAX HP-8501
Quick Installation Guide
4
servers, and anything else you want to put on your networks
Application:
Please setup your HP-8501 as the following map .
One HP-8501 connect with ADSL modem or IP share .
The other HP-8501( You can use another device which supports powerline) connect with your
PC .
EDIMAX HP-8501
Quick Installation Guide
5
2. Utility
There is a Utility in the CD-ROM , you can click “Setup Utility” to install . The Utility can help you
to manager the Powerline devices in the LAN . The device is able to detect other powerline
devices which is on the same power circuit automatically. You only need to install.this utility
program when you want to enable the encrypt function of Powerline Extender to secure your
data, or you have problem connecting other powerline devices.
Please verify that no other Powerline Management Utilities are installed before installing this
product. If other utilities are installed, uninstall them and restart before installing this software.
To install, insert the HP-8501’s CD-ROM into the computer's CD-ROM drive. The Setup utility
shall run automatically. Alternatively this can also be done manually by double clicking the
setup.exe file on the CD. The CD will launch an installation utility similar to the one shown in
Figure 1.
Click the Next button to continue.
EDIMAX HP-8501
Quick Installation Guide
6
Figure 1: Install Shield Screen
After you finish the Utility installation , you can double click the following icon to enable the Utility
This screen shot shows a Powerline Ethernet device( HP-8501 ) connected as a local device.
Remote Powerline Ethernet devices as follows：
Item Description
Device Name Shows the name of a found device in the LAN
Rate (Mbps) Data rate between HP-8501 and the remote Powerline device
MAC Address MAC Address of the remote Powerline device
Password shows the user-defined device password (initially left blank)
EDIMAX HP-8501
Quick Installation Guide
7
A user may change the password by clicking ‘Enter Password’ button. To set the Password of
the device (required when creating a secured private network), first select the device by clicking
on its name in the lower panel and then click on the ‘Enter Password’ button .A dialog box will
appear as shown in Figure 2 for you to type the password. The selected device name is shown
so you can make sure which device you’re changing the password. Click OK after you’ve entered
the new password. A confirmation box will appear if the password was entered correctly. If a
device is not found, the user will be prompted and instructions to this problem will be shown, too.
Figure 2: Set Device Password
The Add button is used to add a remote device to your network that is not listed in the lower
panel, for example, a device currently located on another logical network. Users will be prompted
to input the passwords for all devices they wish to manage and add them to the local logical
network by clicking on the Add button. A dialog box will appear as shown below. The dialog box
EDIMAX HP-8501
Quick Installation Guide
8
allows user to enter both device name and the password. A confirmation box will appear if the
password was entered correctly and the device was found. If a device is not found, the user will
be prompted and instructions to this problem will be shown, too.
Figure 3: Add Remote Device
Note: The device must be present on the power line (plugged in) in order to check the password
so it can be added to the network. If the device could not be located, a warning message will be
shown.
The Scan button is used to perform an search of the Powerline Ethernet devices connected to
the computer. By default, the utility will automatically scan once every few seconds and updates
the display. A typical screen after naming and supplying passwords might appear as in Figure 4.
EDIMAX HP-8501
Quick Installation Guide
9
Figure 4: Main tab of the configuration utility
If you want to know the detail setting of the Utility , please study user’s manual in the CD-ROM .
Warning
(1) Simply plug into a power outlet and do not use a power strip or UPS with the wall mount
device
(2)This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Important Safety Instructions
This product is intended for connection to the AC power line.
The following pre-cautions should be taken when using this product:
‧Please read all instructions before installing and operating this product.
‧Please follow all warnings and instructions marked on the product.
‧Do not operate this product near water.
‧This product should never be place near or over radiator, or heat register.
‧This product relies on a building's electrical installation for short-circuit (over current) protection.
Altri manuali per HP-8501
3
Indice
Altri manuali Edimax Router di rete
Edimax
Edimax GS-5208P Manuale utente
Edimax
Edimax BR-6428nS V3 Manuale utente
Edimax
Edimax BR-6478AC Manuale utente
Edimax
Edimax CV-7438nDM Manuale utente
Edimax
Edimax CV-7438nDM Manuale utente
Edimax
Edimax BR-6524n Scheda informativa del prodotto
Edimax
Edimax AR-7267WnB Manuale utente
Edimax
Edimax BR-6004 Manuale utente
Edimax
Edimax AR-7287WnA Manuale utente
Edimax
Edimax BR-6641 Manuale di istruzioni
Edimax
Edimax BR-6428nS V5 Manuale utente
Edimax
Edimax BR-6208ACD Manuale utente
Edimax
Edimax BR-6675nD Manuale utente
Edimax
Edimax ER-1088 Manuale utente
Edimax
Edimax EW-7811ULC Manuale utente
Edimax
Edimax AR-6024WG Manuale utente
Edimax
Edimax EW-7833UAC Manuale utente
Edimax
Edimax AR-7084A Manuale utente
Edimax
Edimax AR-7186WnA Manuale utente
Edimax
Edimax CV-7438nDM Manuale utente
Manuali Router di rete popolari di altre marche
NETGEAR
NETGEAR FS526T - Switch Manuale utente
Korenix
Korenix JetNet 5710G Series Manuale utente
Automated Logic
Automated Logic ZN551 Manuale del proprietario
Cisco
Cisco ASR 1000 Series Manuale dell'operatore
EnGenius
EnGenius ESR-9710 Manuale utente
Cisco
Cisco 805 Series Istruzioni operative e di sicurezza