Netzeingang / Sicherungshalter
An diesen Kaltgeräte-Netzanschluss wird der Stecker der Netzanschlussleitung angeschlossen.
Verwenden Sie nur das mitgelieferte Netzkabel.
Anschluß Potentialausgleich
Grundsätzlich ist das Steuergerät über den 3-poligen Schukostecker geerdet, wenn es, wie
vorgeschrieben, an eine geerdete Netzleitung angeschlossen ist.
Bei Betrieb des Gerätes in Räumen der Anwendungsgruppe 1 oder 2E nach MedGV ist es
unabdingbar, dass das Gerät mit einem entsprechenden Kabel an den stationären
Potentialausgleich des Raumes oder des Gerätewagens angeschlossen wird. Dazu besitzt das
Geräte eine entsprechende Steckvorrichtung.
Videoausgang
An die VIDEO OUT-Buchse können externe Geräte wie Monitor, Videorecorder oder Videoprinter
angeschlossen werden
Über die BNC-Buchse kann das Videosignal als VBSSignal (Composit-Signal, VHS-Norm)
abgegriffen werden.
Connector for Camera Gable
This Connector is used for attachment of the plug of the camera Gable.
The plug can only be plugged in a certain Position. This is achieved by a small nose an the top of
the plug. Put the Connector firmly in and fasten the lock screw. The main board will only be
switched on, when the Connector is installed.
Whitebalance
The WHITEBALANCE is done by pressing the corresponding push button.
Therefore, aim the camera head an a homogeneously illuminated White sheet of paper or a well
illuminated multicolour object. Simultaneously, press the push button once. The button then will flash
until the WHITEBALANCE is finished. The current WHITEBALANCE is stored in memory and is also
saved, when the camera is switched off.
Take notice, that the paper-sheet or the multi-colour object is not irradiated, that means, e.g. that the
grain-structure of the paper is visible an the monitor.
If Whitebalance is done correctly, a natural colour reproduction is guaranteed.
Window-function
The WINDOW-function is turned an and off by pressing the corresponding push button.
The WINDOW-function Garnes out a light measurement that only affects a central window of the
picture. That means, that in contrast to Standard measurement, where the average brightness is
integrated over the entire picture size, only a centre Part of the Image is taken to evaluate the
average brightness, outer margins are disregarded.
If the WINDOW-function is activated, a yellow light inside the push button is up-light. If the object to
be regarded is in the centre of the picture, you should activate the WINDOWfunction. The object
itself is displayed correctly illuminated an the monitor and the outer margins of the screen are
displayed proportionately darker or brighter.
Anewed pressing of the button, deactivates the WINDOWfunction.
Main switch
The control unit is switched an by switching the mains switch. The mains switch has two different
switching positions:
I ON switched on
O OFF switched off
When the control unit is switched on, this is indicated by the up-light green lamp inside the switch.
MEDIZINTECHNIK FÜR TIERÄRZTE
