Ekwb EK-Pro AM5 Series Manuale utente

USER GUIDE

AM5 NI + POMC | AM5 AL + POMC | AM5 RACK NI + POMC | AM5 RACK AL + POMC

EK-Pro

CPU Water Block AM5

Please note the installation of the product is intended to be undertaken

by an adequately trained and experienced person. You are installing the

product at your own risk. If you are not properly trained or experienced

or feel unsure about the installation procedure, please refrain from

installing the product yourself and contact our tech support for

assistance. We disclaim our liability for any damages to the product as

well as incidental, consequential, or indirect damages incurred due to

improper or inappropriate installation.

Before you start using this product, please follow these basic guidelines:

Please read the manual carefully before starting the

installation process.

Please remove your graphics card from the computer

to ensure the safest mounting process and prevent any

possible damage to your GPU and/or graphics card circuit

board (PCB).

The EK-HFB and EK-ACF type ﬁttings require only a small

amount of force to screw them ﬁrmly in place since the

rubber O-ring gaskets ensure the liquid seal.

The use of corrosion inhibiting coolants is always

recommended for any liquid cooling system.

Do not use pure distilled water. For best results, EK

recommends the use of EK-CryoFuel coolants.

Make sure to bleed the air from your water block thoroughly,

or you will not reach optimal performance.

- 3 -

TABLE OF CONTENTS

GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY 4

BOX CONTENTS 5

TECHNICAL SPECIFICATIONS AND PRODUCT PARTS 6

INSTALLING THE WATER BLOCK 8

CLEANING THE CPU 8

THERMAL COMPOUND APLICATION 8

INSTALLING THE WATER BLOCK ASSEMBLY 9

INSTALLING THE FITTINGS 10

TESTING THE LOOP 11

SUPPORT AND SERVICE 12

SOCIAL MEDIA 12

- 4 -

GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY

This CPU liquid cooling unit is pre-assembled for use with modern

AMD server socket-type motherboards. By default (out of the box),

this water block supports the following CPU sockets:

- AMD® Socket AM5

- 5 -

BOX CONTENTS

Allen Key 5 mm (1 pc)EK-Pro CPU Water Block AM5

Mounting Mechanism EAN: 3831109905043

Allen Key 2.5. mm (1 pc)

Thermal Grizzly Hydronaut (1g)

- 6 -

TECHNICAL SPECIFICATIONS AND PRODUCT PARTS

The following items are enclosed with each EK-Pro AM5 water block,

depending on the version: EK-Pro AM5 CPU water block

3831109903223 Ni + POM-C:

Position EAN Description Quantity

1106244 CPU COLDPLATE Nickel 1

2106249 TOP ACETAL 1

3103287 M3 x 20 ISO 14583 Screw 8

4100442 SEALING GASKET 66 x 2 EPDM70 1

5106242 EK – MOUNTING PLATE 1

6106246 J E T PL AT E 1

7106251 TOP COVER 1

8103089 M3 x 5 ISO 14581 Screw 4

9106248 Pro CPU WB AM5 Screw 4

10 8706 M4 x 16 mm 8 kg (16 x 7.8) Spring 4

11 9033 Seegerring 3.2 DIN 6799 4

3831109903247 Ni rack + POM-C:

Position EAN Description Quantity

1106244 CPU COLDPLATE Nickel 1

2106250 TOP ACETAL Rack 1

3103103 M3 x 16 ISO 14583 Screw 8

4100442 SEALING GASKET 66 x 2 EPDM70 1

5106242 EK – MOUNTING PLATE 1

6106246 J E T PL AT E 1

7106252 TOP COVER Rack 1

8103089 M3 x 5 ISO 14581 Screw 4

9106248 Pro CPU WB AM5 Screw 4

10 8706 M4 x 16 mm 8 kg (16 x 7.8) Spring 4

11 9033 Seegerring 3.2 DIN 6799 4

12 3830046996435 EK-PLUG G1/8 2

- 7 -

3831109903247 Al + POM-C:

Position

EAN Description

Quantity

1106245 CPU COLDPLATE ALU 1

2106249 TOP ACE TAL 1

3103287 M3 x 20 ISO 14583 Screw 8

4100442 SEALING GASKET 66 x 2 EPDM70 1

5106242 EK – MOUNTING PLATE 1

6106247 JET PLATE ALU 1

7106251 TOP COVER 1

8103089 M3 x 5 ISO 14581 Screw 4

9106248 Pro CPU WB AM5 Screw 4

10 8706 M4 x 16 mm 8 kg (16 x 7.8) Spring 4

11 9033 Seegerring 3.2 DIN 6799 4

3831109903254 Al rack + POM-C:

Position

EAN Description

Quantity

1106245 CPU COLDPLATE ALU 1

2106250 TOP ACETAL Rack 1

3103103 M3 x 16 ISO 14583 Screw 8

4104307 SEALING GASKET 66 x 2 EPDM70 1

5106242 EK – MOUNTING PLATE 1

6106247 JET PLATE ALU 1

7106252 TOP COVER Rack 1

8103089 M3 x 5 ISO 14581 Screw 4

9106248 Pro CPU WB AM5 Screw 4

10 8706 M4 x 16 mm 8 kg (16 x 7.8) Spring 4

11 9033 Seegerring 3.2 DIN 6799 4

3831109810040

EK - ALU PLUG G1/8 2

- 8 -

INSTALLING THE WATER BLOCK

STEP 1

CLEANING THE CPU

Wipe the CPU’s contact surface (by using non–abrasive cloth or

Q-tip).

STEP 2

THERMAL COMPOUND APLICATION

Applying thermal compound: on a clean IHS, apply a line of thermal

compound and spread it over the whole CPU heat spreader (IHS)

with a credit card or equivalent.

The layer of the thermal compound must be thin and even in thickness

through the whole surface of the IHS. A too-thick application could

lead to poor performance.

STEP 1

STEP 2

IHS

NON-ABRASIVE CLOTH

Thermal Grease

For this step, you will need:

- 9 -

STEP 3

INSTALLING THE WATER BLOCK ASSEMBLY

Before proceeding with the installation, it is mandatory to

remove the protective foil from the backside of the water

block. The CPU should be attached to the processor

carrier before you start this step. The carrier typically

comes with the server system or motherboard.

When installing the water block onto the CPU, position it

so that the EKWB logo is pointing toward the lower right

corner, to ensure optimal performance of the product.

Align the water block over the mounting screws on the AM5

motherboard. Make sure the processor is oriented correctly, aligning

the PIN 1 corners on the socket.

Next, use a 2.5 mm Allen key to tighten the bolts until you feel a

sharp increase in resistance.

It is recommended to remove the motherboard from the

PC chassis before proceeding with the installation of

the processor and water block assembly because of the

space constraints of different computer cases.

The installation of the CPU water block is now complete.

STEP 3

- 10 -

CLAMP

INLET

OUTLET

BARB

CLAMP

BARB

INLET

STEP 4

INSTALLING THE FITTINGS

Carefully identify the direction of the ﬂow in your circuit. For the

non-rack version, EK recommends the use of EK-HFB 10 mm barb

ﬁttings and EK-Tube ZMT 10/16 mm Matte Black tubing. For the rack

version, EK-HFB Fitting 6 mm G1/8 and EK-Tube ZMT 6/9mm Matte

Black tubing is recommended.

With EK-Pro CPU non-rack water blocks, it is mandatory to use the

port in the center of the water block as the inlet port. For the rack

version, the inlet port is on the right on both sides. Mixing the ports

may result in lesser thermal performance of the water block.

STEP 4

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali ekwb Hardware per computer

ekwb

ekwb EK-FC R9-280X DCII Manuale utente

ekwb

ekwb EK-FC460 GS/SONIC Manuale

ekwb

ekwb EK-SBAY DDC Series Guida

ekwb

ekwb Ultra Monoblock EK-FB GA X99 Manuale utente

ekwb

ekwb EK-FC Strix RTX 2080 Ti Backplate Classic Manuale utente

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Manuale utente

ekwb

ekwb EK-Loop Fan FPT 120 FAN Manuale utente

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Manuale utente

ekwb

ekwb EK-FC670 GTX Series Manuale

ekwb

ekwb EK-FC580 DCII Guida

ekwb

ekwb EK-FC R9-295X2 Guida

ekwb

ekwb EK-FC RX-480 Manuale utente

ekwb

ekwb EK-FC780 GTX HOF Series Manuale

ekwb

ekwb EK-FC R9-290X SE Backplate Guida

ekwb

ekwb EK-Quantum RX 6800 Manuale utente

ekwb

ekwb EK-Supremacy Classic RGB Manuale utente

ekwb

ekwb EK-FC1080 GTX Backplate Guida

ekwb

ekwb EK-Classic GPU Water Block RTX 3080/3090... Manuale utente

ekwb

ekwb EK-FC480 GTX Manuale

ekwb

ekwb EK-FB ASUS R5-E10 Guida

ekwb

ekwb EK-FC 780 GTX Classy Manuale

ekwb

ekwb EK-FB MSI X299 GAMING PRO CARBON Monoblock Manuale utente

ekwb

ekwb GTX 1080 Ti Aorus Backplate Guida

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente

ekwb EK-Pro AM5 Series Manuale utente

Manuali Hardware per computer popolari di altre marche