•Replace all panels before operating.
•It is recommended that a separate circuit serving only your appliance
be provided. Use receptacles that cannot be turned off by a switch or
pull chain.
•Never clean appliance parts with flammable fluids. These fumes can
create a fire hazard or explosion. And do not store or use gasoline or
other flammable vapors and liquids in the vicinity of this or any other
appliance. The fumes can create a fire hazard or explosion.
•Before proceeding with cleaning and maintenance operations, make
sure the power line of the unit is disconnected.
•
Do not connect or disconnect the electric plug when your hands are wet.
•Unplug the appliance or disconnect power before cleaning or
servicing. Failure to do so can result in electrical shock or death.
•Do not attempt to repair or replace any part of your appliance unless
it is specifically recommended in this manual. All other servicing
should be referred to a qualified technician.
FOLLOW WARNING CALLOUTS BELOW ONLY WHEN
APPLICABLE TO YOUR MODEL
•Use two or more people to move and install the appliance. Failure to
do so can result in back or other injury.
•To ensure proper ventilation for your appliance, the front of the unit
must be completely unobstructed. Choose a well-ventilated area with
temperatures above 60°F (16°C) and below 90°F (32°C). This unit
must be installed in an area protected from the elements, such as
wind, rain, water spray or drips.
•The appliance should not be located next to ovens, grills or other
sources of high heat.
•The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes. A standard
electrical supply (120 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and
ordinances, is required.
•Do not kink or pinch the power supply cord of the appliance.
•The size of the fuse (or circuit breaker) should be 15 amperes.
•It is important that the appliance be level in order to work properly.
You may need to make several adjustments to level it.
•All installations must be in accordance with local plumbing code
requirements.
