Audio Setup
AUDIO OUT: Use right arrow button to sdect the audio output way.
This is the way for you to select SPDIF/OFF, SPDIF/RAW, SPDIF/PCM.
KEY： Press ▲ ▼ to adjust the tone level.
Video Setup
BRIGHTNESS: Use ▲ ▼ to adjust the brightness of the video output.
CONTRAST: Use ▲ ▼ to adjust the contrast value of the video output.
HUE: Use ▲ ▼ to adjust the HUE value of the video output.
SATURATION : Use ▲ ▼ to adjust the saturation value of the video output.
SHARPNESS: Use ▲ ▼ to adjust the sharpness value of the video output.
Speaker Setup
DOWN MIX LT/RT : When you play a disc that has logic effect, you can
choose LT/RT output. The disc information will be decoded and show better
effect.
STEREO: When 2ch output is selected, normal stereo signals may be
played from the L & R output socket.
Digital Setup
OP MODE
LINE OUT: The input signals are linear compressed and the volume is lower.
You should rather choose LINE OUT setting at night.
RF REMOD: The volume is higher and adapt to daytime use.
DYNAMIC RANGE: When you choose LINE OUT mode, select
DYNAMIC RANGE to adjust the compression ratio and you can get different
effects. When you adjust to FULL, the compression ratio will be set to the
lowest level. When adjust is OFF, the compression ratio will be set to the
lowest level.
DUAL MONO: You can set the audio output mode for Lor R channel. There
are four modes: STEREO, MONO L, MONO R, and MIX MONO.
