ElectrIQ DragonPlus7-1.5W Manuale utente

USER MANUAL

OIL FILLED RADIATOR

DragonPlus7-1.5W

DragonPlus7-1.5WB

DragonPlus9-2.0W

DragonPlus9-2.0WB

DragonPlus11-2.5W

DragonPlus11-2.5WB

Thank you for choosing electriQ

Please read the manual before using this heater

and keep it safe for future reference.

Visit our page www.electriQ.co.uk for our entire product range

THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED SPACES OR

OCCASIONAL USE.

CONTENTS

SAFETY INSTRUCTIONS

PRODUCT OVERVIEW

DISPLAY

CONTROL PANEL

REMOTE CONTROL

OPERATION

CONNECTING THE APPLIANCE TO WIFI

CONTROLLING YOUR APPLIANCE THROUGH THE APP

MAINTENANCE

TROUBLESHOOTING

TECHNICAL DATA

SUPPORT

PRODUCT FICHE

SAFETY INSTRUCTIONS

IMPORTANT

Carefully read the instructions before operating the unit

This appliance is for indoor use only.

Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.

Installation must be in accordance with regulations of the country where the

unit is used.

If you are in any doubt about the suitability of your electrical supply have it

checked and, if necessary, modified by a qualified electrician.

This heater has been tested and is safe to use. However, as with any electrical

appliance use it with care.

Disconnect the power from the unit before dismantling, assembling or

cleaning.

Avoid touching any moving parts within the appliance.

Never insert fingers, pencils or any other objects though the guard.

This appliance can be used by Children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be carried out by children.

Children aged from 3 years and less than 8 years shall only switch on/off the

appliance provided that it has been placed or installed in its intended normal

operating position and they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

Children aged from 3 years and less than 8 years shall not plug in, regulate,

or clean the appliance or perform user maintenance.

Children under 3 years should be kept away unless continuously supervised.

Some parts of this product can become very hot and cause burns. Particular

attention has to be given where children and vulnerable people are present.

Do not clean the unit by spraying it or immersing it in water.

Never connect the unit to an electrical outlet using an extension cord. If an

outlet is not available, one should be installed by a qualified electrician.

Never operate this appliance if the unit, cord or plug is damaged. Ensure the

power cord is not stretched, exposed to sharp object/edges, or routed under

the unit.

Any service other than regular cleaning should be performed by an authorised

service representative. Failure to comply could result in a voided warranty.

Never use the plug as a switch to start and turn off the heater. Use the

provided power button located on the control panel.

Do not use an external timer.

Do not cover the appliance, or place items close to the unit which may restrict

airflow, as this may present a fire risk.

The heater must not be located immediately below a socket outlet.

Always place the unit on a dry and stable surface. Do not move or tilt the unit.

Avoid keeping the unit in direct sunlight for a long period of time.

The heater is designed to be used at temperatures above -20°C. If it is

exposed to temperatures below this, it must be allowed to warm above this

level before operation.

Do not attempt to repair, disassemble or modify the appliance. This unit

contains no user-serviceable parts.

Always unplug or disconnect the appliance from the mains power supply when

not in use, or when moving or cleaning it. Do not pull the cord to unplug the

heater.

Keep the heater clean. Do not allow any object to enter the ventilation or

exhaust opening as this may cause electric shock, fire, or damage to the

heater.

Do not use the appliance for anything other than its intended use. It is

designed for domestic indoor use only.

There may be a trace of odour during the first few minutes of initial use, or

after a period of storage. This is normal and will quickly disappear.

This appliance has hot and arching or sparking parts inside. Do not use it in

areas where gasoline, paint, or any flammable liquids are used or stored.

This appliance is not intended for use in bathrooms, laundry areas and similar

humid locations. Never locate this appliance where it may fall into a bathtub

or otherwise become exposed to water.

The remote contains a lithium battery, keep out of reach of small children.

Seek Medical advice if swallowed.

To prevent battery leakage: Remove the battery from the remote if exhausted

or before long periods of storage.

WARNING: To reduce the risk of fire or electrical shock, DO NOT use this

appliance with any solid-state Speed Control Device or any variable speed

controllers.

ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS

Do not cover or restrict the airflow. Do not use in dusty environment.

For safety and maximum performance, the minimum distance from a wall or

objects should be 50cm.

PRODUCT OVERVIEW

1.Handle

2.Digital display screen

3.Control panel

4.Power switch

5.Cord storage with hook

6.2 x mounting plates U

ACCESSORIES

Remote Control

Mounting Plates

Castors

U-Shaped Bolts

Butterfly Screws

ASSEMBLY INSTRUCTIONS

•The castors must be attached before the heater is operated.

•Castors are supplied with the device. You must mount them on the

supplied mounting plates and then attach these to the unit before

use.

WARNING: Do not operate without the castors. Only operate the

heater in an upright position.

POSITIONING THE HEATER

•Place the unit in an upright position on a flat, stable and heat-resistant surface.

•Ensure that there are no flammable or heat-sensitive materials or substances

within one metre of the front and 50 cm of the rear and sides of the unit.

•Do not cover the heater.

CONNECTING THE HEATER

•Before inserting the plug into a suitable socket, make sure that the unit is intact,

properly assembled and that there is no signs of damage to the appliance or its

power cable.

•To avoid overloading a circuit, connect the unit only to a circuit where no other

equipment is connected.

•When the power switch is in the OFF position, insert the plug into an earthed

socket and turn on the power.

DISPLAY SCREEN

LOW

MEDIUM

HIGH

TIMER

POWER

HEAT

LEVEL

CONTROL PANEL

The unit can be operated using the remote control or the control panel on the side of

the unit.

Please note the unit must be turned on using the power switch before use

REMOTE CONTROL

The buttons on the remote allow the access to the same settings as the main control

panel.

Change the heat

level between Low,

Medium and High

Set the Standby /

Start Timer

On / Off Button

Increase

desired

Temperature

Decrease desired

Temperature

Decrease desired

Temperature

Increase

desired

Temperature

Change the heat

level between Low,

Medium and High

Set the Standby /

Start Timer

On / Off Button

OPERATION

Turning ON/OFF

•Press the power switch on the side of the unit to the "ON" position to power the unit.

The power symbol will illuminate on the display.

•Press the "ON/OFF" button on the control panel or remote control. The unit will start

to operate at the High heat setting.

•Press the "ON/OFF" button to stop operation and put the unit into standby mode.

•Press the power switch to the OFF position to turn off the power to the appliance.

SELECTING A POWER LEVEL

Press the “HEAT” button repeatedly to select a Heat level between Low, Medium and

High. The display will show the currently selected Heat level

SETTING THE TEMPERATURE

The desired temperature can be set between 15°C and 35°C. Once the desired

temperature has been reached the unit will stop the heating function.

With the unit operating at the desired heat level use the + and - buttons to set the

desired temperature.

While the unit is heating, the thermometer symbol will flash.

When the room temperature is above the desired temperature the thermometer

symbol will be illuminated constantly.

TIMER BUTTON

The in-built timer will allow you to set the unit to turn on or turn off after a set period

of time, Please note only one timer can be used at any time.

ON TIMER –The timer will turn on the unit automatically after the time set has

elapsed.

1. With the unit turned off, press the TIMER button, then set the number of

hours’ time you desire the unit to start by repeatedly pressing the TIMER

button.

2. Once the set time has elapsed, the unit will turn on automatically.

3. Press the POWER button before the time has elapsed and the unit will turn on

as normal and the timer will be cancelled

OFF TIMER –The timer will turn off the unit automatically after the time set has

elapsed.

1. While the unit is operating, press the TIMER button then set the number of

hours’ time you desire the unit to stop by repeatedly pressing the TIMER

button.

2. Once the set time has elapsed, the unit will enter standby automatically.

3. Press the POWER button before the time has elapsed, the timer will be

cancelled and the unit will turn off.

MODES AVAILABLE FOR SETUP

The heater has two different setup modes, Quick Connection and AP (Access Point).

The quick connection is a quick and simple way to set the unit up. The AP connection

uses a direct local Wi-Fi connection between your phone and the heater to upload the

network details.

When first turned on using the switch on the rear of the unit, the power indicator will

flash rapidly, showing that the unit is in Quick connection mode, and ready to set up.

Please ensure your device is in the correct Wi-Fi connection mode for the connection

type you are attempting, the flashing of the power indicator on your heater will indicate

this.

Connection Type

Frequency of Flashes

Quick Connection

Flashes twice per second

AP (Access Point)

Flashes once per second

CHANGING BETWEEN CONNECTION TYPES

To change the unit into AP mode, with the appliance in standby (Power switch on and

unit turned off), press and hold the HEAT button for 5 Seconds.

To change back to Quick connection mode, turn the appliance off using the switch on

the rear. Leave turned off for 10 seconds before returning the switch to the on position.

After a few seconds the Power indicator will start to quickly flash to indicate the unit is

in Quick connection mode.

TURNING WIFI OFF

With the appliance in standby mode (Power switch on, but turned off), Press and hold

the On Off Button for 3 seconds. The unit will bleep and the Light button will go out.

TURNING WIFI ON

Turn the appliance off using the switch. Leave turned off for 10 seconds before

returning the switch to the on position. After a few seconds the Power indicator will

start to quickly flash to indicate the unit is in Quick connection mode.

CONNECTING THE APPLIANCE TO WIFI

DOWNLOAD THE APP TO YOUR PHONE

Download the” TUYA SMART” app, from your chosen app store, using the QR codes

below, or by searching for the app in your chosen store.

Android

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali ElectrIQ Stufa

ElectrIQ

ElectrIQ HS24-600-2DGW Manuale utente

ElectrIQ

ElectrIQ eiQ-AM09W Manuale utente

ElectrIQ

ElectrIQ EQODETALL Manuale utente

ElectrIQ

ElectrIQ eiQEWMR Manuale utente

ElectrIQ

ElectrIQ EGH20AWB Manuale utente

ElectrIQ

ElectrIQ EQODETT Manuale utente

ElectrIQ

ElectrIQ EDR-TRM0820B Manuale utente

ElectrIQ

ElectrIQ EORW800LED Manuale utente

ElectrIQ

ElectrIQ 1466275 Manuale utente

ElectrIQ

ElectrIQ EPMH1000LED Manuale utente

ElectrIQ

ElectrIQ ECFIRPH7W Manuale utente

ElectrIQ

ElectrIQ VSTR9-650-0.6WW Manuale utente

ElectrIQ

ElectrIQ eiQODE80 Manuale utente

ElectrIQ

ElectrIQ EPPH5W Manuale utente

ElectrIQ

ElectrIQ DPHW1500W Manuale utente

ElectrIQ

ElectrIQ EDR-TRD1025B Manuale utente

ElectrIQ

ElectrIQ EQODETTM Manuale utente

ElectrIQ

ElectrIQ EIGH8TBVW Manuale utente

ElectrIQ

ElectrIQ eiQ-AM09 Manuale utente

ElectrIQ

ElectrIQ HS10-600-0.6DGW Manuale utente

ElectrIQ

ElectrIQ eiQODE45 Manuale utente

ElectrIQ

ElectrIQ EAH2000W Manuale utente

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente