Electrolux WEK 7 Manuale utente

Service Manual

Wine chiller

Muggenhofer Straße 135

D-90429 Nürnberg

Germany

Fax +49 (0)911 323 1022

DGS-TDS-N

Edition: 05.06

Publ.-No.:

168 650

685

Fitted wine chiller

WEK 7

DGS-TDS-N 05.2006 © Electrolux 2 168 650

Contents

1. Installing the Appliance.....................................................................3

2. Operating Functions..........................................................................4

3. Refrigeration Cycle Diagram.............................................................5

4. Troubleshooting ................................................................................6

5. Diagnosis Mode, Presentation Mode................................................8

6. Replace Spare Parts.........................................................................9

DGS-TDS-N 05.2006 © Electrolux 3 168 650

1. Installing the Appliance

1. Observe the correct width

550 mm, CH version- fittings 167603

600 mm, EU version – fittings 167678

2. Observe the climate classes

SN +10 - +32°C

N +16 - +32°C

ST +18 - +38°C

3. Electrical connection

220 … 240V 50 Hz alternating current

It is imperative that the chiller be disconnected from the mains prior to

work being carried out on the electrical system!

The electrical safety (accidental contact protection) is to be ensured by

the installation.

DGS-TDS-N 05.2006 © Electrolux 4 168 650

2. Operating Functions

1. Switch appliance on/off

2. Temperature selection, top area -> (Can only be set if the

3. Temperature selection, bottom area -> display flashes).

4. Supercool mode

5. Interior lighting on permanently or only when the door is open.

1 5 2 9 7 3

6 8 4 8

6. Temperature display for the top compartment

7. Temperature display for the bottom compartment

8. Mode display

9. Supercool on (flashes when the presentation activation)

10. Presentation mode

(pressing buttons 2 , 4 and 3 simultaneously activates and deactivates the presentation

mode).

11. Diagnosis

(pressing of all 4 temperature selection buttons activates the diagnosis mode).

Child-proof lock: the buttons are only active after they have been pressed

for 3 sec.

DGS-TDS-N 05.2006 © Electrolux 5 168 650

3. Refrigeration Cycle Diagram

German English

Bedienungseinheit Operating unit

Beleuchtung Lighting

Türkontakt Door contact

Elektronik Electronic system

Temperaturfühler - oben Temperature sensor - top

Temperaturfühler - unten Temperature sensor - bottom

Ventilator Ventilator

Lamellenverdampfer Lamellar evaporator

Servomotor Servomotor

Heizung Heating

Kondensator Capacitor

Trockenpatrone Dry cartridge

Kompressor Compressor

DGS-TDS-N 05.2006 © Electrolux 6 168 650

4. Troubleshooting

Fault Possible cause Remedy

Appliance not working Appliance is not switched on

Compressor 5 Min. forced

interruption for pressure

compensation

Plug is not inserted or is loose.

Fuse is defect

Power outlet is defect

Presentation mode is active

Switch appliance on.

Insert plug.

Check or replace fuse.

Have power supply defect repaired

by an electrical specialist.

Deactivate

The chilling

temperature is

insufficient

Temperature is not correctly set

Door was opened too long.

Ventilator defect

Inspect door seal

Appliance is next to a heat source

Glass door is cracked or broken

Glass door is mounted canted

Compressor defect, irregular

operating sound.

Please refer to the operating

functions.

Do not leave the door open for longer

than 2-3 minutes (alarm sounds after

5 minutes and can be deactivated by

briefly pressing any button).

Replace ventilator (see 6.3.6 )

Replace door seal (see 6.1.4 ).

Please refer to "place of installation"

in the instruction manual.

Replace glass door (see 6.1.2).

Adjust glass door (see 6.1.1).

The repair is only to be carried out by

a workshop designed for this

purpose.

Risk of explosion

Interior lighting not

working

Light does not go out

LED is defect

LED plug is not correctly inserted

Magnet missing of incorrectly fitted

Sensor bent (magnetic field not

effective)

Permanent mode activated

Replace LED (see 6.2.2).

Inspect plug-in connection (see

6.2.2).

Check light switch (see 6.1.3 ).

Align sensor (see 6.1.3 ).

Deactivate permanent mode

DGS-TDS-N 05.2006 © Electrolux 7 168 650

Fault Possible cause Remedy

Insufficient

temperature

difference top/bottom

Cooling temperature

too cold

Temperature setting

Sealing lip missing from false floor

False floor missing

Heating defect

Air flap control defective

Air flap jams

Sensors exchanged

Set correctly

Fit sealing lip

Mount false floor

Inspect heating (see Diagnosis.

Replace if defect)

Inspect servomotor (see diagnosis)

Remedy air flap malfunction

Connect sensor correctly

Formation of

condensation on the

door

Increased atmospheric moisture Wipe off with a dry cloth, set a little

warmer.

Error message F1 on

the operation panel

Top sensor defect

(Appliance does not function in the

emergency programme)

Replace sensor (see 6.3.11).

Error message F2 on

the operation panel

Bottom sensor defect

(Appliance does not function in the

emergency programme)

Replace sensor (see 6.3.11).

DGS-TDS-N 05.2006 © Electrolux 8 168 650

5. Diagnosis Mode

Activation and deactivation by simultaneously activating the four buttons for the adjustment

of the target values (min. 3 sec.) . When the diagnosis mode is active, "tE“ alternates with the

ACTUAL temperature of the top sensor in the left-hand display and in the right-hand display,

the ACTUAL temperature of the top sensor alternates with the consumer status.

The temperature displays in Diagnosis Mode are not the average compartment temperatures

but the ACTUAL temperature at the sensor position.

The following functions are possible.

Compressor on / off "+" cold compartment Display CI / CO

Heating on / off " - " cold compartment Display HI / HO

The heating function is reset to "off" after 10 minutes for safety reasons.

Flap open / closed "+" cold compartmentDisplay SI / SO

Ventilator on / off " - " cold compartment Display LI / LO

The Diagnosis Mode is automatically deactivated after 30 minutes for safety reasons.

The Diagnosis Mode can be deactivated at all times by switching the main switch off.

Presentation Mode

An operation mode is possible for presentations, by which the compressor, ventilator, heating

and air flap are not switched.

The Presentation Mode is activated and deactivated by simultaneously pressing the button

combination Target Value Adjustment"+" top, "Supercool" and target Value Adjustment

"+" bottom (min. 3 sec.)

"dE" is briefly displayed in the left-hand display after activation, "dA“ being briefly displayed

in the left-hand display after deactivation.

The target value adjustment, lighting, door switch and the door alarm remain active. The

"Supercool" function button only switches the LED but does not switch the compressor on

and off.

The target values are shown in the right-hand and left-hand display as ACTUAL values.

In order to control the "Presentation Mode" operating mode, the "Supercool" LED briefly

illuminates every 5 seconds or it is briefly extinguished if the "Supercool" is activated.

A switching off and on by means of the main switch or a power failure does not result in a

deactivation of the Presentation Mode.

DGS-TDS-N 05.2006 © Electrolux 9 168 650

6. Replacing Spare Parts

6.1 Door elements

6.1.1 Levelling out the door

1. An elongated hole is situated in the KS frame (top

and bottom) which can be used to adjust the door

height

2. An elongated hole is situated in the door (top and

bottom) which can be used to adjust the door in a

longitudinal direction

Ensure that the gap between the niche and the door is

the same all around.

6.1.2 Replacing the door

1. Remove the bottom and top covers

2. Remove the internal screw from the top and the

bottom

3. Loosen the external screw (do not remove)

4. Push the hinge out and then remove the door.

5. Mount the new door in the reverse order

DGS-TDS-N 05.2006 © Electrolux 10 168 650

6.1.3 Inspecting the light switch

1. Switch the inside lighting of the door opening on (see No. 5 in the Operating Functions)

2. The operating display shows "OFF"

3. Close the door- the inside lighting should go off. Refer to 4 and 5 if the light does not go

off.

4. Remove the operation (see 6.2.1) and then check the sensor.

The sensor should be clearly bent as shown in the

photo. If necessary, bend it carefully of replace the

board.

5. Check the position of the door magnet if the inside lighting still does not go off, i.e. turn the

magnet in the magnet housing.

6.1.4 Replacing the door seal

1. Removal

Left the seal at the corner and pull it off

2. Fitting

Carefully press the seal in at the corners and travel

along the seal with the fingers

Indice

Altri manuali Electrolux Refrigeratore per vino

Electrolux

Electrolux EI24WC65GS - Wine Cellar With 46 Bottle... Guida utente

Electrolux

Electrolux EWUS020B5B Manuale utente

Electrolux

Electrolux E24WC75HSS Manuale utente

Electrolux

Electrolux ERW3313BOX Manuale utente

Electrolux

Electrolux ERW3313AOX Manuale utente

Electrolux

Electrolux E24WC75HPS - Icon - Professional Series 48 Bottle Wine... Guida utente

Electrolux

Electrolux EI24BC65GS - 24 Inch Beverage Center Manuale utente

Electrolux

Electrolux E24WC48EBS Manuale utente

Electrolux

Electrolux ERW1573AOA Manuale utente

Electrolux

Electrolux E24WC160ES1 Manuale utente

Electrolux

Electrolux ERW1170AO Manuale utente

Electrolux

Electrolux ERW33901X Manuale utente

Electrolux

Electrolux E24 WC 160 ES1 Manuale utente

Electrolux

Electrolux E24WC75HPS - Icon - Professional Series 48 Bottle Wine... Manuale utente

Electrolux

Electrolux European Wine Tower Manuale utente

Electrolux

Electrolux ERW0273AOA Manuale utente

Electrolux

Electrolux E24WC75HPS - Icon - Professional Series 48 Bottle Wine... Manuale utente

Electrolux

Electrolux ERW3313AOX Manuale utente

Electrolux

Electrolux WK4PL10CN Manuale utente

Electrolux

Electrolux WK4PL10CN Manuale utente

Electrolux

Electrolux ERW082XAMB Manuale utente

Electrolux

Electrolux Dometic CS 110 Manuale utente

Electrolux

Electrolux EI24WC65GS - Wine Cellar With 46 Bottle... Istruzioni per l'installazione

Electrolux

Electrolux E24WC75HPS - Icon - Professional Series 48 Bottle Wine... Manuale utente

Manuali Refrigeratore per vino popolari di altre marche

U-Line

U-Line Echelon Wine Captain 2075WC Manuale del proprietario

Haier

Haier WS50GA Manuale utente

Cavist

Cavist 62 Manuale utente

Kenmore

Kenmore 461.99130 Manuale utente

Miele

Miele KWT 6422 iG Manuale utente

Danby

Danby DWC113BLSDB Manuale utente

Caple

Caple Wi6128 Manuale utente

Avanti

Avanti WC1001 Manuale utente

Frigidaire

Frigidaire FFWC38F6LS Manuale utente

Titan

Titan TT-W2454SZ Manuale di installazione

Klarstein

Klarstein Botella 166 Uno Manuale utente

Costway

Costway FP10130WL Manuale utente

Lemair

Lemair LWC59 Manuale utente

Haier

Haier JC-125GEA Manuale utente

Caple

Caple WCi46B Manuale utente

Climadiff

Climadiff CLI24 Guida rapida

Viking

Viking VCWB301LSS Manuale utente

Caple

Caple WC6511 Manuale utente