4
NOTE: Additional information is required for configuration. For example, you will
need to provide your network SSID (service set identifier) and password.
For initial configuration, the computer must be running serial communications software
configured for serial settings of 1200 baud, 8, N,1.
To configure the Wifi, issue the following command and follow the onscreen instructions.
at+config
Look at the AT+CONFIG section of this document for more details.
Additional commands are available using the AT command set.
USING THE GURUMODEM CARD
Using a communications program in Terminal mode, you can issue commands to the
GuruModem that allow you to change parameters and configuration options. The
AT+CONFIG command provides a series of menus to configure the GuruModem quickly.
In this section we describes some of the more common AT commands and how they can be
used to get the most out of the GuruModem card. Additional commands can be found in
the AT Command Reference
Set the baud rate
The default baud rate is set to 1200 baud. If you want to change this, you need to
understand that once the baud rate is changed, characters will no longer be displayed
properly. This can be corrected by changing the settings in your communications
program after you have set a new baud rate. The baud rate can be set with the
following command.
atb9600
This command will change the baud rate to 9600 baud. Other baud rates are
available. Here is a list of the baud rates available:
1200, 2400, 4800, 9600, …, 115200, 230400.
